虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

Voltage-sourced

  • 电池组电压测量的研究

      Automobiles, aircraft, marine vehicles, uninterruptiblepower supplies and telecom hardware represent areasutilizing series connected battery stacks. These stacksof individual cells may contain many units, reaching potentialsof hundreds of volts. In such systems it is oftendesirable to accurately determine each individual cell’svoltage. Obtaining this information in the presence of thehigh “common mode” voltage generated by the batterystack is more diffi cult than might be supposed.

    标签: 电池组 电压 量的研究

    上传时间: 2013-10-24

    上传用户:kang1923

  • 基于Multisim 10的矩形波信号发生器仿真与实现

    在Multisim 10软件环境下,设计一种由运算放大器构成的精确可控矩形波信号发生器,结合系统电路原理图重点阐述了各参数指标的实现与测试方法。通过改变RC电路的电容充、放电路径和时间常数实现了占空比和频率的调节,通过多路开关投入不同数值的电容实现了频段的调节,通过电压取样和同相放大电路实现了输出电压幅值的调节并提高了电路的带负载能力,可作为频率和幅值可调的方波信号发生器。Multisim 10仿真分析及应用电路测试结果表明,电路性能指标达到了设计要求。 Abstract:  Based on Multisim 10, this paper designed a kind of rectangular-wave signal generator which could be controlled exactly composed of operational amplifier, the key point was how to implement and test the parameter indicators based on the circuit diagram. The duty and the frequency were adjusted by changing the time constant and the way of charging and discharging of the capacitor, the width of frequency was adjusted by using different capacitors provided with multiple switch, the amplitude of output voltage was adjusted by sampling voltage and using in-phase amplifier circuit,the ability of driving loads was raised, the circuit can be used as squarewave signal generator whose frequency and amplitude can be adjusted. The final simulation results of Multisim 10 and the tests of applicable circuit show that the performance indicators of the circuit meets the design requirements.

    标签: Multisim 矩形波 信号发生器 仿真

    上传时间: 2014-01-21

    上传用户:shen007yue

  • 陶瓷电容器的温度和电压的变化

    Abstract: The reality of modern, small form-factor ceramic capacitors is a good reminder to always readthe data sheet. This tutorial explains how ceramic capacitor type designations, such as X7R and Y5V,imply nothing about voltage coefficients. Engineers must check the data to know, really know, how aspecific capacitor will perform under voltage.

    标签: 陶瓷电容器 温度 变化 电压

    上传时间: 2013-11-04

    上传用户:梧桐

  • 基于微处理器的5V系统接口

    This application note discusses a variety of approaches for interfacing analog signals to 5V powered systems. Synthesizing a "rail-to-rail" op amp and scaling techniques for A/D converters are covered. A voltage-to-frequency converter, applicable where high resolution is required, is also presented.  

    标签: 微处理器 系统接口

    上传时间: 2013-10-12

    上传用户:181992417

  • yright 2002 Cygnal Integrated Products, Inc. // // Filename: LIION_BC_MAIN.c // Target Device: 8051F

    yright 2002 Cygnal Integrated Products, Inc. // // Filename: LIION_BC_MAIN.c // Target Device: 8051F300 // Created: 11 SEP 2002 // Created By: DKC // Tool chain: KEIL Eval C51 // // This is a stand alone battery charger for a Lithium ION battery. // It utilizes a buck converter, controlled by the on-chip 8-bit PWM, // to provide constant current followed by constant voltage battery charge.

    标签: LIION_BC_MAIN Integrated Filename Products

    上传时间: 2013-12-23

    上传用户:牧羊人8920

  • A simple C program to strobe the LEDsvia Port D. The strobe rate is to be set by adjusting the volta

    A simple C program to strobe the LEDsvia Port D. The strobe rate is to be set by adjusting the voltage drop over a potentiometer that is sampled by an ADC.

    标签: strobe D. adjusting the

    上传时间: 2014-01-09

    上传用户:lifangyuan12

  • The LT® 1529/LT1529-3.3/LT1529-5 are 3A low dropout regulators with micropower quiescent current

    The LT® 1529/LT1529-3.3/LT1529-5 are 3A low dropout regulators with micropower quiescent current and shutdown. The devices are capable of supplying 3A of output current with a dropout voltage of 0.6V. Designed for use in battery-powered systems, the low quiescent current, 50mA operating and 16mA in shutdown, make them an ideal choice. The quiescent current is well controlled it does not rise in dropout as it does with many other low dropout PNP regulators.

    标签: 1529 micropower regulators quiescent

    上传时间: 2013-12-17

    上传用户:qiao8960

  • 硬件设计指南(PDF格式)

    硬件设计指南(PDF格式),主要包括:Low Voltage Interfaces;Grounding in Mixed Signal Systems;Digital Isolation Techniques; Power Supply Noise Reduction and Filtering; Dealing with High Speed Logic

    标签: 硬件 设计指南

    上传时间: 2015-08-31

    上传用户:阿四AIR

  • The LM158 series consists of two independent, high gain, internally frequency compensated operatio

    The LM158 series consists of two independent, high gain, internally frequency compensated operational amplifiers which were designed specifically to operate from a single power supply over a wide range of voltages. Operation from split power supplies is also possible and the low power supply current drain is independent of the magnitude of the power supply voltage.

    标签: compensated independent internally frequency

    上传时间: 2014-01-09

    上传用户:zwei41

  • 本装置是一个以HT46R71D 为主芯片

    本装置是一个以HT46R71D 为主芯片,配合传感器组成的汽车轮胎气压检测装 置,最终取高三位有效值于LCD 显示,有四种显示单位供切换(Psi、Bar、Kpa、 Kgf/cm2)。本装置仅为参考范例,使用时,为提高准确度,建议多量测些组数 据来构建Sensor Output Voltage - Discharge Time (V-T)表格,并作相应校准。

    标签: 46R 71D R71 HT

    上传时间: 2015-11-19

    上传用户:shinesyh