LTC1732 是LINEAR TECHNOLOGY 公司推出的锂离子电池充电控制集成电路芯片。它具有电池插入检测和自动低压电池充电功能。文章介绍了该芯片的结构、特点、工作原理及应用信息，给出了典型的应用电路。 LTC1732 是LINEAR TECHNOLOGY 公司生产的锂-离子（Li-离子）电池恒流/恒压线性充电控制器。它也可以对镍-镉（NiCd）和镍-氢（NiMH）电池恒流充电。其充电电流可通过外部传感电阻器编程到7%（最大值）的精度。最终的浮动电压精度为1%。利用LTC1732 的SEL 端可为4.1V 或4.2V 电池充电。当输入电源撤消后，LTC1732 可自动进入低电流睡眠状态，以使消耗电流下降到7μA。LTC1732 的内部比较器用于检测充电结束条件（C/10），而总的充电时间则是通过可编程计时器的外部电容来设置的。在电池完全放电后，控制器将自动以规定电流的10%对被充电电池进行慢速充电直到电池电压超过2.457V。当放电后的电池插入充电器或当输入电源接通时，LTC1732 将开始重新充电。另外，如果电池一直插入在充电器且在电池电压降到3.8V（LTC1732-4）或4.05V（LTC1732-4.2）以下时，充电器也将开始重新充电。LTC1732 的其它主特点如下：●具有1%的预置充电电压精度；●输入电压范围4.5V～12V；●充电电流可编程控制；●具有C/10 充电电流检测输出；●可编程控制充电终端计时；●带有低电压电池自动小电流充电模式；●可编程控制恒定电流接通模式；●具有电池插入检测和自动低压电流充电功能；●带有输入电源（隔离适配器）检测输出；●LTC1732-4.2 型器件的再充电阈值电压为4.05V；●LTC1732-4 型器件的再充电阈值电压为3.8V。
上传时间： 2013-11-12
上传用户：semi1981
现实世界中有很多问题，它的机理较简单，用静态,线性或逻辑的方法即可建立模型，使用初等的数学方法，即可求解，我们称之为初等数学模型。本章主要介绍有关自然数，比例关系，状态转移，及量刚分析等建模例子，这些问题的巧妙的分析处理方法，可使读者达到举一反三，开拓思路，提高分析, 解决实际问题的能力。 在人们的生产实践中，经常会遇到如何利用现有资源来安排生产，以取得最大经济效益的问题。此类问题构成了运筹学的一个重要分支—数学规划，而线性规划(Linear Programming 简记LP)则是数学规划的一个重要分支。自从1947年G. B. Dantzig 提出求解线性规划的单纯形方法以来，线性规划在理论上趋向成熟，在实用中日益广泛与深入。特别是在计算机能处理成千上万个约束条件和决策变量的线性规划问题之后，线性规划的适用领域更为广泛了，已成为现代管理中经常采用的基本方法之一。 如果目标函数或约束条件中包含非线性函数，就称这种规划问题为非线性规划问题。一般说来，解非线性规划要比解线性规划问题困难得多。而且，也不象线性规划有单纯形法这一通用方法，非线性规划目前还没有适于各种问题的一般算法，各个方法都有自己特定的适用范围。 下面通过实例归纳出非线性规划数学模型的一般形式，介绍有关非线性规划的基本概念。
上传时间： 2013-10-19
上传用户：lunshaomo
This application note describes how to build a system that can be used for determining theoptimal phase shift for a Double Data Rate (DDR) memory feedback clock. In this system, theDDR memory is controlled by a controller that attaches to either the OPB or PLB and is used inan embedded microprocessor application. This reference system also uses a DCM that isconfigured so that the phase of its output clock can be changed while the system is running anda GPIO core that controls that phase shift. The GPIO output is controlled by a softwareapplication that can be run on a PowerPC® 405 or Microblaze™ microprocessor.
上传时间： 2013-10-15
上传用户：euroford
针对传统集成电路（ASIC）功能固定、升级困难等缺点，利用FPGA实现了扩频通信芯片STEL-2000A的核心功能。使用ISE提供的DDS IP核实现NCO模块，在下变频模块调用了硬核乘法器并引入CIC滤波器进行低通滤波，给出了DQPSK解调的原理和实现方法，推导出一种简便的引入?仔/4固定相移的实现方法。采用模块化的设计方法使用VHDL语言编写出源程序，在Virtex-II Pro 开发板上成功实现了整个系统。测试结果表明该系统正确实现了STEL-2000A的核心功能。 Abstract: To overcome drawbacks of ASIC such as fixed functionality and upgrade difficulty, FPGA was used to realize the core functions of STEL-2000A. This paper used the DDS IP core provided by ISE to realize the NCO module, called hard core multiplier and implemented CIC filter in the down converter, described the principle and implementation detail of the demodulation of DQPSK, and derived a simple method to introduce a fixed phase shift of ?仔/4. The VHDL source code was designed by modularity method , and the complete system was successfully implemented on Virtex-II Pro development board. Test results indicate that this system successfully realize the core function of the STEL-2000A.
上传时间： 2013-11-06
上传用户：liu123
为了在CDMA系统中更好地应用QDPSK数字调制方式，在分析四相相对移相（QDPSK)信号调制解调原理的基础上，设计了一种QDPSK调制解调电路，它包括串并转换、差分编码、四相载波产生和选相、相干解调、差分译码和并串转换电路。在MAX+PLUSⅡ软件平台上，进行了编译和波形仿真。综合后下载到复杂可编程逻辑器件EPM7128SLC84-15中，测试结果表明，调制电路能正确选相，解调电路输出数据与QDPSK调制输入数据完全一致，达到了预期的设计要求。 Abstract: In order to realize the better application of digital modulation mode QDPSK in the CDMA system， a sort of QDPSK modulation-demodulation circuit was designed based on the analysis of QDPSK signal modulation-demodulation principles. It included serial/parallel conversion circuit, differential encoding circuit, four-phase carrier wave produced and phase chosen circuit, coherent demodulation circuit, difference decoding circuit and parallel/serial conversion circuit. And it was compiled and simulated on the MAX+PLUSⅡ software platform,and downloaded into the CPLD of EPM7128SLC84-15.The test result shows that the modulation circuit can exactly choose the phase，and the output data of the demodulator circuit is the same as the input data of the QDPSK modulate. The circuit achieves the prospective requirement of the design.
上传时间： 2014-01-13
上传用户：qoovoop
为提升虚拟仪器传输速率与实时性能，扩展监测范围，在VC的软件平台上设计了一种全功能虚拟示波器。与传统虚拟示波器相比，该系统采用嵌入式系统完成信号采集，采用工业以太网为传输介质，通过线性插值算法和多线程编程思想，实现波形显示、参数计算、频谱分析以及波形存储及回放功能。实验结果表明，该虚拟示波器可以实现20 kHz采样频率下的波形精确显示，达到预期的各项指标。 Abstract: o enhance the transfer rate and real-time of virtual instrument performance， expand scope of monitoring， this paper uses the VCs software platform to design a fully functional virtual oscilloscope. Compared with traditional virtual oscilloscope， this system adopts the embedded system to complete the data acquisition， industrial Ethernet as the transmission medium used by the linear interpolation algorithm and multi-threaded programming ideas， namely to achieve waveform display， parameter calculation， spectrum analysis and waveform storage and playback. Experimental results show that the virtual oscilloscope can accurately display the waveform with 20kHz sampling frequency， and achieve the desired targets.
上传时间： 2013-11-25
上传用户：wbwyl
The Maxim Integrated 71M6541-DB REV 3.0 Demo Board is a demonstration board for evaluating the 71M6541 device for single-phase electronic energy metering applications in conjunction with the Remote Sensor Inter-face. It incorporates a 71M6541 integrated circuit, a 71M6601 Remote Interface IC, peripheral circuitry such as a serial EEPROM, emulator port, and on-board power supply. A serial to USB converter allows communication to a PC through a USB port. The Demo Board allows the evaluation of the 71M6541 energy meter chip for measurement accuracy and overall system use.
上传时间： 2013-11-06
上传用户：雨出惊人love
We offer a broad line of high performance low dropout (LDO) linear regulators with fasttransient response, excellent line and load regulation, and very wide input voltage rangefrom 0.9V to 100V. Output currents range from 20mA to 10A, with positive, negative andmultiple output versions available. Many devices offer output voltage operation <0.8V andsome feature operation as low as 0V, even with a single supply. Most are stable with ceramicoutput capacitors. LDO regulators can be applied in virtually any application.
上传时间： 2013-11-15
上传用户：努力努力再努力
Linear Technology offers some of the highest performance RF and signal chain solutions for wireless and cellularinfrastructure. These products support worldwide standards including, LTE, WiMAX, GSM,W-CDMA, TD-SCDMA,CDMA, and CDMA2000. Other wireless systems include broadband microwave data links, secure communications,satellite receivers, broadband wireless access, wireless broadcast systems, RFID readers and cable infrastructure
上传时间： 2013-11-04
上传用户：kiklkook
Abstract: This article explains the recent trend in heart-rate and fitness monitors to go wireless toeliminate cables to allow free movement, and allow convenient data collection without the need to plug intheir devices. It details a typical wireless system, using the MAX1472 crystal-referenced phase-lockedloop (PLL) VHF/UHF transmitter.
标签： Heart-RateFitness Monitors Wireless Go
上传时间： 2013-11-11
上传用户：xiaowei314
