现阶段对电流型二线制光照强度变送器的研究还相对较少，设计的光照强度变送器普遍存在精度不高，线性度不好，性能不够稳定，不能输出标准4~20 mA电流信号的问题。介绍了一种电流型二线制光照强度变送器的设计，其结构由光照强度转电压电路、电压范围转换电路、电压转电流电路以及稳压电源产生电路组成。实验结果表明该变送器具有精度高、线性度好、功耗低，能够稳定可靠地输出标准4~20 mA电流的特点。
上传时间： 2013-11-08
上传用户：star_in_rain
电压驱动型脉宽调制器TL494
上传时间： 2013-10-28
上传用户：rolypoly152
A number of conventional solutions have been available forthe design of a DC/DC converter where the output voltageis within the input voltage range—a common scenarioin Li-Ion battery-powered applications—but none werevery attractive until now. Conventional topologies, suchas SEPIC or boost followed by buck, have numerousdisadvantages, including low effi ciency, complex magnetics,polarity inversion and/or circuit complexity/cost. TheLTC®3785 buck-boost controller yields a simple, effi cient,low parts-count, single-converter solution that is easyto implement, thus avoiding the drawbacks associatedwith traditional solutions.
上传时间： 2013-10-21
上传用户：ljt101007
The LTC®3562 quad output step-down regulator is designedfor multicore handheld microprocessor applications thatoperate from a single Li-Ion battery. Its four monolithic, higheffi ciency buck regulators support Intel’s mobile CPU P-Stateand C-State energy saving operating modes. The outputvoltages are independently controllable via I2C, and eachoutput can be independently started and shut down. Designerscan choose from power saving pulse-skipping mode orBurst Mode® operation, or select low noise LDO mode. Thespace-saving LTC3562 is available in a 3mm × 3mm QFNpackage and requires few external components.
上传时间： 2013-10-07
上传用户：1583060504
The LTC®3569 is a compact power solution for handhelddevices. Its tiny 3mm × 3mm QFN package includesthree buck regulators with individually programmableoutput voltages. One regulator supports load currentsup to 1200mA, while the other two support currents to600mA. Two regulators can be paralleled for increasedload capability. Each current-mode regulator is internallycompensated with excellent load and line regulation. Acomplete 2- or 3-output solution requires a minimumof external passive components.
上传时间： 2013-10-11
上传用户：yxgi5
The LTC3546 is a dual output current mode buck regulatorwith fl exible output current partitioning. Beyondthe advantages normally associated with dual outputregulators (reduced size, cost, EMI and part count, withimproved effi ciency), the LTC3546’s outputs can bepartitioned for either 3A and 1A outputs, or two 2A outputs.This increases its application range and simplifi esmultiple supply rail designs. A confi gurable Burst Mode®clamp for each output sets the current transition levelbetween Burst Mode operation and forced continuousconduction mode to optimize effi ciency over the entireoutput range. An adjustable switching frequency up to4MHz and internal power MOSFET switches allow forsmall and compact footprints.
上传时间： 2013-11-04
上传用户：yxgi5
Linear Technology’s DC/DC step-down μModule®regulators are complete switchmode power supplies in asurface-mount package. They include the DC/DC controller,inductor, power switches and supporting circuitry.These highly integrated regulators also provide an easysolution for applications that require negative outputvoltages. In other words, these products can operate asinverting buck-boost regulators. As a result, the lowestpotential in the circuit is not the standard 0V, but –VOUT,which must be tied to the μModule regulator’s GND. Allsignals are now referred to –VOUT.
上传时间： 2013-10-22
上传用户：ztj182002
The LTC®3610 is a high power monolithic synchronousstep-down DC/DC regulator that can deliver up to 12Aof continuous output current from a 4V to 24V (28Vmaximum) input supply. It is a member of a high currentmonolithic regulator family (see Table 1) that featuresintegrated low RDS(ON) N-channel top and bottomMOSFETs. This results in a high effi ciency and highpower density solution with few external components.This regulator family uses a constant on-time valleycurrent mode architecture that is capable of operatingat very low duty cycles at high frequency and with veryfast transient response. All are available in low profi le(0.9mm max) QFN packages.
上传时间： 2013-11-07
上传用户：moerwang
NCV8503是一款高精度微功耗电源稳压器。输出电流可达400mA。该器件提供多个级别的输出电压供客户选择：2.5V、3.3V、5.0V，及可调输出版本。在负载为400mA时，最大压降仅为0.6V，电压输出精度在±2.0%以内。当ENABLE=0V时，静态电流低于1uA；如果ENABLE=5V，负载为100uA静态电流仅为200uA。非常适合电池供电设备。支持RESET输出（带DELAY功能），可用于微处理器逻辑控制。当输出电压达到1.0V时，RESET电路即可正常工作。当电源上电及电压跌落于门槛电压时，RESET电路输出复位信号。
上传时间： 2013-11-22
上传用户：xieguodong1234
符合全球标准的小巧电源•35～150 W容量支持5 V, 12 V和24 V输出电压(100 W, 150 W: 仅24 V型)• 支持DIN导轨安装• 安全标准 ： UL 508/60950-1, EN 60950-1CSA C22.2 No. 60950-1
上传时间： 2014-04-17
上传用户：fklinran
