虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

full-hardware

  • 基于MPC555与CS8900A的以太网扩展设计

       介绍了MPC555与CS8900A扩展以太网的硬件设计图。以NUCLUES PLUS操作系统为基础,介绍了网卡软件驱动程序的编制,给出了以太网协议包嵌入NUCLEUS PLUS操作系统的实现方法。 Abstract:  The Ethernet extension hardware design of MPC555 and CS8900A are introduced,and the software driven program based on NUCLEUS PLUS operation system and the technique that Ethernet protocol embedded in NUCLEUS PLUS real operation system are discussed.

    标签: 8900A 8900 MPC 555

    上传时间: 2013-10-23

    上传用户:xiehao13

  • 基于C8051F005单片机的参数测试仪的设计

    介绍了基于单片机航空交流电参数测试仪的系统设计。以Silicon Labs公司的C8051F005单片机为核心设计出数据采集板,通过RS-232串口与上位机通讯。运用Lab Windows/CVI编写的上位机软件实现信号的检测以及波形和数据的显示,给出了测试仪硬件电路的组成和软件流程图。本系统具有硬件结构简单、容易实现和成本低等特点,在实际应用中其稳定性、精确性均能满足客户要求。 Abstract:  The design of aeronautics AC parameters tester based on the single-chip is introduced.The core component of data acquisition board is C8051F005 single chip of Silicon Labs Company,and communication with PC through RS-232. The signal processing software programmed with LabWindows/CVI can be used successfully to fulfill inspection of signal and display of the waveform and data. The hardware and software configuration of test instrument are provided.The hardware of the system is simple, and can be easily realized.The stability and precision of the measurement instrument are enough to meet the requirements.

    标签: C8051F005 单片机 仪的设计 参数测试

    上传时间: 2013-11-18

    上传用户:wang5829

  • 基于MSP430F149的智能电池巡检系统的设计

    介绍了电力操作电源与智能电池巡检系统的特点,给出了一种基于超低功耗单片机MSP430 F149针对中小型变电站自动化运行的专用设备的基本设计原理及实现方法,最后给出了详细硬件构成和软件实现。该系统能满足中小型变电站安全、可靠、自动运行的要求,并通过与上位机的串行通信实现变电站的远程管理和控制。 Abstract:  The characters of the intelligent battery data logging system of the electric operation power are introduced.The basic design principle and the implemented methods of the special equipment which only designed for the middle or small transformer substation based on MSP430F149 are prescribed. Finally, the hardware block diagram and the software flow chart are also given. The function that the system finally needs to realize can basically meet with the middle or small transformer substation’s satisfy, reliably,and automatic running.And it can also realize the transformer substation long-distance management and control by serial communicating with the host computer.

    标签: 430F F149 MSP 430

    上传时间: 2013-11-25

    上传用户:黄华强

  • MSP430在频率测量系统中的应用

       介绍一种以MSP430单片机为基础的智能频率测量系统,采用硬件逻辑与软件指令相结合的方式控制闸门,实现0 MHz~10 MHz范围内无档切换的等精度测量。 Abstract:  An intelligent frequency measurement system based on MSP430 singlechip is introduced. The system uses a way that can combine hardware logic and software instructions to contronl the strobe ,and completes the functions of equal precision in the range of 0MHz~10MHz without shifting

    标签: MSP 430 频率测量

    上传时间: 2013-10-28

    上传用户:dbs012280

  • 基于ADuC841的膜片钳放大器系统设计

    为降低成本和解决现有膜片钳放大器系统中PC机的干扰问题,研究了一种基于单片机的膜片钳放大器小系统。该系统采用ADI公司生产的ADuC841作为控制核心,并且配置相应的液晶显示模块LCM3202401。模拟电路部分采用高输入阻抗的AD8627实现微电流信号的采集,并由后级电路进行信号的放大和电阻电容的补偿。它具有硬件电路简单、体积小、使用方便的特点。既可以单独作为小系统实现采集和显示,也可以通过红外方式和PC机进行通讯,在PC机上进行信号的处理。 Abstract:  In order to reduce cost and resolve the interferential problem with PC in existing patch clamp amplifiers, a small patch clamp amplifier system design based on microcontroller is studied. It adopts a new high performance microconverter ADuC841 by the ADI as the control core in the system, configuring a liquid crystal module LCM3202401. In the analog circuit, AD8627 with high input impedance is used to detect the low current,signal magnification, as well as resistance and capacitance compensation are accomplished by subsequent circuits. It has the advantage of simple hardware circuit design, small volume and convenient operation. It can either be used as an independent system to measure and show signal detected or transmit to PC by infrared ray.

    标签: ADuC 841 膜片钳 放大器

    上传时间: 2013-11-06

    上传用户:yy_cn

  • 基于ATmgea8单片机的加热控制系统

     介绍基于ATmega8型单片机的温度测量及加热控制系统。分析系统的工作原理,详尽讨论系统的硬件电路和软件流程。实验证明,该系统工作可靠,稳定性高。 Abstract:  The new temperature measuring and heating control system based on ATmega8 MCU is introduced.The system’s working principles is analyzed.The design principles of hardware and software are also discussed in detail.This system has been testified and it works steady and reliably.

    标签: ATmgea8 单片机 加热控制

    上传时间: 2013-11-21

    上传用户:caiguoqing

  • 基于ATmega168的ADC按键设计

    利用Atmel公司的ATmega168微处理器,采用A/D转换方式来实现按摩椅控制器的键盘接口,通过在硬件电路中巧妙地选择电阻,在软件设计中采用数字滤波、二分法和区间鉴定等方法,灵敏可靠地实现了按摩椅中30个按键的处理。给出了硬件电路设计和软件设计思想以及部分汇编代码。 Abstract:  This paper chooses A/D conversion method to realize the keyboard interface of the controller by using ATmega168 microchip from Atmel Company.It accomplishes 30-key dealing sensitively and reliably in massage chair through skillfully selecting resistors in hardware circuit and using digital filter,dichotomy and area-judging method in software design.The hardware design circuit, software design idea and partly assembles code are presented mainly.

    标签: ATmega 168 ADC 按键

    上传时间: 2014-01-10

    上传用户:咔乐坞

  • 基于P87C591的信号采集节点的设计

    介绍了CAN总线和P87C591单片机的特点,给出了基于P87C591单片机的信号采集节点的软、硬件设计,指出了硬件电路设计中应注意的问题,在软件设计中重点介绍了节点初始化、报文发送和报文接收等子程序。 Abstract:  The features of CAN Bus and the microcontroller P87C591 are introduced, and the design of hardware circuit and soft configuration of the signals collection node based on P87C591 are presented. The problems in designing hardware circuit are discussed.Initialization subprogram, transmiting subprogram and receiving subprogram are emphasized in soft configuration.

    标签: P87C591 信号采集 节点

    上传时间: 2013-11-03

    上传用户:BIBI

  • MAX7456在可视倒车雷达中的应用

    为解决传统可视倒车雷达视频字符叠加器结构复杂,可靠性差,成本高昂等问题,在可视倒车雷达设计中采用视频字符发生器芯片MAX7456。该芯片集成了所有用于产生用户定义OSD,并将其插入视频信号中所需的全部功能,仅需少量的外围阻容元件即可正常工作。给出了以MAX7456为核心的可视倒车雷达的软、硬件实现方案及设计实例。该方案具有电路结构简单、价格低廉、符合人体视觉习惯的特点。经实际装车测试,按该方案设计的可视倒车雷达视场清晰、提示字符醒目、工作可靠,可有效降低驾驶员倒车时的工作强度、减少倒车事故的发生。 Abstract:  A new video and text generation chip,MAX7456,was used in the design of video parking sensor in order to simplify system structure,improve reliability and reduce cost. This chip included all the necessary functions to generate user-defined OSDs and to add them into the video signals. It could be put into work with addition of just a small number of resistances and capacitors. This paper provided software and hardware implementation solutions and design example based on the chip. The system had the characteristics of simplicity in circuit structure,lower cost,and comfort for the nature of human vision. Loading road test demonstrates high video and text display quality and reliable performance,which makes the driver easy to see backward and reduces chance of accidents.

    标签: 7456 MAX 可视倒车 中的应用

    上传时间: 2013-12-10

    上传用户:qiaoyue

  • AD9859芯片资料

    FEATURES400 MSPS internal clock speedIntegrated 10-bit DAC32-bit tuning wordPhase noise ≤ –120 dBc/Hz @ 1 kHz offset (DAC output)Excellent dynamic performance>75 dB SFDR @ 160 MHz (±100 kHz offset) AOUTSerial I/O control1.8 V power supplySoftware and hardware controlled power-down48-lead TQFP/EP packageSupport for 5 V input levels on most digital inputsPLL REFCLK multiplier (4× to 20×)Internal oscillator; can be driven by a single crystalPhase modulation capabilityMultichip synchronization

    标签: 9859 AD 芯片资料

    上传时间: 2014-12-04

    上传用户:axin881314