本文将接续介绍电源与功率电路基板，以及数字电路基板导线设计。宽带与高频电路基板导线设计a.输入阻抗1MHz，平滑性(flatness)50MHz 的OP增幅器电路基板图26 是由FET 输入的高速OP 增幅器OPA656 构成的高输入阻抗OP 增幅电路，它的gain取决于R1、R2，本电路图的电路定数为2 倍。此外为改善平滑性特别追加设置可以加大噪讯gain，抑制gain-频率特性高频领域时峰值的R3。图26 高输入阻抗的宽带OP增幅电路图27 是高输入阻抗OP 增幅器的电路基板图案。降低高速OP 增幅器反相输入端子与接地之间的浮游容量非常重要，所以本电路的浮游容量设计目标低于0.5pF。如果上述部位附着大浮游容量的话，会成为高频领域的频率特性产生峰值的原因，严重时频率甚至会因为feedback 阻抗与浮游容量，造成feedback 信号的位相延迟，最后导致频率特性产生波动现象。此外高输入阻抗OP 增幅器输入部位的浮游容量也逐渐成为问题，图27 的电路基板图案的非反相输入端子部位无full ground设计，如果有外部噪讯干扰之虞时，接地可设计成网格状(mesh)。图28 是根据图26 制成的OP 增幅器Gain－频率特性测试结果，由图可知即使接近50MHz频率特性非常平滑，-3dB cutoff频率大约是133MHz。
标签： PCB
上传时间： 2013-11-09
上传用户：z754970244
This document provides practical, common guidelines for incorporating PCI Express interconnect layouts onto Printed Circuit Boards (PCB) ranging from 4-layer desktop baseboard designs to 10- layer or more server baseboard designs. Guidelines and constraints in this document are intended for use on both baseboard and add-in card PCB designs. This includes interconnects between PCI Express devices located on the same baseboard (chip-to-chip routing) and interconnects between a PCI Express device located “down” on the baseboard and a device located “up” on an add-in card attached through a connector. This document is intended to cover all major components of the physical interconnect including design guidelines for the PCB traces, vias and AC coupling capacitors, as well as add-in card edge-finger and connector considerations. The intent of the guidelines and examples is to help ensure that good high-speed signal design practices are used and that the timing/jitter and loss/attenuation budgets can also be met from end-to-end across the PCI Express interconnect. However, while general physical guidelines and suggestions are given, they may not necessarily guarantee adequate performance of the interconnect for all layouts and implementations. Therefore, designers should consider modeling and simulation of the interconnect in order to ensure compliance to all applicable specifications. The document is composed of two main sections. The first section provides an overview of general topology and interconnect guidelines. The second section concentrates on physical layout constraints where bulleted items at the beginning of a topic highlight important constraints, while the narrative that follows offers additional insight.
上传时间： 2014-01-24
上传用户：s363994250
Q01、如何使一条走线至两个不同位置零件的距离相同? 您可先在Design/Rule/High Speed/Matched Net Lengths的规则中来新增规则设定,最 后再用Tools/EqualizeNet Lengths 来等长化即可。 Q02、在SCHLIB中造一零件其PIN的属性，如何决定是Passive, Input, I/O, Hi- Z,Power,…..？在HELP中能找到说明吗？市面有关 SIM？PLD？的书吗？或贵公司有讲义？ 你可在零件库自制零件时点选零件Pin脚,并在Electrical Type里,可以自行设定PIN的 属性,您可参考台科大的Protel sch 99se 里 面有介绍关于SIM的内容。 Q03、请问各位业界前辈,如何能顺利读取pcad8.6版的线路图,烦请告知 Protel 99SE只能读取P-CAD 2000的ASCII档案格式,所以你必须先将P-CAD8.6版的格式 转为P-CAD 2000的档案格式,才能让Protel读取。
标签： Protel
上传时间： 2013-11-07
上传用户：tangsiyun
为了提高直接转矩控制（DTC）系统定子磁链估计精度，降低电流、电压测量的随机误差，提出了一种基于扩展卡尔曼滤波（EKF）实现异步电机转子位置和速度估计的方法。扩展卡尔曼滤波器是建立在基于旋转坐标系下由定子电流、电压、转子转速和其它电机参量所构成的电机模型上，将定子电流、定子磁链、转速和转子角位置作为状态变量，定子电压为输入变量，定子电流为输出变量，通过对磁链和转速的闭环控制提高定子磁链的估计精度，实现了异步电机的无速度传感器直接转矩控制策略，仿真结果验证了该方法的可行性,提高了直接转矩的控制性能。 Abstract: In order to improve the Direct Torque Control（DTC） system of stator flux estimation accuracy and reduce the current， voltage measurement of random error， a novel method to estimate the speed and rotor position of asynchronous motor based on extended Kalman filter was introduced. EKF was based on d-p axis motor and other motor parameters （state vector: stator current， stator flux linkage， rotor angular speed and position； input: stator voltage； output: staror current). EKF was designed for stator flux and rotor speed estimation in close-loop control. It can improve the estimated accuracy of stator flux. It is possible to estimate the speed and rotor position and implement asynchronous motor drives without position and speed sensors. The simulation results show it is efficient and improves the control performance.
上传时间： 2015-01-02
上传用户：qingdou
The data plane of the reference design consists of a configurable multi-channel XBERT modulethat generates and checks high-speed serial data transmitted and received by the MGTs. Eachchannel in the XBERT module consists of two MGTs (MGTA and MGTB), which physicallyoccupy one MGT tile in the Virtex-4 FPGA. Each MGT has its own pattern checker, but bothMGTs in a channel share the same pattern generator. Each channel can load a differentpattern. The MGT serial rate depends on the reference clock frequency and the internal PMAdivider settings. The reference design can be scaled anywhere from one channel (two MGTs)to twelve channels (twenty-four MGTs).
上传时间： 2013-12-25
上传用户：jkhjkh1982
This book introduces embedded systems to C and C++ programmers. Topics include testing memory devices, writing and erasing Flash memory, verifying nonvolatile memory contents, controlling on-chip peripherals, device driver design and implementation, optimizing embedded code for size and speed, and making the most of C++ without a performance penalty. Pages : 336 Slots : 1
标签： programmers introduces embedded include
上传时间： 2013-12-10
上传用户：shizhanincc
PhpDig is a search engine written in PHP that uses a MySQL database backend. It features indexing of both static and dynamic pages, spidering of almost all links in HTML content, in hrefs, areamaps, and frames, and full text indexing. The search results appearence is skin-able, using a very simple templates system. PhpDig是一个用PHP编写的搜索引擎，它使用MySQL数据库后台。它的功能有静态和动态页面索引，在HTML内容中用hrefs, areamaps，和frames以及全文本索引构成所有的链接网。搜索结果的外观是可定制外观的，使用一个非常简单的模板系统。
标签： database features indexing backend
上传时间： 2014-01-03
上传用户：haohaoxuexi
Java Clock is a FREE Java applet used to display a clock on your Web pages. You can display either analog or digital clock. The full source code of this applet is also available (visit my home page to download it). You may use this applet on your Web pages WITHOUT paying me fee or royalty as long as credit is given (a link to my home page is enough).
标签： display Java applet either
上传时间： 2014-01-12
上传用户：woshiayin
VC技术内幕第五版_English.The 6.0 release of Visual C++ shows Microsoft s continued focus on Internet technologies and COM, which are key components of the new Windows Distributed interNet Application Architecture (DNA). In addition to supporting these platform initiatives, Visual C++ 6.0 also adds an amazing number of productivity-boosting features such as Edit And Continue, IntelliSense, AutoComplete, and code tips. These features take Visual C++ to a new level. We have tried to make sure that this book keeps you up to speed on the latest technologies being introduced into Visual C++.
标签： Microsoft continued Internet English
上传时间： 2013-12-08
上传用户：lepoke
The Small C compiler translates a subset of the C language into assembly language. It runs under PC/MS-DOS 2.1 and later. Small C is compatible with the Microsoft and Small Mac assemblers. Small C takes full advantage of the ability of these assemblers to generate relocatable object code, to maintain libraries of relocatable modules, and to link separately compiled program modules. It supports a small memory model with one code and one data/stack segment.
标签： language translates compiler assembly
上传时间： 2015-04-08
上传用户：Avoid98
