Keil C251设计软件V3.11(4k代码限制） keil c251 v3.11 demo版的安装说明：安装方法是先将V3.11安装程序用winzip解压缩到某个目录下。（不要直接点击setup.exe安装），比如解压缩到c:\c251然后执行c:\c251\setup\setup.exe 安装程序，这个程序会让你选择安装Eval Version版还是Full Version版，选择Eval Version版进行安装 安装好之后就可以使用，但有代码大小的限制。需要无限制的版本，请购买正版软件。 C251是intel公司的16位单片机，指令兼容51的单片机。8位单片机风靡了20年，下一个20年应该是16位单片机的世界。
上传时间： 2014-01-23
上传用户：yanqie
NXP Semiconductor designed the LPC2400 microcontrollers around a 16-bit/32-bitARM7TDMI-S CPU core with real-time debug interfaces that include both JTAG andembedded Trace. The LPC2400 microcontrollers have 512 kB of on-chip high-speedFlash memory. This Flash memory includes a special 128-bit wide memory interface andaccelerator architecture that enables the CPU to execute sequential instructions fromFlash memory at the maximum 72 MHz system clock rate. This feature is available onlyon the LPC2000 ARM Microcontroller family of products. The LPC2400 can execute both32-bit ARM and 16-bit Thumb instructions. Support for the two Instruction Sets meansEngineers can choose to optimize their application for either performance or code size atthe sub-routine level. When the core executes instructions in Thumb state it can reducecode size by more than 30 % with only a small loss in performance while executinginstructions in ARM state maximizes core performance.
上传时间： 2013-11-15
上传用户：zouxinwang
The LPC1700 Ethernet block contains a full featured 10 Mbps or 100 Mbps Ethernet MAC (Media Access Controller) designed to provide optimized performance through the use of DMA hardware acceleration. Features include a generous suite of control registers, half or full duplex operation, flow control, control frames, hardware acceleration for transmit retry, receive packet filtering and wake-up on LAN activity. Automatic frame transmission and reception with Scatter-Gather DMA off-loads many operations from the CPU.
上传时间： 2013-11-09
上传用户：geshaowei
The CAT25128 is a 128−Kb Serial CMOS EEPROM device internally organized as 16Kx8 bits. This features a 64−byte page write buffer and supports the Serial Peripheral Interface (SPI) protocol. The device is enabled through a Chip Select (CS) input. In addition, the required bus signals are clock input (SCK), data input (SI) and data output (SO) lines. The HOLD input may be used to pause any serial communication with the CAT25128 device. The device featuressoftware and hardware write protection, including partial as well as full array protection.
上传时间： 2013-11-15
上传用户：fklinran
用户程序示例教程 The Blinky project is a simple program for the LPC2138using Keil MCB2130 Microcontroller Board. It blinks the LEDs at speed according to the Potentiometer setting and prints the current seting to the Serial Port 1.In addition it generates a sine wave with an adjustable frequency on the speaker of the board.
上传时间： 2014-12-27
上传用户：hongmo
以典型的9S08 系列为例，当你选择了一个MCU 型号后，在图1-4 右侧会显示出所有针对该型号芯片可用的项目调试场景。其中：Full Chip Simulator”是芯片全功能模拟仿真，即无需任何目标系统的硬件资源，直接在你的PC 机上模拟运行单片机的程序，在模拟运行过程中可以观察调试程序的各项控制和运行流程，分析代码运行的时间，观察各种变量，等等。CW 提供了功能强大的模拟激励功能，可以在模拟运行时模拟一些外部事件的输入，配合程序调试；P&E Multilink/Cyclone Pro”是基于P&E 公司的硬件调试工具实现实时在线硬件调试。实际就是我们经常说的BDM 调试。BDM 调试是基于芯片本身内含的在线调试功能，可实现程序下载，单步／全速运行，可以设若干个断点，可以观察和修改任意寄存器或RAM 内存空间。BDM 几乎是开发飞思卡尔8 位（9S08 和RS08 系列）、16 位（9S12 系列）和32 位（Coldfire V1 系列）单片机的标准调试模式，运用最为广泛；SofTec HCS08”是另外一家SofTec 公司提供的硬件调试工具，国内使用较少；HCS08 Serial Monitor”是基于芯片串口的监控调试开发模式。由于开发效率较低，现在几乎无人使用。
上传时间： 2013-10-10
上传用户：alex wang
The PCA82C250 and PCA82C251 are advanced transceiver products for use in automotive and general industrialapplications with transfer rates up to 1 Mbit/s. They support the differential bus signal representation beingdescribed in the international standard for in-vehicle CAN high-speed applications (ISO 11898). Controller AreaNetwork (CAN) is a serial bus protocol being primarily intended for transmission of control related data between anumber of bus nodes.
上传时间： 2013-11-24
上传用户：Alick
The PCA9549 provides eight bits of high speed TTL-compatible bus switching controlledby the I2C-bus. The low ON-state resistance of the switch allows connections to be madewith minimal propagation delay. Any individual A to B channel or combination of channelscan be selected via the I2C-bus, determined by the contents of the programmable Controlregister. When the I2C-bus bit is HIGH (logic 1), the switch is on and data can flow fromPort A to Port B, or vice versa. When the I2C-bus bit is LOW (logic 0), the switch is open,creating a high-impedance state between the two ports, which stops the data flow.An active LOW reset input (RESET) allows the PCA9549 to recover from a situationwhere the I2C-bus is stuck in a LOW state. Pulling the RESET pin LOW resets the I2C-busstate machine and causes all the bits to be open, as does the internal power-on resetfunction.
上传时间： 2014-11-22
上传用户：xcy122677
Although Stellaris microcontrollers have generous internal SRAM capabilities, certain applicationsmay have data storage requirements that exceed the 8 KB limit of the Stellaris LM3S8xx seriesdevices. Since microcontrollers do not have an external parallel data-bus, serial memory optionsmust be considered. Until recently, the ubiquitous serial EEPROM/flash device was the only serialmemory solution. The major limitations of EEPROM and flash technology are slow write speed, slowerase times, and limited write/erase endurance.Recently, serial SRAM devices have become available as a solution for high-speed dataapplications. The N256S08xxHDA series of devices, from AMI Semiconductor, offer 32 K x 8 bits oflow-power data storage, a fast Serial Peripheral Interface (SPI) serial bus, and unlimited write cycles.The parts are available in 8-pin SOIC and compact TSSOP packages.
上传时间： 2013-10-14
上传用户：cxl274287265
KEIL RTX51实时操作系统中文版:RTX51是一个适用于8051 家族的实时多任务操作系统。RTX51使复杂的系统和软件设计以及有时间限制的工程开发变得简单。RTX51是一个强大的工具，它可以在单个CPU上管理几个作业（任务）。RTX51有两种不同的版本。 RTX51 Full 允许4个优先权任务的循环和切换，并且还能并行的利用中断功能。RTX51 支持信号传递，以及与系统邮箱和信号量进行消息传递。RTX51的os_wait 函数可以等以 下事件：中断、时间到、来自任务或中断的信号、来自任务或中断的消息、信号量。 RTX51 Tiny 是RTX51 Full 的一个子集。RTX51 Tiny 可以很容易的运行在没有扩展外 部存储器的单片机系统上。但是，使用RTX51 Tiny 的程序可以访问外部存储器。RTX51 Tiny允许循环任务切换，并且支持信号传递，还能并行的利用中断功能。RTX51 Tiny 的os_wait函数可以等待以下事件：时间到、时间间隔、来自任务或者中断的信号。 本章节以后的部分用RTX-51 来指代RTX-51 Full 和RTX-51 Tiny。在两者之间不同的 地方会加以说明。
上传时间： 2013-11-25
上传用户：axin881314
