ASR M08-B设置软件 V3.2 arduino 2560+ASRM08-B测试程序 arduino UNO+ASRM08-B测试程序语音控制台灯电路图及C51源码(不带校验码) 继电器模块设置。 ASR M08-B是一款语音识别模块。首先对模块添加一些关键字，对着该模块说出关键字，串口会返回三位的数，如果是返回特定的三位数字，还会引起ASR M08-B的相关引脚电平的变化。【测试】①打开“ASR M08-B设置软件 V3.2.exe”。②选择“串口号”、“打开串口”、点选“十六进制显示”。③将USB转串口模块连接到语音识别模块上。接线方法如下：语音模块TXD --> USB模块RXD语音模块RXD --> USB模块TXD语音模块GND --> USB模块GND语音模块3V3 --> USB模块3V3（此端为3.3V电源供电端。）④将模块的开关拨到“A”端，最好再按一次上面的大按钮（按一次即可，为了确保模块工作在正确的模式）。⑤对着模块说“开灯”、“关灯”模块会返回“0B”、“0A”，表示正常(注意：0B对应返回值010，0B对应返回值010，返回是16进制显示的嘛，设置的时候是10进制设置的)。
标签： ASR M08-B
上传时间： 2022-07-06
上传用户：aben
All inputs of the C16x family have Schmitt-Trigger input characteristics. These Schmitt-Triggers are intended to always provide proper internal low and high levels, even if anundefined voltage level (between TTL-VIL and TTL-VIH) is externally applied to the pin.The hysteresis of these inputs, however, is very small, and can not be properly used in anapplication to suppress signal noise, and to shape slow rising/falling input transitions.Thus, it must be taken care that rising/falling input signals pass the undefined area of theTTL-specification between VIL and VIH with a sufficient rise/fall time, as generally usualand specified for TTL components (e.g. 74LS series: gates 1V/us, clock inputs 20V/us).The effect of the implemented Schmitt-Trigger is that even if the input signal remains inthe undefined area, well defined low/high levels are generated internally. Note that allinput signals are evaluated at specific sample points (depending on the input and theperipheral function connected to it), at that signal transitions are detected if twoconsecutive samples show different levels. Thus, only the current level of an input signalat these sample points is relevant, that means, the necessary rise/fall times of the inputsignal is only dependant on the sample rate, that is the distance in time between twoconsecutive evaluation time points. If an input signal, for instance, is sampled throughsoftware every 10us, it is irrelevant, which input level would be seen between thesamples. Thus, it would be allowable for the signal to take 10us to pass through theundefined area. Due to the sample rate of 10us, it is assured that only one sample canoccur while the signal is within the undefined area, and no incorrect transition will bedetected. For inputs which are connected to a peripheral function, e.g. capture inputs, thesample rate is determined by the clock cycle of the peripheral unit. In the case of theCAPCOM unit this means a sample rate of 400ns @ 20MHz CPU clock. This requiresinput signals to pass through the undefined area within these 400ns in order to avoidmultiple capture events.For input signals, which do not provide the required rise/fall times, external circuitry mustbe used to shape the signal transitions.In the attached diagram, the effect of the sample rate is shown. The numbers 1 to 5 in thediagram represent possible sample points. Waveform a) shows the result if the inputsignal transition time through the undefined TTL-level area is less than the time distancebetween the sample points (sampling at 1, 2, 3, and 4). Waveform b) can be the result ifthe sampling is performed more than once within the undefined area (sampling at 1, 2, 5,3, and 4).Sample points:1. Evaluation of the signal clearly results in a low level2. Either a low or a high level can be sampled here. If low is sampled, no transition willbe detected. If the sample results in a high level, a transition is detected, and anappropriate action (e.g. capture) might take place.3. Evaluation here clearly results in a high level. If the previous sample 2) had alreadydetected a high, there is no change. If the previous sample 2) showed a low, atransition from low to high is detected now.
上传时间： 2013-10-23
上传用户：copu
The RT9018A/B is a high performance positive voltage regulator designed for use in applications requining very low Input voltage and very low dropout voltage at up to 3A(peak).
上传时间： 2013-10-10
上传用户：geshaowei
mp3设计程序资料，采用c语言编写。 README file for yampp-3 source code 2001-05-27 This is the current state of the yampp-3 source code, 2001-05-27. This code is intended to run on Rev. B of the yampp-3 PCB, but can ofcourse be used on compatible systems as well. It still uses the "old" song selection system as the yampp-2. However, the disk handling routines has improved a lot and the obviosly, the new VS1001 handling has been put in. The codesize is almost at it s maximum at 1F40 bytes. A .ROM file is included if you don t have the compiler set up. For now, the documentation is in the code
上传时间： 2015-04-13
上传用户：小码农lz
The Netlab toolbox is designed to provide the central tools necessary for the simulation of theoretically well founded neural network algorithms and related models for use in teaching, research and applications development. It contains many techniques which are not yet available in standard neural network simulation packages
标签： simulation necessary the designed
上传时间： 2013-12-11
上传用户：hj_18
PeerSec Networks MatrixSSL?is an embedded SSL implementation designed for small footprint applications and devices. PeerSec Networks offers a fully supported, commercial version as well as an open source version that is available for download. PeerSec MatrixSSL allows secure management of remote devices. Several secure embedded Web servers also use MatrixSSL for their encryption layer.
标签： implementation applicatio MatrixSSL footprint
上传时间： 2014-01-18
上传用户：561596
DirectX not only provides fast access to the hardware and therefore incredibly speedy performance, but it also makes it much easier for hardware developers to produce new devices that work well in the Windows environment. The DirectX APIs take away the necessity of writing your own low-level, device-specific code to access hardware such as the display adapter and network card, making it much easier for you to write programs that take full advantage of the computer s multimedia capabilities.
标签： performance incredibly therefore hardware
上传时间： 2016-02-16
上传用户：秦莞尔w
The Wifidog project is an open source captive portal solution. It was designed primarily for wireless community groups, but caters to various other business models as well. If you have questions about the wifidog project, they may be answered in the FAQ. You may also be interested in seeing some of the community wireless groups, WISP s, universities, and private businesses currently using Wifidog across the globe.
标签： primarily designed solution Wifidog
上传时间： 2013-11-29
上传用户：梧桐
MPEG-2 has 7 distinct parts as well. The first part is the Systems section which defines the container format and the Transport Streams that are designed to carry the digital video and audio over ATSC and DVB. The Program Stream defines the container format for lossy compression on optical disks, DVDs and SVCDs.
标签： the distinct Systems defines
上传时间： 2014-07-02
上传用户：奇奇奔奔
This material is not only up-to-date, it defines up-to-date. It is truly cutting-edge. As the only book on the subject, Rootkits will be of interest to any Windows security researcher or security programmer. It s detailed, well researched and the technical information is excellent. The level of technical detail, research, and time invested in developing relevant examples is impressive.
标签： up-to-date only cutting-edge material
上传时间： 2017-07-09
上传用户：comua
