This release supports Microsoft Windows NT 4.0, Windows 2000, Windows 95, Windows 98, Windows Me, Windows XP, Red Hat Linux 6.1, Red Hat Linux 7.2, Solaris 2.6, 2.7 (7.0), 8.0, HP-UX 10.20, and 11 (see important note below)." multice22.rar
上传时间： 2013-05-29
上传用户：hustfanenze
·摘要： 以IPC+DSP作为六自由度工业机器人的控制器,设计了一种基于可编程多轴控制器PMAC(Programmable Multi-Axies Controller)的开放式机器人控制系统.采用Visual C++编制控制程序,将机器人系统中管理、控制功能的实现分为若干个模块,负责底层伺服驱动的函数利用PMAC运动语言编写,可直接调用.整个控制软件能完成数据及运动状态显示、伺服驱动、
上传时间： 2013-05-25
上传用户：qwe1234
·Multicarrier Communications: Lie-Liang Yang Wiley | ISBN: 0470722002 | 2009-03-03 ,696 pages Benefiting from both time-domain and frequency-domain signal processing techniques, multi
标签： nbsp Communications Multicarrier Wiley
上传时间： 2013-04-24
上传用户：prczsf
·详细说明：使用凌阳单片机的多命令语音识别范例- The use insults the positive monolithic integrated circuit the multi- orders speech recognition model 文件列表: Recognise_SD ............\bsrSD.h ............\
上传时间： 2013-04-24
上传用户：moshushi0009
·详细说明：双音多频（DTMF）信号发生器的使用源程序，vc 编写，与《双音多频（DTMF）接收器的使用源程序》联合用- The double sound multi- frequencies (DTMF) the signal generating device use source program, the vc compilation, (DTMF) Receiver Use Source p
上传时间： 2013-07-23
上传用户：tianjinfan
·详细说明：双音多频的DTMF信号编码程序，产生DTMF信号进行编码。- The double sound multi- frequencies DTMF signal coded program, produces the DTMF signal to carry on the code.
上传时间： 2013-04-24
上传用户：yangzhiwei
With more and more multi-frequency clocks being used in today's chips, especially in the communications field, it is often necessary to switch the source of a clock line while the chip is running.
上传时间： 2013-10-10
上传用户：1214209695
This document presents design techniques and reference circuits that power Virtex™-4 FXRocketIO™ multi-gigabit transceivers (MGTs) operating at data rates below 3.125 Gb/s.When using multiple transceivers, it is sometimes preferred to power them from a switchingpower supply. However, switching power supplies generate noise that affects transceiver
上传时间： 2013-11-18
上传用户：huang111
For a variety of reasons, it is desirable to charge batteriesas rapidly as possible. At the same time, overchargingmust be limited to prolong battery life. Such limitation ofovercharging depends on factors such as the choice ofcharge termination technique and the use of multi-rate/multi-stage charging schemes. The majority of batterycharger ICs available today lock the user into one fixedcharging regimen, with at best a limited number ofcustomization options to suit a variety of application needsor battery types. The LTC®1325 addresses these shortcomingsby providing the user with all the functionalblocks needed to implement a simple but highly flexiblebattery charger (see Figure 1) which not only addressesthe issue of charging batteries but also those of batteryconditioning and capacity monitoring.
上传时间： 2013-10-19
上传用户：royzhangsz
详细介绍工控软件组态王与单片机多机串口通讯的设计原理。分析组态王提供的直接与单片机串口通信方法的优点，给出系统基于RS-485总线传输的接口电路原理图。根据组态王提供的通讯协议和单片机多机串口通讯的原理，给出程序设计流程与思路。 Abstract: In this paper，the design principle of communication between multi-SCM and KingView by serial ports is described in detail.We analysis the advantage of method supplied by KingView,by which KingView can communicate with serial ports of SCM directly，and provide the system’s interface circuit based on the RS-485transmission line.We provide flow diagram of programming and thinking on the basis of communication protocol supplied by KingView and principle of communication among multi-SCM through serial ports.
上传时间： 2013-12-19
上传用户：tecman
