用Fourier变换求取信号的功率谱---周期图法 用Fourier变换求取信号的功率谱---分段周期图法 用Fourier变换求取信号的功率谱---welch方法 功率谱估计----多窗口法（multitaper method ,MTM法） 功率谱估计----最大熵法（maxmum entmpy method,MEM法） 功率谱估计----多信号分类法（multiple signal classification,music法）Fourier transform to strike a signal to the power spectrum - the cycle of plans Fourier transform to strike a signal to the power spectrum - Sub-cycle Method Fourier transform to strike a signal to the power spectrum --- welch method Power spectrum estimated more than window ---- Law (multitaper method, MTM) ---- Power spectrum estimate of maximum entropy (maxmum entmpy method, MEM) ---- More than the estimated power spectrum signal classification (multiple signal classification, music)
上传时间： 2016-07-16
上传用户：wqxstar
OSCILLATORS are key building blocks in integrated transceivers. In wired and wireless communication terminals, the receiver front-end selects, amplifies and converts the desired high-frequency signal to baseband. At baseband the signal can then be converted into the digital domain for further data processing and demodula- tion. The transmitter front-end converts an analog baseband signal to a suitable high- frequency signal that can be transmitted over the wired or wireless channel.
标签： High-Frequency Oscillator Design
上传时间： 2020-05-27
上传用户：shancjb
随着光伏发电系统快速发展,以及电动汽车充电桩的普及,传统的剩余电流保护器无法满足实际需求。介绍了一款B型剩余电流保护器,采用磁调制剩余电流互感器和零序电流互感器采集剩余电流。根据GB/T 22794—2017标准要求,可识别1 kHz及以下的正弦交流、带和不带直流分量的脉动直流、平滑直流等剩余电流信号。经信号调理电路将电压信号送到单片机进行采集和判断。通过试验测试,该样机在测试精度和速度上均符合国家标准的相关要求。The rapid development of photovoltaic power generation systems and the popularity of electric vehicle charging piles make the traditional residual current protective devices unable to meet the actual demand.This paper proposed a type B residual current protective device,which uses the magnetically modulated residual current transformer and the zero sequence current transformer to acquire the residual current.According to the requirements of GB/T 22794—2017,the type B residual current protective device can detect sinusoidal AC residual current of 1kHz and below 1kHz,pulsating DC residual current with and without DC component,smooth DC residual current and so on.The signal processing circuit sends the voltage signal to the MCU for acquisition and judgment.Through experimental tests,the device meets the relevant requirements of national standards in terms of test accuracy and speed.
标签： 电流保护器
上传时间： 2022-03-27
上传用户：
CH7525 is a low-cost, low-power semiconductor device that translates the DisplayPort signal to HDMI/DVI. This innovative DisplayPort receiver with an integrated HDMI Transmitter is specially designed to target the notebook/ultrabook, tablet device and PC market segments. Through the CH7525’s advanced decoding / encoding algorithm, the input DisplayPort high-speed serialized multimedia data can be seamlessly converted to HDMI/DVI output.
上传时间： 2022-06-02
上传用户：
Abstract：Noise frequency modulation(FM)jamming。which belongs to blanket jamming。is already become the main form ofnoise jamming at present。because the wideband was gained by it．Tne spectnlnl ofnoise FM jamming is analyzed by time domain autocorrelation method in this paper．It’S jamm g peculiarity and几out— putting signal’S jamming peculiarity ale explained．At last，these time series models ofnoise FM jalllIIling sig— nal and几outputting signal ale built．
标签： jamming modulation frequency Abstract
上传时间： 2015-10-17
上传用户：lijinchuan
Commercially available active noise control headphones rely on fixed analog controllers to drive "anti-noise" loudspeakers. Our design uses an adaptive controller to optimally cancel unwanted acoustic noise. This headphone would be particularly useful for workers who operate or work near heavy machinery and engines because the noise is selectively eliminated. Desired sounds, such as speech and warning signals, are left to be heard clearly. The adaptive control algorithm is implemented on a Texas Instruments (TI™ ) 1 TMS320C30GEL digital signal processor (DSP), which drives a Sony CD550 headphone/microphone system. Our experiments indicate that adaptive noise control results in a dramatic improvement in performance over fixed noise control. This improvement is due to the availability of high-performance programmable DSPs and the self-optimizing and tracking capabilities of the adaptive controller in response to the surrounding noise.
标签： Commercially controllers headphones available
上传时间： 2013-12-04
上传用户：dyctj
he LPC932 can be used to create a Pulse Width Modulated PWM signal. That s an analog signal, with only 2 discrete levels, for example 0V and 5V and a constant period. The current value of this signal at a certain poiTnt of time is proportional to its Duty Cycle. That s the High Time during one period divided by the period. It can also be calculated as the average value during a particular period. That means after low pass filtering, (e.g. RC circuit) the signal becomes analog, with an actual value controlled by the microcontroller. The PWM functionality enables the LPC932 to control for example the speed of DC motors or the brightness of electric lighting.
标签： signal Modulated analog create
上传时间： 2015-05-14
上传用户：CHINA526
Adds noise to processes x1(n) and x2(n), at SNR=snr, using seeds s1 and s2.
上传时间： 2015-08-07
上传用户：宋桃子
利用Matlab编程模擬phase noise對OFDM signal的影響,希望供大家参考,Error vector magnitude (EVM)
标签： magnitude Matlab signal vector
上传时间： 2014-01-18
上传用户：wanghui2438
signal for via with noise
上传时间： 2013-12-21
上传用户：dreamboy36
