Information in this document is subject to change without notice and does notrepresent a commitment on the part of the manufacturer. The software describedin this document is furnished under license agreement or nondisclosureagreement and may be used or copied only in accordance with the terms of theagreement. It is against the law to copy the software on any medium except asspecifically allowed in the license or nondisclosure agreement. The purchasermay make one copy of the software for backup purposes. No part of this manualmay be reproduced or transmitted in any form or by any means, electronic ormechanical, including photocopying, recording, or information storage andretrieval systems, for any purpose other than for the purchaser’s personal use,without written permission.
上传时间： 2014-12-27
上传用户：Tracey
The TL2575 and TL2575HV represent superior alternatives to popular three-terminal linear regulators. Due totheir high efficiency, the devices significantly reduce the size of the heatsink and, in many cases, no heatsink isrequired. Optimized for use with standard series of inductors available from several different manufacturers, theTL2575 and TL2575HV greatly simplify the design of switch-mode power supplies by requiring a minimaladdition of only four to six external components for operation.
标签： STEP-DOWN SWITCHING SIMPLE 1A
上传时间： 2013-11-20
上传用户：jelenecheung
All inputs of the C16x family have Schmitt-Trigger input characteristics. These Schmitt-Triggers are intended to always provide proper internal low and high levels, even if anundefined voltage level (between TTL-VIL and TTL-VIH) is externally applied to the pin.The hysteresis of these inputs, however, is very small, and can not be properly used in anapplication to suppress signal noise, and to shape slow rising/falling input transitions.Thus, it must be taken care that rising/falling input signals pass the undefined area of theTTL-specification between VIL and VIH with a sufficient rise/fall time, as generally usualand specified for TTL components (e.g. 74LS series: gates 1V/us, clock inputs 20V/us).The effect of the implemented Schmitt-Trigger is that even if the input signal remains inthe undefined area, well defined low/high levels are generated internally. Note that allinput signals are evaluated at specific sample points (depending on the input and theperipheral function connected to it), at that signal transitions are detected if twoconsecutive samples show different levels. Thus, only the current level of an input signalat these sample points is relevant, that means, the necessary rise/fall times of the inputsignal is only dependant on the sample rate, that is the distance in time between twoconsecutive evaluation time points. If an input signal, for instance, is sampled throughsoftware every 10us, it is irrelevant, which input level would be seen between thesamples. Thus, it would be allowable for the signal to take 10us to pass through theundefined area. Due to the sample rate of 10us, it is assured that only one sample canoccur while the signal is within the undefined area, and no incorrect transition will bedetected. For inputs which are connected to a peripheral function, e.g. capture inputs, thesample rate is determined by the clock cycle of the peripheral unit. In the case of theCAPCOM unit this means a sample rate of 400ns @ 20MHz CPU clock. This requiresinput signals to pass through the undefined area within these 400ns in order to avoidmultiple capture events.For input signals, which do not provide the required rise/fall times, external circuitry mustbe used to shape the signal transitions.In the attached diagram, the effect of the sample rate is shown. The numbers 1 to 5 in thediagram represent possible sample points. Waveform a) shows the result if the inputsignal transition time through the undefined TTL-level area is less than the time distancebetween the sample points (sampling at 1, 2, 3, and 4). Waveform b) can be the result ifthe sampling is performed more than once within the undefined area (sampling at 1, 2, 5,3, and 4).Sample points:1. Evaluation of the signal clearly results in a low level2. Either a low or a high level can be sampled here. If low is sampled, no transition willbe detected. If the sample results in a high level, a transition is detected, and anappropriate action (e.g. capture) might take place.3. Evaluation here clearly results in a high level. If the previous sample 2) had alreadydetected a high, there is no change. If the previous sample 2) showed a low, atransition from low to high is detected now.
上传时间： 2013-10-23
上传用户：copu
Automobiles, aircraft, marine vehicles, uninterruptiblepower supplies and telecom hardware represent areasutilizing series connected battery stacks. These stacksof individual cells may contain many units, reaching potentialsof hundreds of volts. In such systems it is oftendesirable to accurately determine each individual cell’svoltage. Obtaining this information in the presence of thehigh “common mode” voltage generated by the batterystack is more diffi cult than might be supposed.
上传时间： 2013-10-24
上传用户：kang1923
his folder contains the following files: 1. 02490rxP802-15_SG3a-Channel-Modeling-Subcommittee-Report-Final.doc: This is the final report of the channel modeling sub-committee. 2. cmx_imr.csv (x=1, 2, 3, and 4) represent the files containing the actual 100 channel realizations for CM1, CM2, CM3, and CM4. The columns are organized as (time, amp, time, amp,...) 3. cmx_imr_np.csv (x=1, 2, 3, and 4) represent the files containing the number of paths in each of the 100 multipath realizations. 4. cmx_imr.mat (x=1, 2, 3, and 4) are the .mat files that can be loaded directly into Matlab (TM). 5. *.m files are the Matlab (TM) files used to generate the various channel realizations.
标签： a-Channel-Modeling-Subcommittee-R following contains folder
上传时间： 2013-12-21
上传用户：hxy200501
一个游戏 the hardware for the game includes a number of displays, each with a button and -- a light, that each represent a bin that can store marbles (beans). -- -- The display indicates the number of marbles in each bin at any given time. -- The light indecates that the present bin is not empty and that pushing the -- button is a valid move in the game. -- -- The button for each display indicates that a player takes the marbles from -- the selected bin, and takes them in his hand. The hand is represented by a -- diplay itself (no button). -- -- Each player has a home bin, located on opposite sides of the game.
标签： the hardware displays includes
上传时间： 2015-06-10
上传用户：cc1015285075
This program demonstrates some function approximation capabilities of a Radial Basis Function Network. The user supplies a set of training points which represent some "sample" points for some arbitrary curve. Next, the user specifies the number of equally spaced gaussian centers and the variance for the network. Using the training samples, the weights multiplying each of the gaussian basis functions arecalculated using the pseudo-inverse (yielding the minimum least-squares solution). The resulting network is then used to approximate the function between the given "sample" points.
标签： approximation demonstrates capabilities Function
上传时间： 2014-01-01
上传用户：zjf3110
OLE Programmer s Reference Information in this online help system is subject to change without notice and does not represent a commitment on the part of Microsoft Corporation. The software and/or files described in this online help system are furnished under a license agreement or nondisclosure agreement. The software and/or files may be used or copied only in accordance with the terms of the agreement. The purchaser may make one copy of the software for backup purposes. No part of this online help system may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying, recording, or information and retrieval systems, for any purpose other than the purchaser s personal use, without the written permission of Microsoft Corporation.
标签： Information Programmer Reference subject
上传时间： 2015-08-04
上传用户：hxy200501
This project does not contain a full, runnable application program. Instead, the only package ope.account contains two classes which represent basic bank customer and account information.
标签： application runnable Instead project
上传时间： 2013-12-25
上传用户：许小华
This project does not contain a full, runnable application program. Instead, the only package ope.football contains two classes to represent match data for football (and possibly other team sports).
标签： application runnable Instead project
上传时间： 2015-09-03
上传用户：zhaiyanzhong
