虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

range-doppler

  • EN 300220-1V2.4.1

    EN 300220-1V2.4.1  Electromagnetic compatibility and Radio spectrum Matters (ERM);Short Range Devices (SRD);Radio equipment to be used in the 25 MHz to 1 000 MHz frequency range with power levels ranging up to 500 mW; Part 1: Technical characteristics and test methods

    标签: EMC

    上传时间: 2021-07-25

    上传用户:beiyouxia

  • HX3248C

    FFeeaattuurreess  Input voltage range: 2.2 to 6V   Programmable LED Current   Drives LEDs Up to 27V   Switching Frequency:up to 800KHz  Wide dimming frequency range: 20KHz~  360 KHz   Programmable Overvoltage Protection   Tiny SOP8/PP Package

    标签: HX3248C

    上传时间: 2021-11-05

    上传用户:aben

  • SC3633

    Wide 2.2V to 6V Input Voltage Range „ 0.20V FB adjustable LED drive current „ Directly drive 9 Series 1W LED at VIN>=6V „ Fixed 800KHz Switching Frequency „ Max. 3A Switching Current Capability „ Up to 92% efficiency „ Excellent line and load regulation „ EN PIN TTL shutdown capability „ Internal Optimize Power MOSFET

    标签: sc3633

    上传时间: 2021-11-05

    上传用户:d1997wayne

  • XR2981

    2.7V to 5.5V input voltage Range Efficiency up to 96%  24V Boost converter with 12A switch current Limit 600KHz fixed Switching Frequency Integrated soft-start Thermal Shutdown Under voltage Lockout Support external LDO auxiliary power supply 8-Pin SOP-PP PackageAPPLICATIONSPortable Audio Amplifier Power SupplyPower BankQC 2.0/Type CWireless ChargerPOS Printer Power SupplySmall Motor Power Supply

    标签: XR2981

    上传时间: 2021-11-05

    上传用户:

  • USB PD3.1快充标准 2021年5月最新版

    USB PD3.1正式发布,上述文档是此标准的详细内容5月25日,USB-IF协会推出了USB Type-C线缆和接口标准v2.1版本,其中更新了有关供电能力的章节。USB PD3.1规范将原来的USB PD3.0内容归到标准功率范围(Standard Power Range,简称SPR)里面,最大功率保持100W不变;同时增加了扩展功率范围(Extended Power Range,简称EPR),最大功率由100W扩展到240W。

    标签: Type-C pd3.1 快充 USB-IF协会

    上传时间: 2021-11-13

    上传用户:

  • IW3617 230V 调光设计参考.pdf

    General Design Specification:1. AC Input Range 180-264Vac, Isolated ac-dc offline, 12LEDS,Output 700mA2. Intelligent wall dimmer detections(Leading-edge dimmer , Trailing-edgedimmer , No-dimmer)3. Multiple dimming control scheme4. Wide dimming range from 1% up to 100%5. No visible flicker6. Resonant control to achieve high efficiency7. High Power Factor, 0.9 without dimmer8. Temperature degrade control to adjust the LED9. Primary-only Sensing eliminates opto-isolator feedback and simplifies design

    标签: iw3617

    上传时间: 2021-12-03

    上传用户:canderile

  • PC1099N datasheet

    The PC1099N from Pixelplus is a CMOS Image Sensor with Mega Pixels 0.3 MP, VGA, Supply Voltage Analog: 3.3 V, HVDD: 3.3 V, CVDD: 3.3 V, Frame Rate 50 to 60 fps, Dynamic Range 63.2 dB, SNR 45.3 dB. More details for PC1099N can be seen below.

    标签: pc1099n

    上传时间: 2021-12-12

    上传用户:qingfengchizhu

  • STM32L053C8T6数据手册

    STM32L053C8T6数据手册Features • Ultra-low-power platform – 1.65 V to 3.6 V power supply – -40 to 125 °C temperature range – 0.27 µA Standby mode (2 wakeup pins) – 0.4 µA Stop mode (16 wakeup lines) – 0.8 µA Stop mode + RTC + 8 KB RAM retention – 139 µA/MHz Run mode at 32 MHz – 3.5 µs wakeup time (from RAM) – 5 µs wakeup time (from Flash) • Core: ARM® 32-bit Cortex®-M0+ with MPU – From 32 kHz up to 32 MHz max.  – 0.95 DMIPS/MHz • Reset and supply management – Ultra-safe, low-power BOR (brownout reset)  with 5 selectable thresholds – Ultralow power POR/PDR – Programmable voltage detector (PVD) • Clock sources – 1 to 25 MHz crystal oscillator – 32 kHz oscillator for RTC with calibration – High speed internal 16 MHz factory-trimmed RC  (+/- 1%) – Internal low-power 37 kHz RC – Internal multispeed low-power 65 kHz to  4.2 MHz RC – PLL for CPU clock • Pre-programmed bootloader – USART, SPI supported • Development support – Serial wire debug supported • Up to 51 fast I/Os (45 I/Os 5V tolerant) • Memories – Up to 64 KB Flash with ECC – 8KB RAM – 2 KB of data EEPROM with ECC – 20-byte backup register

    标签: stm32l053c8t6

    上传时间: 2022-02-06

    上传用户:

  • PW2606B.pdf规格书下载

    The PW2606B is a front-end over voltage and over current protection device. It achieves wide inputvoltage range from 2.5VDC to 40VDC. The over voltage threshold can be programmed externally orset to internal default setting. The low resistance of integrated power path nFET switch ensures betterperformance for battery charging system applications. It can deliver up to 1A current to satisfy thebattery supply system. It integrates the over-temperature protection shutdown and auto-recoverycircuit with hysteresis to protect against over current events

    标签: pw2606b

    上传时间: 2022-02-11

    上传用户:

  • PW2601_2.0.pdf规格书下载

    The PW2601 is a charger front-end integrated circuit designed to provide protection to Li-ionbatteries from failures of charging circuitry. The device monitors the input voltage, battery voltageand the charging current to make sure all three parameters are operated in normal range. Thedevice will switch off internal MOSFET to disconnect IN to OUT to protect load when any of inputvoltage, output current exceeds the threshold. The Over temperature protection (OTP) functionmonitors chip temperature to protect the device. The PW2601 also can protect the system’sbattery from being over charged by monitors the battery voltage continuously. The deviceoperates like a linear regulator, maintaining a 5.1V output with input voltages up to the input overvoltage threshold.The PW2601 is available in DFN-2x2-8L package. Standard products are Pb-free and Halogenfree

    标签: pw2601

    上传时间: 2022-02-11

    上传用户: