LVQ学习矢量化算法源程序 This directory contains code implementing the Learning vector quantization network. Source code may be found in LVQ.CPP. Sample training data is found in LVQ1.PAT. Sample test data is found in LVQTEST1.TST and LVQTEST2.TST. The LVQ program accepts input consisting of vectors and calculates the LVQ network weights. If a test set is specified, the winning neuron (class) for each neuron is identified and the Euclidean distance between the pattern and each neuron is reported. Output is directed to the screen.
标签： implementing quantization directory Learning
上传时间： 2015-05-02
上传用户：hewenzhi
WSP is an HTTP to WSP proxy that can be used to forward HTTP requests to WSP, which is used in WAP 1.x. It may be called a reverse WAP gateway, and enables you to test or browse WAP sites with HTTP tools. It also can be used with penetration test tools.
上传时间： 2013-12-16
上传用户：大三三
pic mcu code:This application note describes the design and implementation of a USB Mass Storage Device (MSD) using a Secure Digital card, which should prove useful to developers of USB mass storage solutions. This application may be used as a stand-alone MSD or as a Secure Digital/Multimedia Card (SD/MMC) reader/ writer interface.
标签： implementation application describes Storage
上传时间： 2014-11-23
上传用户：天诚24
This project is created using the Keil ARM CA Compiler. The Logic Analyzer built into the simulator may be used to monitor and display any variable or peripheral I/O register. It is already configured to show the PWM output signal on PORT3.0 and PORT3.1 This ARM Example may be debugged using only the uVision Simulator and your PC--no additional hardware or evaluation boards are required. The Simulator provides cycle-accurate simulation of all on-chip peripherals of the ADuC7000 device series. You may create various input signals like digital pulses, sine waves, sawtooth waves, and square waves using signal functions which you write in C. Signal functions run in the background in the simulator within timing constraints you configure. In this example, several signal functions are defined in the included Startup_SIM.INI file.
标签： the Analyzer Compiler project
上传时间： 2013-12-19
上传用户：Yukiseop
This example program shows how to configure and use the A/D Converter of the following microcontroller: STMicroelectronics ST10F166 After configuring the A/D, the program reads the A/D result and outputs the converted value using the serial port. To run this program... Build the project (Project Menu, Build Target) Start the debugger (Debug Menu, Start/Stop Debug Session) View the Serial Window (View Menu, Serial Window #1) View the A/D converter peripheral (Peripheral Menu, A/D Converter) Run the program (Debug Menu, Go) A debug script (debug.ini) creates buttons that set different analog values in A/D channels. As the program runs, you will see the A/D input and output change. Other buttons create signals that generate sine wave or sawtooth patterns as analog inputs. µ Vision3 users may enable the built-in Logic Analyzer to view, measure and compare these input signals graphically.
标签： microcontroll Converter configure following
上传时间： 2014-12-01
上传用户：独孤求源
This m-file displays the time waveform for the Gaussian pulse function and the first and second derivatives of the Gaussian pulse function for a 0.5 nanosecond pulse width. Other values of pulse widths may be used by changing fs,t,t1. The program uses the actual first and second derivative equations for the Gaussian pulse waveforms. The first derivative is considered to be the monocycle or monopulse as discussed in most papers. The second derivative is the waveform generated from a dipole antenna used in a UWB system. Other information is contained in the file.
上传时间： 2015-05-08
上传用户：leixinzhuo
Decoding most of the infrared signals can be easily handled by PIC16C5X microcontrollers. This application note describes how this decoding may be done. The only mandatory hardware for decoding IR signals is an infrared receiver. The use of two types is described here. Both are modular types used often by the consumer electronics industry. The first type responds to infrared signals modulated at about 40 kHz. The second responds to non-modulated infrared pulses and has a restricted range. The hardware costs of each approach will be less than two dollars.
标签： microcontrollers Decoding infrared handled
上传时间： 2015-05-24
上传用户：ruan2570406
Micro In-System Programmer Brief Installation Notes Enter the src directory. If uisp does not compile successfully, add switch -DNO_DIRECT_IO in the Makefile to remove support for direct I/O port access (that may be necessary on non-PC architectures). Parallel port access should still work if you have the Linux ppdev driver (patch for 2.2.17 is in the kernel directory, ppdev is standard in 2.4 kernels). Please lobby Alan Cox to include this tiny little driver in 2.2.x too :). To make it type: make and to install it: make install If you have any further doubts, please consult UISP s homepage: http://www.nongnu.org/uisp/
标签： Installation Programmer In-System directory
上传时间： 2013-12-23
上传用户：小儒尼尼奥
Copyright Copyright © 2004 O Reilly Media, Inc. Printed in the United States of America. Published by O Reilly MediaInc., 1005 Gravenstein Highway North, Sebastopol, CA 95472. O Reilly & Associates books may be purchased for educational, business, or sales promotional use. Online editions are also available for most titles (http://safari.oreilly.com). For more information, contact our corporate/institutional sales department: (800) 998-9938 or corporate@oreilly.com. Nutshell Handbook, the Nutshell Handbook logo, and the O Reilly logo are registered trademarks of O Reilly Media, Inc The Cookbook series designations, Java Servlet and JSP Cookbook, the image of a fennec fox, and related trade dress are trademarks of O Reilly & Associates, Inc. Java and all Java-based trademarks and logos are trademarks or registered trademarks of Sun Microsystems, Inc., in the United States
标签： Copyright America Printed Reilly
上传时间： 2014-08-20
上传用户：lps11188
This file came from Planet-Source-Code.com...the home millions of lines of source code You can view comments on this code/and or vote on it at: http://www.Planet-Source-Code.com/vb/scripts/ShowCode.asp?txtCodeId=58860&lngWId=1 The author may have retained certain copyrights to this code...please observe their request and the law by reviewing all copyright conditions at the above URL.
标签： Planet-Source-Code millions source lines
上传时间： 2013-12-26
上传用户：dancnc
