This application note describes how to build a system that can be used for determining theoptimal phase shift for a Double Data Rate (DDR) memory feedback clock. In this system, theDDR memory is controlled by a controller that attaches to either the OPB or PLB and is used inan emBedded microprocessor application. This reference system also uses a DCM that isconfigured so that the phase of its output clock can be changed while the system is running anda GPIO core that controls that phase shift. The GPIO output is controlled by a softwareapplication that can be run on a PowerPC® 405 or Microblaze™ microprocessor.
上传时间： 2014-11-26
上传用户：erkuizhang
The introduction of Spartan-3™ devices has createdmultiple changes in the evolution of emBedded controldesigns and pushed processing capabilities to the “almostfreestage.” With these new FPGAs falling under $20, involume, with over 1 million system gates, and under $5for 100K gate-level units, any design with programmablelogic has a readily available 8- or 16-bit processor costingless than 75 cents and 32-bit processor for less than $1.50.
上传时间： 2013-10-21
上传用户：ligi201200
The Xilinx Zynq-7000 Extensible Processing Platform (EPP) redefines the possibilities for emBedded systems, giving system and software architects and developers a flexible platform to launch their new solutions and traditional ASIC and ASSP users an alternative that aligns with today’s programmable imperative. The new class of product elegantly combines an industrystandard ARMprocessor-based system with Xilinx 28nm programmable logic—in a single device. The processor boots first, prior to configuration of the programmable logic. This, along with a streamlined workflow, saves time and effort and lets software developers and hardware designers start development simultaneously.
上传时间： 2013-10-09
上传用户：evil
针对嵌入式机器视觉系统向独立化、智能化发展的要求，介绍了一种嵌入式视觉系统--智能相机。基于对智能相机体系结构、组成模块和图像采集、传输和处理技术的分析，对国内外的几款智能相机进行比较。综合技术发展现状，提出基于FPGA+DSP模式的硬件平台，并提出智能相机的发展方向。分析结果表明，该系统设计可以实现脱离PC运行，完成图像获取与分析，并作出相应输出。 Abstract: This paper introduced an emBedded vision system-intelligent camera ，which was for emBedded machine vision systems to an independent and intelligent development requirements. Intelligent camera architecture， component modules and image acquisition， transmission and processing technology were analyzed. After comparing integrated technology development of several intelligent cameras at home and abroad， the paper proposed the hardware platform based on FPGA+DSP models and made clear direction of development of intelligent cameras. On the analysis of the design， the results indicate that the system can run from the PC independently to complete the image acquisition and analysis and give a corresponding output.
上传时间： 2013-11-14
上传用户：无聊来刷下
Prakash Rashinkar has over 15 years experience in system design and verificationof emBedded systems for communication satellites, launch vehicles and spacecraftground systems, high-performance computing, switching, multimedia, and wirelessapplications. Prakash graduated with an MSEE from Regional Engineering College,Warangal, in India. He lead the team that was responsible for delivering themethodologies for SOC verification at Cadence Design Systems. Prakash is anactive member of the VSIA Functional Verification DWG. He is currently Architectin the Vertical Markets and Design Environments Group at Cadence.
上传时间： 2013-11-19
上传用户：m62383408
SL811开发资料_包含源程序_电路图_芯片资料:SL811HS emBedded USB Host/Slave Controller.The SL811HS is an emBedded USB Host/Slave Controller capable of communicate with either full-speed or low-speed USB peripherals. The SL811HS can interface to devices such as microprocessors, microcontrollers, DSPs, or directly to a variety of buses such as ISA, PCMCIA, and others. The SL811HS USB Host Controller conforms to USB Specification 1.1.The SL811HS USB Host/Slave Controller incorporates USB Serial Interface functionality along with internal full-/low-speed transceivers.The SL811HS supports and operates in USB full-speed mode at 12 Mbps, or at low-speed 1.5-Mbps mode.The SL811HS data port and microprocessor interface provide an 8-bit data path I/O or DMA bidirectional, with interrupt support to allow easy interface to standard microprocessors or microcontrollers such as Motorola or Intel CPUs and many others. Internally,the SL811HS contains a 256-byte RAM data buffer which is used for control registers and data buffer.The available package types offered are a 28-pin PLCC (SL811HS) and a 48-pin TQFP package (SL811HST-AC). Both packages operate at 3.3 VDC. The I/O interface logic is 5V-tolerant.
上传时间： 2013-12-22
上传用户：a82531317
CSL is a programming language with C syntax and comprehensive libraries. The compact scripting engine can also be emBedded into your own applications as a powerful macro language. Windows Distribution utilities.
标签： comprehensive programming libraries scripting
上传时间： 2013-11-27
上传用户：xuanchangri
We intend to develop a wifi enabled p2p file sharing system on a linux platform using jxta and java. The purpose is to build a system that can be ported to an emBedded device at a later stage and be used for p2p file sharing using the 802.11b standard. 我们旨在Linux平台上使用jxta 和java来开发一个支持wifi的p2p文件共享系统。其目的是建造一个以后可以移植到嵌入式设备的系统，使用802.11b标准进行p2p文件共享。 来源: http://sourceforge.net/projects/linux-p2p-wifi/
标签： platform develop enabled sharing
上传时间： 2015-01-20
上传用户：Shaikh
JILRuntime A general purpose, register based virtual machine (VM) that supports object-oriented features, reference counting (auto destruction of data as soon as it is no longer used, no garbage collection), exceptions (handled in C/C++ or virtual machine code) and other debugging features. Objects and functions can be written in virtual machine code, as well as in C or C++, or any other language that can interface to C object code. The VM is written for maximum performance and thus is probably not suitable for emBedded systems where a small memory footprint is required. Possible uses of the VM are in game development, scientific research, or to provide a stand-alone, general purpose programming environment.
标签： object-oriented JILRuntime register supports
上传时间： 2013-12-23
上传用户：cc1015285075
The JILRunOnly project is a simple command-line application written in ANSI-C that is intended to demonstrate in detail, how the JILRuntime/JewelScript library can be emBedded into an application.
标签： command-line application JILRunOnly intended
上传时间： 2015-04-03
上传用户：ywqaxiwang
