PRINCIPLE: The UVE algorithm detects and eliminates from a PLS model (including from 1 to A components) those variables that do not carry any relevant information to model Y. The criterion used to trace the un-informative variables is the reliability of the regression coefficients: c_j=mean(b_j)/std(b_j), obtained by jackknifing. The cutoff level, below which c_j is considered to be too small, indicating that the variable j should be removed, is estimated using a matrix of random variables.The predictive power of PLS models built on the retained variables only is evaluated over all 1-a dimensions =(yielding RMSECVnew).
标签： from eliminates PRINCIPLE algorithm
上传时间： 2016-11-27
上传用户：凌云御清风
The Graham scan examines the points one by one and eliminates the points which cause reflexive angles
标签： points eliminates one reflexive
上传时间： 2017-02-17
上传用户：jing911003
Abstract: This application note describes the essential workings of an electrocardiogram (ECG). It discussesfactors that disrupt the ECG signals and make reliable, highly-accurate electrical characterization difficult. Theindustry-standard solution for ECG electrical characterization, which uses an analog front-end and ADCcombination, is explained. The article then introduces the MAX11040 simultaneous-sampling, sigma-deltaADC as a compelling, highly integrated solution that eliminates the need for the AFE, and saves both spaceand cost for the application.
上传时间： 2013-12-23
上传用户：sssl
Portable, battery-powered operation of electronic apparatushas become increasingly desirable. Medical, remotedata acquisition, power monitoring and other applicationsare good candidates for battery operation. In some circumstances,due to space, power or reliability considerations,it is preferable to operate the circuitry from a single 1.5Vcell. Unfortunately, a 1.5V supply eliminates almost alllinear ICs as design candidates. In fact, the LM10 opamp-reference and the LT®1017/LT1018 comparators arethe only IC gain blocks fully specifi ed for 1.5V operation.Further complications are presented by the 600mV dropof silicon transistors and diodes. This limitation consumesa substantial portion of available supply range, makingcircuit design diffi cult. Additionally, any circuit designedfor 1.5V operation must function at end-of-life batteryvoltage, typically 1.3V. (See Box Section, “Componentsfor 1.5V Operation.”)
标签： Circuitry Operation Single 1017
上传时间： 2013-12-20
上传用户：Wwill
The CN3052A is a complete constant-current /constant voltage linear charger for single cell Li-ion and Li Polymer rechargeable batteries. The device contains an on-chip power MOSFET and eliminates the need for the external sense resistor and blocking diode.
上传时间： 2013-11-10
上传用户：子虚乌有
Portable, battery-powered operation of electronic apparatushas become increasingly desirable. Medical, remotedata acquisition, power monitoring and other applicationsare good candidates for batteryoperation. In some circumstances,due to space, power or reliability considerations,it is preferable to operate the circuitry from a single 1.5Vcell. Unfortunately, a 1.5V supply eliminates almost alllinear ICs as design candidates. In fact, the LM10 opamp-reference and the LT®1017/LT1018 comparators arethe only IC gain blocks fully specifi ed for 1.5V operation.Further complications are presented by the 600mV dropof silicon transistors and diodes. This limitation consumesa substantial portion of available supply range, makingcircuit design diffi cult. Additionally, any circuit designedfor 1.5V operation mustfunction at end-of-life batteryvoltage, typically 1.3V. (See Box Section, “Componentsfor 1.5V Operation.”)
标签： Circuitry Operation Single Cell
上传时间： 2013-10-30
上传用户：hz07104032
应用 APPLICATIONS·电视机、录像机、音频设备、显示器、复印机、打印装置、游戏机及计算机等。·用于开关电源线性滤波器。·削除 TV、VTR、VCR及监听器泄漏杂音。·用于OA 设备、通信设备和其它器件。·TV set, recorder, sound-frequency equipment, show-scope, photocopy-scope, typewrite equipment, recreation-scope, computer etc.·For line filters of switching power supplies.·eliminates incoming/leaking noise of TVs, VTRs/VCRs and audio equipment .·For OA equipment, communications equipment and other electronic devices.
上传时间： 2013-10-23
上传用户：shizhanincc
The PMSM FOC is made of several C modules, compatible with the free-of-charge IAR EWARM KickStart edition toolchain version 4.42. It is used to quickly evaluate both the MCU and the available tools. In addition, when used together with the STM32F103xx motor control starter kit (STM3210B-MCKIT) and PM motor, a motor can be made to run in a very short time. It also eliminates the need for time-consuming development of FOC and speed regulation algorithms by providing ready-to-use functions that let the user concentrate on the application layer. Moreover, it is possible to get rid of any speed sensor thanks to the sensorless algorithm for rotor position reconstruction.
标签： free-of-charge compatible KickStart modules
上传时间： 2014-01-09
上传用户：498732662
The System Management BIOS Reference Specification addresses how motherboard and system vendors present management information about their products in a standard format by extending the BIOS interface on Intel architecture systems. The information is intended to allow generic instrumentation to deliver this data to management applications that use CIM (the WBEM data model) or direct access and eliminates the need for error prone operations like probing system hardware for presence detection.
标签： Specification motherboard Management Reference
上传时间： 2013-12-10
上传用户：凤临西北
This control is another extension to the now standard and widely used ListView control. I have included some of the more common features: shaded columns, column sorting (with data type), but the real addition is the FILTERBAR features of the header. This implementation eliminates all of the work of dealing with the filter messages and item filtering by incorporating it into the control. This could have been implemented as delegates, but we create controls to do the work for us, don t we? I would like to thank Carlos H. Perez since a lot of the implementation came from examples he set with his ListViewEx control.
标签： control extension ListView standard
上传时间： 2013-12-05
上传用户：royzhangsz
