虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

decision-making

  • 基于DSP28035的高速永磁无刷直流电机驱动系统

    基于DSP28035的高速永磁无刷直流电机驱动系统,包括论文和软硬设计资料。摘要参赛作品为基于DSP28035的高速永磁无刷直流电机驱动系统。该系统以一台额定转速60 krpm的高速永磁无刷直流电机、交错并联的Buck电路以及全桥电路为硬件平台,以DSP28035为控制核心,实现了调压调速功能和基于坐标变换的无位置传感器新技术。为实现该系统要求,本作品充分利用了DSP28035的资源例如:CLA模块,模拟比较器、HPWM模块以及AD转换模块等。AbstractThis work is the drive system for a high speed permanent magnet burshless dc motor based on DSP28035. The hardware platform consists of a BLDC motor(rated speed is 60000rpm), a Buck circuit and an inverter. Under the control of DSP28035, this system can achieve the goal of adjusting the motor’s speed with voltage and the function of sensorless control based on the coordinate transformation. By making full use of resources of the core, such as CLA, analog comparator, HPWM and AD converters, the whole system can meet the requirements.1 引言高速永磁无刷直流电机驱动系统由于基波频率较高(一般在1kHZ以上),利用逆变桥斩波进行调速的控制方式通常会受到开关管开关频率的限制,因此该系统多采用三相全桥前级加Buck电路进承担调压调速的功能,而三相全桥主要承担逻辑换相的功能。然而,传统Buck电路所需电感的体积较大,增加了系统的体积,降低了系统的功率密度。

    标签: dsp28035 直流电机

    上传时间: 2022-05-08

    上传用户:bluedrops

  • 血氧仪核心硬件电路设计及Multisim仿真

    为了实时检测血氧量,能使缺氧特别敏感的脑组织或心脏类疾病患者得到及时治疗,采用近红外双波长透射式光电脉搏血氧测定法,以H桥电路对发射光源进行控制及通用运算放大器搭建滤波电路。运用参数理论计算和计算机仿真结果相对比的方法,通过Mu ltisim软件对所设计电路进行仿真,仿真结果与理论参数计算相吻合,证明了电路参数设计的可行性,为血氧仪的实物制作提供参考。For real-time detection of oxygen saturation for timely treatment of the brain or heart,which are very sensitive to oxygen inadequacy,the near-infrared wavelengths double photoelectric pulse oximeter transmission method is adopted.The illuminant is controlled with the H bridge circuit and the filter circuit is built with general op-amps.Parameters by theoretical calculation is compared with the computer simulation results in Multisim and satisfactory results are obtained.It is shown that the design of the circuit parameters is feasible and can be a help in making the physical blood-oxygen monitor.

    标签: multisim 光电二极管 滤波器

    上传时间: 2022-05-12

    上传用户: