通信：不同的独立系统利用线路互相交换数据便是通信。通信的主要目的是将数据从一端发送到另一端，以实现数据的交换。网络：构成整个通信的线路称为网络。计算机网络：交换信息的系统若为计算机系统，则称为计算机网络（Computer Network）通信。发送端：就是根据协议将数据利用一定的程序通过线路发送出去。接收端：根据协议将数据收集起来并存储或显示在屏幕上
标签： 串行通信
上传时间： 2021-11-30
上传用户：
uninstall the device in the "Computer Management" pannel.在设备管理器中卸载已有驱动install PL2303-Prolific_DriverInstaller_v1200安装压缩包中的PL2303-Prolific_DriverInstaller_v1200restart your computer.重启计算机
上传时间： 2022-03-13
上传用户：jiabin
M.NT68676.2A is a monitor control board, which is suitable for Asia-Pacific market. It can supportLED/LCD panels which resolution is up to 2048×1152.M.NT68676.2A can synchronize with computer automatically. Synchronization requires thesynchronous signal which horizontal and vertical sync are separated.M.NT68676.2A can support dynamic contrast control, headphone input and Digital volume controlsimultaneously.
标签： 乐华驱动板
上传时间： 2022-03-13
上传用户：kent
本系统采用电动机电枢供电回路串接采样电阻的方式来实现对小型直流有刷电动机的转速测量。该系统主要由二阶低通滤波电路,小信号放大电路、单片机测量显示电路、开关稳压电源电路等组成。同时自制电机测速装置,用高频磁环作为载体,用线圈绕制磁环,利用电磁感应原理检测电机运行时的漏磁,将变化的磁场信号转化为磁环上的感应电流。用信号处理单元电路将微弱电信号转化为脉冲信号,送由单片机检测,从而达到准确测量电机的速度的要求。In this system, the sampling resistance of armature power supply circuit is connected in series to measure the speed of small DC brush motor. The system is mainly composed of second-order low-pass filter circuit, small signal amplifier circuit, single-chip measurement and display circuit, switching regulated power supply circuit and so on. At the same time, the self-made motor speed measuring device uses high frequency magnetic ring as the carrier, coil winding magnetic ring, and electromagnetic induction principle to detect the leakage of magnetic field during the operation of the motor, which converts the changed magnetic field signal into the induced current on the magnetic ring. The weak electric signal is transformed into pulse signal by signal processing unit circuit, which is sent to single chip computer for detection, so as to meet the requirement of accurate measurement of motor speed.
标签： 直流电动机
上传时间： 2022-03-26
上传用户：
以仓库智能改造为背景,主要介绍单片机和上位机之间通信网络和通信协议的选择,MODBUS协议通信指令和功能码使用,重点阐述了基于RS-485总线的MODBUS通信协议在上位机和单片机之间的串行通信,实现上位机对单片机设备的远程控制和信息采集的功能。Based on the intelligent warehouse transformation as the background,mainly introduces between MCU and PC communication network and the choice of communication protocol,instruction and the function code using the MODBUS protocol communication,expounds the MODBUS communication protocol based on RS-485 bus serial communication between PC and single chip microcomputer,PC remote control of single chip computer equipment and the function of information collection.
上传时间： 2022-03-26
上传用户：
近年来反季节种植已成火热趋势,温室大棚的普及十分迅速,而温室大棚对自动化、智能化的要求也越来越迫切,本系统将温室大棚的温湿度、二氧化碳浓度各个方面的检测,通风、浇灌、温度、喷洒农药等各个方面的控制进行综合系统研究,实现温室大棚对自动化、智能化的要求。这一系统是基于单片机控制的智能检测,控制系统包含单片机主控模块、感应检测模块、传感模块,显示、控制模块等[1]。从而提高温室大棚的种植效率,减少劳动力,提高利润等。In recent years,counter-season planting has become a hot trend featuring the rapid popularization of greenhouse and urgent requirement for the automation and intellectualization of greenhouse.This paper offers a comprehensive and systematic study of the monitoring of temperature,humidity and carbon dioxide concentration in the greenhouse and the control of ventilation,irrigation,temperature and pesticide spraying in order to achieve automation and intellectualization in greenhouse.This system is based on the intelligent detection controlled by single chip computer with the control system including the main control module,induction detection module,sensing module,display and control module of single chip computer,which is effective in improving planting efficiency of greenhouse,reducing labor force and increasing profits.
上传时间： 2022-03-27
上传用户：
以AT89S52单片机为控制核心,采用电容降压技术,Buck电路拓扑,PWM驱动模块和功率器件散热设计,通过高速的数据采集、主功率输入输出模块和控制模块,设计一种新型智能车载充电器.在充电过程中,通过负脉冲瞬间放电实现对铅酸蓄电池的再生修复,提高电池的有效容量,延长使用寿命.该充电器体积小、速度快、效率高、可靠性好.With AT89S52 single chip computer as the control core,a new type of intelligent car-carried charger was designed by using capacitance step-down technology,Buck circuit topology,PWM driving module and power device heat dissipation design,through high-speed data acquisition,main power input and output module and control module.In the charging process,the regeneration and repair of lead-acid batteries are realized by instantaneous discharge of negative pulse,which improves the effective capacity of batteries and prolongs their service life.The charger has the advantages of small size,fast speed,high efficiency and good reliability.
标签： 车载充电器
上传时间： 2022-03-27
上传用户：
Algebra, Topology, Differential Calculus, and Optimization Theory For Computer Science and Machine Learning一本数学大全书，由Jean Gallier and Jocelyn Quaintance合著。
上传时间： 2022-05-05
上传用户：默默
基于TMS320F28335的超声波流量计硬件原理图+软件源码本文以TMS320F28335 处理器为核心，设计一种用于管道流量测量的超声波流量计。系统硬件由核心板，超声波发射和接收电路，切换电路，超声换能器，基于ADS805 的高速信号采集电路，人机交互以及电源等模块构成。采用时差法进行管道流量测量，时差测量采用SCOT 加权的广义互相关时延估计算法。本论文设计的超声波流量计具有测量速度快、准确性好、成本低等优点。关键字：C2000，超声波，流量，广义互相关算法AbstractA kind of ultrasonic flowmeter using for the pipe flow measurement is designed based onTMS320F28335 in this paper. The system hardware consists of the following parts: the core board,ultrasonic signal transmitter and receiver circuits, switch circuit, ultrasonic transducer, signalacquisition circuit based on ADS805, human-computer interaction module and power supplymodule, etc. The system use the method of time difference for pipeline flow measurement and thetime difference is calculated by the time-delay algorithm of SCOT weighted generalizedcross-correlation. The ultrasonic flowmeter has the features of high testing speed, high precisionand low cost, etc.Keywords: C2000,Ultrasonic, Flow, Generalized Cross-Correlation Algorithm
标签： tms320f28335 超声波流量计
上传时间： 2022-05-06
上传用户：
以STM32F103C8T6为核心,设计了无刷直流电机控制器硬件电路。电路主要包括IR2310构成的PWM驱动电路、IRF3808构成的逆变电路、增量式旋转编码构成的速度反馈电路。控制器具有CAN和RS232通信接口,可与计算机或PLC构成速度或位置伺服系统。利用由xPC目标搭建的半实物仿真平台对PI参数进行整定。测试了控制器的速度伺服响应性能,给定速度为2400rpm时,控制器响应时间为0.32s。实验结果表明,系统工作可靠,稳定性好,响应速度快,可以满足上肢康复机器人的机械臂速度控制性能要求。The hardware circuit of Brushless DC motor controller is designed by taking STM32F103C8T6 as the core,which mainly includes PWM driving circuits made up of IR2310,inverter circuit formed by IRF3808,speed feedback circuit composed of incremental rotary encoder and so on.Speed servo control system or position servo control system can be composed of BLDM controller with computer or PLC through CAN communication interface or RS232 serial communication interface.By using the hardware in the loop simulation platform built by xPC target,the PI parameters are set up.The Speed servo response performance of the controller is tested.When the speed is 2 400 rpm,the response time of the controller is 0...
上传时间： 2022-05-07
上传用户：
