虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

binary-state

  • 原始数据以Kiwi格式存储在GTBL.dat的二进制文件中

    原始数据以Kiwi格式存储在GTBL.dat的二进制文件中,具体的文件格式请参照ReveseTableFormat.xls 中的“逆引表格式”sheet.-this procedure is the function of the navigation data of the road data collation, analysis. Kiwi to the original data stored in the format of the binary file GTBL.dat, specific file format ReveseTableFormat.xls Please refer to the "reverse primer format" sheet.

    标签: Kiwi GTBL dat 数据

    上传时间: 2014-11-26

    上传用户:qweqweqwe

  • 同步DMX512 简介和控制器的设计 在灯具调光和控制中

    同步DMX512 简介和控制器的设计 在灯具调光和控制中,人们大量采用了DMX512 的控制协议,它是由美国剧 场技术协会(United State Institute for Theatre Technology,Inc)于1986 年8 月提出的一个能在一对线上传送512 路可控硅调光亮度信息的标准. DMX512 通信方式是采用了异步通信格式,每个调光点由11 位组成,其中一个 是起始位,8 位调光数据,两个停止位.每一次传输能512 个调光点.

    标签: DMX 512 控制器 控制

    上传时间: 2014-01-20

    上传用户:gonuiln

  • 自适应turbo码OFDM的研究论文。国外硕士论文

    自适应turbo码OFDM的研究论文。国外硕士论文,对OFDM研究者有一定的参考作用。-- adaptive turbo-coded OFDM, Thesis submitted to the Faculty of the Virginia Polytechnic Institute and State university in partial fulfillment of the requirements for the degree of Master of Science in Electrical Engineering.

    标签: turbo OFDM 论文 硕士

    上传时间: 2013-12-09

    上传用户:784533221

  • The ADC0803 family is a series of three CMOS 8-bit successive approximation A/D converters using a

    The ADC0803 family is a series of three CMOS 8-bit successive approximation A/D converters using a resistive ladder and capacitive array together with an auto-zero comparator. These converters are designed to operate with microprocessor-controlled buses using a minimum of external circuitry. The 3-State output data lines can be connected directly to the data bus.

    标签: approximation converters successive family

    上传时间: 2016-11-20

    上传用户:libenshu01

  • rc5的decryption

    rc5的decryption,同样带state machine,同样有四个状态

    标签: decryption rc5

    上传时间: 2016-11-22

    上传用户:llandlu

  • This demo shows the BER performance of linear, decision feedback (DFE), and maximum likelihood seque

    This demo shows the BER performance of linear, decision feedback (DFE), and maximum likelihood sequence estimation (MLSE) equalizers when operating in a static channel with a deep null. The MLSE equalizer is invoked first with perfect channel knowledge, then with an imperfect, although straightforward, channel estimation algorithm. The BER results are determined through Monte Carlo simulation. The demo shows how to use these equalizers seamlessly across multiple blocks of data, where equalizer state must be maintained between data blocks.

    标签: performance likelihood decision feedback

    上传时间: 2013-11-25

    上传用户:1079836864

  • model OF the OFDM communication in simulink. And I was successful in completing it using a Bernoulli

    model OF the OFDM communication in simulink. And I was successful in completing it using a Bernoulli binary generator as the input source (Basic_OFDM.mdl).

    标签: communication completing successful Bernoulli

    上传时间: 2014-01-10

    上传用户:13188549192

  • The VGA example generates a 320x240 diffusion-limited-aggregation (DLA) on Altera DE2 board. A DLA i

    The VGA example generates a 320x240 diffusion-limited-aggregation (DLA) on Altera DE2 board. A DLA is a clump formed by sticky particles adhering to an existing structure. In this design, we start with one pixel at the center of the screen and allow a random walker to bounce around the screen until it hits the pixel at the center. It then sticks and a new walker is started randomly at one of the 4 corners of the screen. The random number generators for x and y steps are XOR feedback shift registers (see also Hamblen, Appendix A). The VGA driver, PLL, and reset controller from the DE2 CDROM are necessary to compile this example. Note that you must push KEY0 to start the state machine.

    标签: diffusion-limited-aggregation DLA generates 320x240

    上传时间: 2014-01-16

    上传用户:225588

  • Flex chip implementation File: UP2FLEX JTAG jumper settings: down, down, up, up Input: Reset -

    Flex chip implementation File: UP2FLEX JTAG jumper settings: down, down, up, up Input: Reset - FLEX_PB1 Input n - FLEX_SW switches 1 to 8 Output: Countdown - two 7-segment LEDs. Done light - decimal point on Digit1. Operation: Setup the binary input n number. Press the Reset switch. See the countdown from n down to 0 on the 7-segment LEDs. Done light lit when program terminates.

    标签: down implementation settings UP2FLEX

    上传时间: 2014-01-21

    上传用户:sclyutian

  • 基于8051的网络远程控制系统 本项目通过网络实现远程监控

    基于8051的网络远程控制系统 本项目通过网络实现远程监控,远程的电脑具有固定IP,在远程电脑的COM1的串行传输端口接一块8051控制板,然后以RS-232传输方式传输数据到8051的电路板,8051控制板上采用固态继电器(Solid State Relay)连接到电子产品,从而可以远程控制这些电子产品何时开启或关闭。8051控制板上还可以每分钟测量一次当前温度,再传输到远程监控端。

    标签: 8051 网络远程 控制系统 网络

    上传时间: 2016-12-21

    上传用户:凌云御清风