因为PCIE 3.0信号的速率可以达到8Gb/s，而且链路通道走线也可能会很长，这可能会导致高速信号衰减过大，在接收端无法得到张开的眼图。因此在PCIE 3.0的Tx和Rx端均使用了均衡设置，以补偿长链路时高速信号的衰减。
上传时间： 2013-10-27
上传用户：894448095
The following Philips LPC2k CAN examples in this directory were provided by ESAcademy. LPC2_CANAll_V110: Receives all CAN messages in a receive queue. LPC2_CANFull_V110: Uses Full-CAN-like reception filtering. LPC2_CANBlinky_V130: Minimal example of MicroCANopen, uses Full-CAN-like reception filtering and implements both Rx and Tx Interrupt Service Routines.
标签： ESAcademy following directory examples
上传时间： 2015-04-25
上传用户：hasan2015
The following Philips LPC2k CAN examples in this directory were provided by ESAcademy. LPC2_CANAll_V110: Receives all CAN messages in a receive queue. LPC2_CANFull_V110: Uses Full-CAN-like reception filtering. LPC2_CANBlinky_V130: Minimal example of MicroCANopen, uses Full-CAN-like reception filtering and implements both Rx and Tx Interrupt Service Routines.
标签： ESAcademy following directory examples
上传时间： 2013-12-13
上传用户：牛津鞋
The following Philips LPC2k CAN examples in this directory were provided by ESAcademy. LPC2_CANAll_V110: Receives all CAN messages in a receive queue. LPC2_CANFull_V110: Uses Full-CAN-like reception filtering. LPC2_CANBlinky_V130: Minimal example of MicroCANopen, uses Full-CAN-like reception filtering and implements both Rx and Tx Interrupt Service Routines.
标签： ESAcademy following directory examples
上传时间： 2014-01-06
上传用户：zukfu
《数据结构(C语言版)》（清华）一书的配书光盘，作为数据结构课程的辅助学习工具。包括数据结构算法演示系统（Windows版）β测试版，数据结构算法演示系统（C语言描述）V3.1C中文版，光盘使用说明
上传时间： 2014-01-23
上传用户：1966640071
温度的动态显示，采用数字显示，含有液晶lcd1602，可以精确到0.1c，而且程序经过了测试
上传时间： 2013-12-14
上传用户：xyipie
A system simulation environment in Matlab/Simulink of RFID is constructed in this paper. Special attention is emphasized on the analog/RF circuit.Negative effects are concerned in the system model,such as phase noise of the local oscillator,TX-RX coupling,reflection of the environment, AWGN noise,DC offset,I/Q mismatch,etc.Performance of the whole system can be evaluated by changing the coding method,parameters of building blocks,and operation distance.Finally,some simulation results are presented in this paper.
标签： environment constructed simulation Simulink
上传时间： 2014-01-09
上传用户：zhangliming420
C52单片机控制1602液晶显示程序，可在第一行显示字符"TX-1B MCU"，在第二行显示字符"WWW.TXMCU.COM"。
上传时间： 2013-12-08
上传用户：kbnswdifs
smsc911x 网卡驱动 This the users/programmers guide for the LAN911x Linux Driver The following sections can be found below * Revision History * Files * Features * Driver Parameters * Rx Performance Tuning * Tested Platforms * Rx Code Path * Tx Code Path * Platform Interface Descriptions
标签： 911x programmers 911 following
上传时间： 2014-12-02
上传用户：sssl
基于OFDM的无线宽带系统仿真It contains mainly two parts, i.e. link-level simulator and system-level simulator. Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation. System-level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate.
标签： simulator i.e. system-level link-level
上传时间： 2016-03-15
上传用户：xsnjzljj
