The code is for Auxiliary IO module which supports 16 inputs and 16 Outputs and Modbus protocol
标签： Auxiliary and supports protocol
上传时间： 2017-07-21
上传用户：wang0123456789
19.2 Mbps 4x4 BLAST&MIMO detector with soft ML Outputs。纯英文论文，外国文献
上传时间： 2015-04-21
上传用户：asdf20
英文描述： BCD to 7-Segment Decoder/Driver with Open-Collector Outputs 中文描述： BCD码到7段解码器/驱动器，集电极开路输出
上传时间： 2013-07-14
上传用户：m62383408
英文描述： BCD-to-Seven-Segment Decoder Driver(Internal Pull-up Outputs) 中文描述： BCD码到七段解码器驱动程序（内部上拉输出）
上传时间： 2013-07-13
上传用户：cc1015285075
英文描述： Dual Negative-Edge-Triggered Master-Slave J-K Flip-Flops with Clear and Complementary Outputs 中文描述： 双下降沿触发主从JK触发器明确和互补输出
上传时间： 2013-04-24
上传用户：黄华强
Precision 16-bit analog Outputs with softwareconfigurableoutput ranges are often needed in industrialprocess control equipment, analytical and scientificinstruments and automatic test equipment. In the past,designing a universal output module was a daunting taskand the cost and PCB real estate associated with thisfunction were problematic, if not prohibitive.
上传时间： 2014-12-23
上传用户：如果你也听说
Recent advances in low voltage silicon germaniumand BiCMOS processes have allowed the design andproduction of very high speed amplifi ers. Because theprocesses are low voltage, most of the amplifi er designshave incorporated differential inputs and Outputs to regainand maximize total output signal swing. Since many lowvoltageapplications are single-ended, the questions arise,“How can I use a differential I/O amplifi er in a single-endedapplication?” and “What are the implications of suchuse?” This Design Note addresses some of the practicalimplications and demonstrates specifi c single-endedapplications using the 3GHz gain-bandwidth LTC6406differential I/O amplifi er.
上传时间： 2013-11-23
上传用户：rocketrevenge
Control systems are becoming increasingly dependent on digital processing and so require sensors able to provide direct digital inputs. Sensors based on time measurement, having Outputs based on a frequency or phase, have an advantage over conventional analogue sensors in that their Outputs can be measured directly in digital systems by pulse counting.
上传时间： 2013-10-08
上传用户：wuyuying
在Protel2004中进行PCB的完备的CAM输出。首先，我们可以输出的gerber文件， 操作如下：1：画好PCB后，在PCB 的文件环境中，左键点击File\Fabrication Outputs\Gerber Files,进入Gerber setup 界面
上传时间： 2013-10-14
上传用户：aeiouetla
Many telecommunications and computing applicationsneed high effi ciency step-down DC/DC converters thatcan operate from a very low input voltage. The highoutput power synchronous controller LT3740 is idealfor these applications, converting input supplies rangingfrom 2.2V to 22V to Outputs as low as 0.8V with loadcurrents from 2A to 20A. Applications include distributedpower systems, point-of-load regulation and conversionof logic supplies.
上传时间： 2013-11-05
上传用户：zhf01y
