This document explains the pulse compression technique. Why it is required and how can it be used effectively. The pulse compression technique helps to increase the maximum range without sacrificing the range resolution and still the power requirement remains low.
标签： compression technique document explains
上传时间： 2013-12-18
上传用户：fnhhs
a carrier sense multiple access with collision avoidance (CSMA/CA) based MAC protocol, called nanoMAC, suitable for low bit-rate, low-power wireless devices with high efficiency
标签： avoidance collision multiple protocol
上传时间： 2017-08-28
上传用户：小宝爱考拉
This manual describes SAMSUNG s S3C2410X 16/32-bit RISC microprocessor. This product is designed to provide hand-held devices and general applications with cost-effective, low-power, and high-performance microcontroller solution in small die size. To reduce total system cost, the S3C2410X includes the following components separate 16KB Instruction and 16KB Data Cache, MMU to handle virtual memory management, LCD Controller (STN & TFT), NAND Flash Boot Loader, System Manager (chip select logic and SDRAM Controller), 3-ch UART, 4-ch DMA, 4-ch Timers with PWM, I/O Ports, RTC, 8-ch 10-bit ADC and Touch Screen Interface, IIC-BUS Interface, IIS-BUS Interface, USB Host, USB Device, SD Host & Multi-Media Card Interface, 2-ch SPI and PLL for clock generation.
标签： This microprocessor describes S3C2410X
上传时间： 2014-01-11
上传用户：shizhanincc
AM26C31CLow Power, I CC = 100 ƒ ⊂ A Typ Operate From a Single 5-V Supply High Speed, t PLH = t PHL = 7 ns Typ Low Pulse Distortion, t sk(p) = 0.5 ns Typ High Output Impedance in Power-Off Conditions Improved Replacement for AM26LS31
标签： Operate Single Supply Power
上传时间： 2014-01-20
上传用户：gtzj
Supplemental information for a high-speed serial bus that integrates well with most IEEE standard 32-bit and 64-bit parallel buses is specified. It is intended to extend the usefulness of a low-cost interconnect between external peripherals, IEEE Std 1394-1995. This standard follows the ISO/IEC 13213:1994 Command and Status Register (CSR) architecture.
标签： Supplemental information high-speed integrates
上传时间： 2014-03-07
上传用户：jjj0202
Behavioral models are used in games and computer graphics for realistic simulation of massive crowds. In this paper, we present a GPU based implementation of Reynolds [1987] algorithm for simulating flocks of birds and propose an extension to consider environment self occlusion. We performed several experiments and the results showed that the proposed approach runs up to three times faster than the original algorithm when simulating high density crowds, without compromising significantly the original crowd behavior.
标签： Behavioral simulation realistic computer
上传时间： 2017-09-08
上传用户：hanli8870
The STi7200 is a new generation, high-definition set-top box/DVD decoder chip, and provides very high performance for low-cost HD systems. With enhanced performance over the STx7109, it includes both Windows Media Video 9 and H.264 video decoders for new, low bitrate applications. The STi7200 is able to decode two HD programs
标签： high-definition generation provides decoder
上传时间： 2013-11-29
上传用户：xg262122
These codes require an ASCII input file called input.dat of the following form: Lower Limit on x Upper Limit on x Final Time Pressure for x<0 when t=0 Density for x<0 when t=0 Speed for x<0 when t=0 Pressure for x>0 when t=0 Density for x>0 when t=0 Speed for x>0 when t=0 These codes produce 8 ASCII output files: density.out. Density vs. x entropy.out. Entropy vs. x mach.out. Mach number vs. x massflux.out. Mass flux vs. x pressure.out. Pressure vs. x sound.out. Speed-of-sound vs. x velocity.out. Velocity vs. x waves.out. A description of the solution in terms of the three waves defined in the book (+,-,0).
标签： input following require called
上传时间： 2017-09-21
上传用户：希酱大魔王
LVDS：Low Voltage Differential Signaling，低电压差分信号。 LVDS传输支持速率一般在155Mbps（大约为77MHZ）以上。
标签： 差分信号
上传时间： 2015-03-04
上传用户：初夏浅浅时光
The TJA1040 is an advanced high speed CAN transceiver for use in automotive and general industrial applications. It supports the differential bus signal representation described in the international standard for in-vehicle high speed CAN applications (ISO11898). CAN (Controller Area Network) is the standard protocol for serial in-vehicle bus communication, particularly for Engine Management and Body Multiplexing. The TJA1040 provides a Standby mode, as known from its functional predecessors PCA82C250 and PCA82C251, but with significantly reduced power consumption. Besides the excellent low-power behavior the TJA1040 offers several valuable system improvements. Highlights are the absolute passive bus behavior if the device is unpowered as well as the excellent EMC performance.
标签： CAN
上传时间： 2015-03-23
上传用户：Yuan Lo
