The PCA9518 is a BiCMOS integrated circuit intended forapplication in I2C and SMBus systems.While retaining all the operating modes and features of the I2Csystem, it permits extension of the I2C-bus by buffering both thedata (SDA) and the clock (SCL) Lines, thus enabling virtuallyunlimited buses of 400 pF.
标签： Expandable 5channel 9518 PCA
上传时间： 2013-10-23
上传用户：dumplin9
The PCA9519 is a 4-channel level translating I2C-bus/SMBus repeater that enables theprocessor low voltage 2-wire serial bus to interface with standard I2C-bus or SMBus I/O.While retaining all the operating modes and features of the I2C-bus system during thelevel shifts, it also permits extension of the I2C-bus by providing bidirectional buffering forboth the data (SDA) and the clock (SCL) Lines, thus enabling the I2C-bus or SMBusmaximum capacitance of 400 pF on the higher voltage side. The SDA and SCL pins areover-voltage tolerant and are high-impedance when the PCA9519 is unpowered.
标签： 4channel transla level 9519
上传时间： 2013-11-19
上传用户：jisiwole
The MC68HC05K0 is a low cost, low pin countsingle chip microcomputer with 504 bytes of userROM and 32 bytes of RAM. The MC68HC05K0 isa member of the 68HC05K series of devices whichare available in 16-pin DIL or SOIC packages.It uses the same CPU as the other devices in the68HC05 family and has the same instructions andregisters. Additionally, the device has a 15-stagemulti-function timer and 10 general purposebi-directional I/0 Lines. A mask option is availablefor software programmable pull-downs on all ofthe I/O pins and four of the pins are capable ofgenerating interrupts.The device is ideally suited for remote-controlkeyboard applications because the pull-downs andthe interrupt drivers on the port pins allowkeyboards to be built without any externalcomponents except the keys themselves. There isno need for external pull-up or pull-down resistors,or diodes for wired-OR interrupts, as these featuresare already designed into the device.
上传时间： 2014-01-24
上传用户：zl5712176
The 87C576 includes two separate methods of programming theEPROM array, the traditional modified Quick-Pulse method, and anew On-Board Programming technique (OBP).Quick Pulse programming is a method using a number of devicepins in parallel (see Figure 1) and is the traditional way in which87C51 family members have been programmed. The Quick-Pulsemethod supports the following programming functions:– program USER EPROM– verify USER EPROM– program KEY EPROM– program security bits– verify security bits– read signature bytesThe Quick-Pulse method is quite easily suited to standardprogramming equipment as evidenced by the numerous vendors of87C51 compatible programmers on the market today. Onedisadvantage is that this method is not well suited to programming inthe embedded application because of the large number of signalLines that must be isolated from the application. In addition, parallelsignals from a programmer would need to be cabled to theapplication’s circuit board, or the application circuit board wouldneed to have logic built-in to perform the programming functions.These requirements have generally made in-circuit programmingusing the modified Quick Pulse method impractical in almost all87C51 family applications.
上传时间： 2013-10-21
上传用户：xiaozhiqban
C++在几乎所有的计算环境中都非常普及，而且可以用于几乎所有的应用程序。C++从C中继承了过程化编程的高效性，并集成了面向对象编程的功能。C++在其标准库中提供了大量的功能。有许多商业C++库支持数量众多的操作系统环境和专业应用程序。但因为它的内容太多了，所以掌握C++并不十分容易。本书详述了C++语言的各个方面，包括数据类型、程序控制、函数、指针、调试、类、重载、继承、多态性、模板、异常和输入输出等内容。每一章都以前述内容为基础，每个关键点都用具体的示例进行详细的讲解。本书基本不需要读者具备任何C++知识，书中包含了理解C++的所有必要知识，读者可以从头开始编写自己的C++程序。本书也适合于具备另一种语言编程经验但希望全面掌握C++语言的读者。 I created all the files under Microsoft Windows so Lines are terminated by CR/LF. In addition to this "ReadMe" file you will find three zip archives in the primary archive, so you need to unzip each of these to get at the code. 为PDG格式,这有pdg阅读器下载|pdg文件阅读器下载
标签： 源代码
上传时间： 2013-11-18
上传用户：gaoqinwu
第一章 传输线理论一 传输线原理二 微带传输线三 微带传输线之不连续分析第二章 被动组件之电感设计与分析一 电感原理二 电感结构与分析三 电感设计与模拟四 电感分析与量测传输线理论与传统电路学之最大不同，主要在于组件之尺寸与传导电波之波长的比值。当组件尺寸远小于传输线之电波波长时，传统的电路学理论才可以使用，一般以传输波长（Guide wavelength）的二十分之ㄧ（λ/20）为最大尺寸，称为集总组件（Lumped elements）；反之，若组件的尺寸接近传输波长，由于组件上不同位置之电压或电流的大小与相位均可能不相同，因而称为散布式组件（Distributed elements）。 由于通讯应用的频率越来越高，相对的传输波长也越来越小，要使电路之设计完全由集总组件所构成变得越来越难以实现，因此，运用散布式组件设计电路也成为无法避免的选择。 当然，科技的进步已经使得集总组件的制作变得越来越小，例如运用半导体制程、高介电材质之低温共烧陶瓷（LTCC）、微机电（MicroElectroMechanical Systems, MEMS）等技术制作集总组件，然而，其中电路之分析与设计能不乏运用到散布式传输线的理论，如微带线（Microstrip Lines）、夹心带线（Strip Lines）等的理论。因此，本章以讨论散布式传输线的理论开始，进而以微带传输线为例介绍其理论与公式，并讨论微带传输线之各种不连续之电路，以作为后续章节之被动组件的运用。
标签： 传输线
上传时间： 2013-11-10
上传用户：潇湘书客
Calculation of the Differential Impedance of Tracks on FR4 substrates There is a discrepancy between calculated and measured values of impedance for differential transmission Lineson FR4. This is especially noticeable in the case of surface microstrip configurations. The anomaly is shown tobe due to the nature of the substrate material. This needs to be considered as a layered structure of epoxy resinand glass fibre. Calculations, using Boundary Element field methods, show that the distribution of the electricfield within this layered structure determines the apparent dielectric constant and therefore affects theimpedance. Thus FR4 cannot be considered to be uniform dielectric when calculating differential impedance.
上传时间： 2013-10-18
上传用户：masochism
给出了一种运动人体区域的检测及其对应的二维关键点的提取方法。首先运用帧差法构建一个自适应的背景模型以达到背景初始化和背景更新的目的。接着用减背景法实现二维运动人体区域的检测。最后将检测到的运动人体区域，通过运用APAR（anti-paralle Lines）区域法实现对运动人体关键点的提取。
上传时间： 2013-10-25
上传用户：lz4v4
The high defi nition multimedia interface (HDMI) is fastbecoming the de facto standard for passing digitalaudio and video data in home entertainment systems.This standard includes an I2C type bus called a displaydata channel (DDC) that is used to pass extended digitalinterface data (EDID) from the sinkdevice (such as adigital TV) to the source device (such as a digital A/Vreceiver). EDID includes vital information on the digitaldata formats that the sink device can accept. The HDMIspecifi cation requires that devices have less than 50pFof input capacitance on their DDC bus Lines, which canbe very diffi cult to meet. The LTC®4300A’s capacitancebuffering feature allows devices to pass the HDMI DDCinput capacitance compliance test with ease.
上传时间： 2013-11-21
上传用户：tian126vip
Tug of War(A tug of war is to be arranged at the local office picnic. For the tug of war, the picnickers must be divided into two teams. Each person must be on one team or the other the number of people on the two teams must not differ by more than 1 the total weight of the people on each team should be as nearly equal as possible. The first line of input contains n the number of people at the picnic. n Lines follow. The first line gives the weight of person 1 the second the weight of person 2 and so on. Each weight is an integer between 1 and 450. There are at most 100 people at the picnic. Your output will be a single line containing 2 numbers: the total weight of the people on one team, and the total weight of the people on the other team. If these numbers differ, give the lesser first. )
上传时间： 2014-01-07
上传用户：离殇
