Rayleigh Fading Channels in Mobile Digital Communication Systems Part II: Mitigation Bibles for Fading Models
标签： Communication Mitigation Rayleigh Channels
上传时间： 2017-07-24
上传用户：zhangjinzj
Interference generator for MSP430 experimenter´ s board and CC1101 transceiver. It´ s useful to check Frecuency Agility
标签： acute Interference experimenter transceiver
上传时间： 2017-08-06
上传用户：sammi
In this book, we study the interference cancellation and detection problem in multiantenna multi-user scenario using precoders. The goal is to utilize multiple antennas to cancel the interference without sacrificing the diversity or the com- plexity of the system.
标签： Cancellation6 Interference
上传时间： 2020-05-27
上传用户：shancjb
由于能源危机和环境污染，世界各国均在投巨资发展电动汽车。燃料电池电动汽车成为电动汽车发展的“热点”。大功率DC/DC变换器能够改善燃料电池的输出特性，是燃料电池轿车动力系统中关键的零部件。然而它作为一种BUCK形式的开关电源，主电路是很强的电磁干扰源，产生的干扰可能通过电源线进入到控制电路板，同时控制电路部分也要用小功率的开关电源进行稳压，因此也可能产生开关噪声经电源线向外传输。因此就必须在控制电路输入端设计电磁干扰(Electromagnetic Interference，EMI)滤波器进行传导干扰的抑制。 本论文首先讨论了DC/DC变换器的工作原理，分析了变换器产生传导干扰从而影响控制电路正常工作的原因。 其次全面、系统地阐述了EMI滤波器的相关理论，包括阻抗失配原则、人工电源网络、滤波网络、插入损耗等重要概念。接着研究了滤波元件的选取原则，并针对关键点之一—高频性能展开了分析，借助仿真观察了元件寄生参数的影响，提出了改善滤波器高频性能的部分方法。 随后介绍了滤波器的设计方法，除了介绍通用的设计方法外，着重分析了滤波器设计中的另一个关键点—噪声源阻抗的影响、测量及估算，并在此基础上系统地形成了基于源阻抗的设计方法，同时也考虑了滤波器与开关电源连接时可能出现的系统不稳定性问题，通过仿真分析提出解决方案。 然后阐述了EMI滤波器在工程应用中的各种注意事项。 最后结合DC/DC变换器控制电路的实际干扰情况，设计了EMI滤波器，使控制电路电源输入端的传导干扰基本下降到相关电磁兼容标准(CISPR25)的三级限值以下。
上传时间： 2013-06-15
上传用户：superhand
在无线通信系统中,信号在传输过程中由于多径效应和信道带宽的有限性以及信道特性的不完善性导致不可避免地产生码间串扰(Intersymbol Interference).为了克服码间串扰所带来的信号畸变,则必须在接收端增加均衡器,以补偿信道特性,正确恢复发送序列.盲均衡器由于不需要训练序列,仅利用接收信号的统计特性就能对信道特性进行均衡,消除码间串扰,成为近年来通信领域研究的热点课题.本课题采用已经取得了很多研究成果的Bussgang类盲均衡算法,主要因为它的计算复杂度小,便于实时实现,具有较好的性能.本文探讨了以FPGA(Field Programmable Gates Array)为平台,使用Verilog HDL(Hardware Description Language)语言设计并实现基于Bussgang类型算法的盲均衡器的硬件系统.本文简要介绍了Bussgang类型盲均衡算法中的判决引导LMS(DDLMS)和常模(CMA)两种算法和FPGA设计流程.并详细阐述了基于FPGA的信道盲均衡器的设计思想、设计结构和Verilog设计实现,以及分别给出了各个模块的结构框图以及验证结果.本课题所设计和实现的信道盲均衡器,为电子设计自动化(EDA)技术做了有益的探索性尝试,对今后无线通信系统中的单芯片可编程系统(SOPC)的设计运用有着积极的借鉴意义.
上传时间： 2013-07-25
上传用户：cuibaigao
Abstract: Alexander Graham Bell patented twisted pair wires in 1881. We still use them today because they work so well. In addition we have the advantage ofincredible computer power within our world. Circuit simulators and filter design programs are available for little or no cost. We combine the twisted pair and lowpassfilters to produce spectacular rejection of radio frequency interference (RFI) and electromagnetic interference (EMI). We also illustrate use of a precision resistorarray to produce a customizable differential amplifier. The precision resistors set the gain and common mode rejection ratios, while we choose the frequencyresponse.
上传时间： 2014-11-26
上传用户：Vici
Abstract: Class D amplifiers are typically very efficient, making them ideal candidates for portable applications that require longbattery life and low thermal dissipation. However, electromagnetic interference (EMI) is an issue that commonly accompanies theClass D switching topology. Active-emissions limiting reduces radiated emissions and enables "filterless" operation, allowingdesigners to create small, efficient portable applications with low EMI.
上传时间： 2013-11-23
上传用户：哈哈hah
设计了水声信号发生系统中的功率放大电路，可将前级电路产生的方波信号转换为正弦信号，同时进行滤波、功率放大，使其满足换能器对输入信号的要求。该电路以单片机AT89C52，集成6阶巴特沃思低通滤波芯片MF6以及大功率运算放大器LM12为核心，通过标准RS232接口与PC进行通信，实现信号增益的程控调节，对干扰信号具有良好的抑制作用。经调试该电路工作稳定正常，输出波形无失真，在输出功率以及放大增益、波纹系数等方面均满足设计要求。 This paper presented a design and implementation of underwater acoustic power amplifer. This circuit converted the rectangle signal generated by frontend circuit into the sine signal， then filtered and power amplification， it meets the requirements of the transducer.Included AT89C52， 6th order Butterworth filter MF6， hipower amplififier LM12.Communication with PC through the RS232 port. The signal gain is adjustable and could be remote controlled. It has a good inhibitory effect on the interference signal. After debugged， this circuit works stable， the output waveform has no distortion， it meets the design requirement in outprt power， amplifier gain and ripple factor.
上传时间： 2013-11-20
上传用户：qwe1234
在理论分析循环码编码和译码基本原理的基础上，提出了基于单片机系统的(24，16)循环码软件实现编码、译码的方案。仿真结果表明(24，16)循环码能有效地克服来自通讯信道的干扰，保证数据通信的可靠及系统的稳定，使误码率大幅度降低。本论文对(24，16)循环码的研究结果表明，可以有效地降低错误概率和提高系统的吞吐量，实现纠错仅需要在接收端增加有限的存储空间和计算复杂度，具有一定的实用价值。 Abstract: Based on analyzing the theory of encoding and decoding of cyclic code， this paper showed the schemes of encoding and decoding of(24，16)cyclic code by the software and based on microcontroller. Simulation results show that using (24，16) cyclic codes can effectively overcome the interference from communication channel， ensure the reliability and stability of data communication systems， and reduce the bit error rate greatly. The results of this paper show that by using the (24，16) cyclic code， the error rate can be reduced and the system throughput can be improved. Meanwhile， the system only needs to enlarge limited storage space and computation the complexity at the receiving end to realize error correction. Thus the (24，16) cyclic code has a practical value.
上传时间： 2013-11-09
上传用户：gaoliangncepu
针对盘山路存在的转弯盲区，即在转弯时司机无法得知弯路对面是否有车辆通过，设计一种基于C8051F310的山路转弯预防警示系统。该系统利用一阶滤波算法检测山路转弯时是否有车辆通过。运用该算法可增强系统检测的实时性，提高检测机动车辆的灵敏度，同时大大减少环境温度对检测的干扰。试验表明该系统能够正确指示出在山路转弯时是否有车辆通过，目前该系统已安装在盘山路上，可大大减少事故的发生率。 Abstract: Aiming at passing hilly road，there is a turn blind spot.Motormen usually do not know if the passing of vehicles pass the road.So a system of defending accident on hilly road is designed,which is based on MCU C8051F310.The sys-tem uses the first-order filter algorithm to detect whether there are passing vehicles.This algorithm enhances the real-time detection and improves the sensitivity of detection vehicles.Meanwhile,it reduces the detection interference of environmen-tal temperature.The experimental results show that this system can exactly indicate if there are passing vehicles.At present,the system has been successfully applied to hilly road.The system can greatly decrease accident.
上传时间： 2013-10-10
上传用户：归海惜雪
