实验内容： 1.利用QuartusII的"MegaWizard Plug-In Manager", 设计输入数据宽度是4bit的ADD、SUB、MULT、DIVIDE、COMPARE 把它们作为一个project,DEVICE选用EPF10K70RC240-4，对它们进行 时序仿真，将仿真波形（输入输出选用group）文件提交。 2.利用QuartusII的"MegaWizard Plug-In Manager"中的LPM_COUNTER， 设计一个20bit的up_only COUNTER, 要求该COUNTER在FE0FA和FFFFF之间自动循环计数； 分析该COUNTER在EPM7128SLC84-7、EPM7128SLC84-10、 和EPF10K70RC240-2、EPF10K70RC240-4几种芯片中的最大工作频率； 请将计数器的输出仿真波形文件提交（特别注意在0FFFFCH--0FE0FFH之间的仿真波形图）。 （仅EPF10K70RC240-4芯片,最大允许Clock频率下）。
标签： 实验
上传时间： 2016-10-18
上传用户：jack
淋浴器温度控制调节采用MAT LAB 的附加组件Simulink, 仿真系 统的框图如图1 所示。图中的虚线为模糊控制器, 作为二维模糊控制器机构以水的温度偏差temp 和 流量偏差f low 为输入量, 采用模糊推理方法对水 的温度偏差和流量偏差进行整定, 用来确定冷水阀 门和热水阀门的开口大小cold 和hot 以便控制冷 热水的流量, 构成2 输入2 输出的一阶模糊控制系 统; 模糊推理与去模糊化采用MIN - MAX 法及重 心法, 并用MA TLAB 模糊推理工具箱来编辑模糊 控制器。 图1
上传时间： 2018-10-12
上传用户：一只虫虫
Mobile telecommunications emerged as a technological marvel allowing for access to personal and other services, devices, computation and communication, in any place and at any time through effortless plug and play. This brilliant idea became possible as the result of new technologies developed in the areas of computers and communications that were made available and accessible to the user.
标签： Telecommunications Protocols Mobile
上传时间： 2020-05-30
上传用户：shancjb
Notwithstanding its infancy, wireless mesh networking (WMN) is a hot and growing field. Wireless mesh networks began in the military, but have since become of great interest for commercial use in the last decade, both in local area networks and metropolitan area networks. The attractiveness of mesh networks comes from their ability to interconnect either mobile or fixed devices with radio interfaces, to share information dynamically, or simply to extend range through multi-hopping.
上传时间： 2020-05-31
上传用户：shancjb
Notwithstanding its infancy, wireless mesh networking (WMN) is a hot and growing field. Wireless mesh networks began in the military, but have since become of great interest for commercial use in the last decade, both in local area networks and metropolitan area networks. The attractiveness of mesh networks comes from their ability to interconnect either mobile or fixed devices with radio interfaces, to share information dynamically, or simply to extend range through multi-hopping.
标签： Multi-hop Networks WiMAX WiFi Mesh LTE and
上传时间： 2020-06-01
上传用户：shancjb
在互補式金氧半(CMOS)積體電路中，隨著量產製程的演進，元件的尺寸已縮減到深次微 米(deep-submicron)階段，以增進積體電路(IC)的性能及運算速度，以及降低每顆晶片的製造 成本。但隨著元件尺寸的縮減，卻出現一些可靠度的問題。 在次微米技術中，為了克服所謂熱載子(Hot-Carrier)問題而發展出 LDD(Lightly-Doped Drain) 製程與結構; 為了降低 CMOS 元件汲極(drain)與源極(source)的寄生電阻(sheet resistance) Rs 與 Rd，而發展出 Silicide 製程; 為了降低 CMOS 元件閘級的寄生電阻 Rg，而發展出 Polycide 製 程 ; 在更進步的製程中把 Silicide 與 Polycide 一起製造，而發展出所謂 Salicide 製程
标签： Protection CMOS ESD ICs in
上传时间： 2020-06-05
上传用户：shancjb
Over many years, RF-MEMS have been a hot topic in research at the technology and device level. In particular, various kinds of mechanical Si-MEMS resonators and piezoelectric BAW (bulk acoustic wave) resonators have been developed. The BAW technology has made its way to commercial products for passive RF filters, in particular for duplexers in RF transceiver front ends for cellular communica- tions. Beyond their use in filters, micromachined resonators can also be used in conjunction with active devices in innovative circuits and architectures.
标签： MEMS-based Circuits Systems and
上传时间： 2020-06-06
上传用户：shancjb
Plug in Electric Vehicles (PEVs) use energy storages usually in the form of battery banks that are designed to be recharged using utility grid power. One category of PEVs are Electric Vehicles (EVs) without an Internal-Combustion (IC) engine where the energy stored in the battery bank is the only source of power to drive the vehicle. These are also referred to as Battery Electric Vehicles (BEVs). The second category of PEVs, which is more commercialized than the EVs, is the Plug in Hybrid Electric Vehicles (PHEVs) where the role of energy storage is to supplement the power produced by the IC engine.
标签： Electric Vehicles Smart Grids in
上传时间： 2020-06-07
上传用户：shancjb
The NCA9511 is a hot-swappable I2C bus buffer that supports I/O card insertion into a live backplane without corruption of the data and clock buses.
上传时间： 2021-01-26
上传用户：
Agilent 34401A Service Guide.pdfIEC Measurement Category II includes electrical devices connected to mains at an outlet on a branch circuit. Such devices include most small appliances, test equipment, and other devices that plug into a branch outlet or socket. The 34401A may be used to make measurements with the HI and LO inputs connected to mains in such devices, or to the branch outlet itself (up to 300 VAC). However, the 34401A may not be used with its HI and LO inputs connected to mains in permanently installed electrical devices such as the main circuit-breaker panel, sub-panel disconnect boxes, or permanently wired motors. Such devices and circuits are subject to overvoltages that may exceed the protection limits of the 34401A. Note: Voltages above 300 VAC may be measured only in circuits that are isolated from mains. However, transient overvoltages are also present on circuits that are isolated from mains. The Agilent 34401A are designed to safely withstand occasional transient overvoltages up to 2500 Vpk. Do not use this equipment to measure circuits where transient overvoltages could exceed this level. Additional Notices Waste Electrical and Electronic Equipment (WEEE) Directive 2002/96/EC This product complies with the WEEE Directive (2002/96/EC) marking requirement. The affixed product label (see below) indicates that you must not discard this electrical/electronic product in domestic household waste. Product Category: With reference to the equipment types in the WEEE directive Annex 1, this product is classified as a "Monitoring and Control instrumentation" product. Do not dispose in domestic household waste. To return unwanted products, contact your local Agilent office, or see www.agilent.com/environment/product for more information. Agilent 34138A Test Lead Set The Agilent 34401A is compatible with the Agilent 34138A Test Lead Set described below. Test Lead Ratings Test Leads - 1000V, 15A Fine Tip Probe Attachments - 300V, 3A Mini Grabber Attachment - 300V, 3A SMT Grabber Attachments - 300V, 3A Operation The Fine Tip, Mini Grabber, and SMT Grabber attachments plug onto the probe end of the Test Leads. Maintenance If any portion of the Test Lead Set is worn or damaged, do not use. Replace with a new Agilent 3413
标签： agilent
上传时间： 2022-02-20
上传用户：
