This application note discusses a variety of approaches for interfacing analog signals to 5V powered systems. Synthesizing a "rail-to-rail" op amp and scaling techniques for A/D converters are covered. A voltage-to-frequency converter, applicable where high resolution is required, is also presented.
上传时间： 2013-10-12
上传用户：181992417
ZigBee™ 是专为低速率传感器和控制网络设计的无线网络协议。有许多应用可从ZigBee 协议受益，其中可能的一些应用有：建筑自动化网络、住宅安防系统、工业控制网络、远程抄表以及PC 外设。此程序包提供的是Zigbee协义栈函数库源代码，它实现了一个与物理层 无关的应用程序接口。 因此，无需做重大修改就可以轻松地在射频（Radio Frequency，RF）收发器之间移植应用程序。
上传时间： 2014-01-16
上传用户：Pzj
Random Number Generators（随机数生成）包括gaussian random number generator、uniform random number generator、low-frequency hold generator、1/f noise generator等5种随机信号生成的c源代码
标签： generator random number Generators
上传时间： 2014-12-07
上传用户：edisonfather
频率调制，It is a diffrent matlab code for frequency modulation.
上传时间： 2015-05-30
上传用户：wanqunsheng
Routine mampres: To obtain amplitude response from h(exp(jw)). input parameters: h :n dimensioned complex array. the frequency response is stored in h(0) to h(n-1). n :the dimension of h and amp. fs :sampling frequency (Hz). iamp:If iamp=0: The Amplitude Res. amp(k)=abs(h(k)) If iamp=1: The Amplitude Res. amp(k)=20.*alog10(abs(h(k))). output parameters: amp :n dimensioned real array. the amplitude-frequency response is stored in amp(0) to amp(n-1). Note: this program will generate a data file "filename.dat" . in chapter 2
标签： dimensione parameters amplitude response
上传时间： 2013-12-19
上传用户：xfbs821
Rotating shafts experience a an elliptical motion called whirl. It is important to decompose this motion into a forward and backward whil orbits. The current function makes use of two sensors to generate a bi-directional spectrogram. The method can be extended to any time-frequency distribution ％ ％ compute the forward/backward Campbell/specgtrogram ％ ％ INPUT: ％ y (n x 2) each column is measured from a different sensor ％ /////// ％ __ ％ |s1| y(:,1) ％ |__| ％ __ ％ / \ ________|/ ％ | | | s2 |/ y(:,2) ％ \____/ --------|/ ％ ％ Fs Sampling frequnecy ％ ％ OUTPUT: ％ B spectrogram/Campbel diagram ％ x x-axis coordinate vector (time or Speed) ％ y y-axis coordinate vector (frequency [Hz])
标签： experience elliptical decompose important
上传时间： 2015-06-23
上传用户：372825274
his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run "make" from the console in echomaster and echoslave subdirs. "make program" will program the device if you have a AVRISP attached. Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST! Otherwise you wont get any clock signal to the AVR and then you can t program it or reset the fuses! The MC1319x has default clock output of 32kHz so you will have to set your programmer to a very low frequency (<=32kHz/4) to be able to program it while it is running on that!
标签： the 20060125 project WinAVR
上传时间： 2014-10-10
上传用户：yan2267246
关于FPGA流水线设计的论文 This work investigates the use of very deep pipelines for implementing circuits in FPGAs, where each pipeline stage is limited to a single FPGA logic element (LE). The architecture and VHDL design of a parameterized integer array multiplier is presented and also an IEEE 754 compliant 32-bit floating-point multiplier. We show how to write VHDL cells that implement such approach, and how the array multiplier architecture was adapted. Synthesis and simulation were performed for Altera Apex20KE devices, although the VHDL code should be portable to other devices. For this family, a 16 bit integer multiplier achieves a frequency of 266MHz, while the floating point unit reaches 235MHz, performing 235 MFLOPS in an FPGA. Additional cells are inserted to synchronize data, what imposes significant area penalties. This and other considerations to apply the technique in real designs are also addressed.
标签： investigates implementing pipelines circuits
上传时间： 2015-07-26
上传用户：CHINA526
describes the most common terms used in radarsystems, such as range, range resolution, Doppler frequency, and coherency. The second part of this chapter develops the radar range equation in many of its forms. This presentation includes the low PRF, high PRF,search, bistatic radar, and radar equation with jamming.
标签： range radarsystems resolution describes
上传时间： 2015-08-05
上传用户：宋桃子
reviews radar waveforms,including CW, pulsed, and LFM. High Range Resolution (HRR) waveforms and stepped frequency waveforms are also analyzed.
标签： waveforms Resolution including and
上传时间： 2014-01-11
上传用户：jiahao131
