介绍了一种TI公司最新推出的MSP430F247单片机，利用它自带的I2C模块驱动I2C总线的温度传感器TMP275。TMP275是一款具有高精度、低功耗的新型温度传感器。由于TMP275具有可编程功能，纤小的封装以及极大的温度范围，因而广泛应用于组建超小型温度测量装置。 Abstract: A new single chip microcomputer MSP430F247 which is released by TI is introduced.It can drive I2C interface digital temperature sensor TMP275 with I2C module.TMP275 is a new temperature sensor which has high accurate,low power. Because TMP275 has programmable function,small packages and wide temperature range,it is applied widely in very little temperature measurment equipment.
上传时间： 2013-12-06
上传用户：asdfasdfd
介绍了采用ATmega48单片机实现三相无刷直流电机控制器的方法。利用Atmega48获得带死区的脉宽调制（PWM）、霍尔传感器的换相处理、正弦驱动信号的产生和电机转速的控制等功能。采用该方法的优点是所需的外围器件少，成本低。 Abstract: The method of 3-phase brushless DC motor control based on ATmega48 is presented in this paper.The system uses ATmega48 to generate PWM signals with dead-time, hall sensors signals commutation，sine driving signal and rotational speed of motor.Using this method，the needed external devices are few, the cost is low.
上传时间： 2013-12-09
上传用户：330402686
介绍了一种基于C8051F020单片机的多路压力测量仪。该测量仪选用电阻应变式压力传感器采集压力信号，并经放大电路处理后送入C8051F020单片机，再由C8051F020单片机内部的A/D转换器将采集到的压力信号进行模数转化，然后分别对数据进行存储和显示。该测量仪能测量6路压力信号，并且各测量点都能单独检测和设置。由于采用了C8051F020单片机，简化了硬件电路，增强了抗干扰能力，使得测量仪具有测量精度高，冲击小等特点。 Abstract: A measurement apparatus for multi-channel pressure based on single chip microcomputer is introduced.It can measure 6 channels signal of the pressure，and the pressure measure points can be detection and located individually.The pressure signal sampling is obtained by resistor stress-type pressure sensors，the digital signals of 6 channels are collected through amplifying and adjustment circuit of pressure signals and internal integrated A/D converter of MCU.Finally，and it realizes the function to store and display data separately.C8051F020 was used to made hardware circuit simple，and it also enhanced the anti-interference ability.It features high precision and little impact.
上传时间： 2013-11-16
上传用户：yare
介绍一种简单射频识别系统设计。该设计包括阅读器、应答器和线圈3部分。由单片机控制阅读器向应答器发射无线信号，并接收应答器回送的信号，再通过分析回送信号识别物品。阅读器和应答器之间以半双工通信方式通信。 Abstract: A simple design of radio frequency identification system is given in this paper.The design includes reader,responder and winding.Through MCU，signals are sent to responder from reader，then corresponding signals are sent back. According to the analysis of the signals sent back，the objects can be identified.Half-duplex communication is adopted? between? reader? and? responder.
上传时间： 2013-10-11
上传用户：plsee
介绍一种采用单片机技术和基站器件EM4095的手持式低频RFID读卡器方案。首先对整个系统框架进行说明，然后介绍主要功能模块的设计，给出了各模块的原理图。重点描述了基站器件EM4095的性能参数和功能原理，最后描述了该系统的主程序流程图。 Abstract: In this paper,a handheld RFID reader based on MCU and EM4095 is introduced.At first，the configuration of this system is explained.Then the design of main modules and schematic documents are particularly presented.The parameters and principle of the chip EM4095 are introduced in detail. At last，the main software flow is given
上传时间： 2013-10-18
上传用户：windypsm
阐述了一个由上位PC机和AT89C52下位单片机组成的主从分布式温度巡回检测系统。主从机采用RS-485 串行通讯标准进行通信，可在下位单片机实现基本的温度数据巡回检测基础上，由上位PC机实现综合处理功能或扩展为远程操作。整个系统具有巡检速度快，扩展性好的特点。 Abstract: In this paper,a top PC and AT89C52 under-bit microcontrollers from the main component of the tour distributed temperature detection system is presented. Master and slave can use RS-485 serial communication standards for communications.Based on next-bit machine for basic goods temperature detected data Tour, the top can achieve the integrated treatment of PC functions or for the expansion of long-distance operation. The entire inspection system is fast, expansion.
上传时间： 2013-10-13
上传用户：zhoujunzhen
在开放式数控系统结构模型的基础上，研究了基于ISA总线的DSP通信控制原理。采用中断方式完成了PC机和DSP之间的通信。介绍了以DriverWorks为工具开发ISA设备WDM驱动程序的方法，探讨了中断处理、驱动程序与应用程序之间的通信,简要说明了驱动程序的安装与调试。通过调试,系统设计运行稳定。 Abstract: The ISA bus and DSP correspondence control principle is investigated in the basis of the existing open architecture numerical control system.The interrupt method is used to realize the communication between PC and DSP based on the ISA bus.The methods of WDM driver exploitation for ISA device using Driver Works are introduced.The main process of driver program and the keys such as handle interrupt and the communication between the drivers and application are presented.And how to debug and install the drive is explained.
上传时间： 2013-11-04
上传用户：kang1923
从系统硬件设计和软件构成上，介绍一种以AT89C52单片机为核心,通过无线遥控方法实现对预设电话自动拨号报警的智能呼救系统。系统提供了患者在紧急情况下无法使用电话报警时的一种报警手段。由用户预设的多组电话号码作为语音报警对象,预录可长达20 s的语音信号来说明患者所处地点及病情，并通知患者家人。 Abstract: This paper introduces a intelligent alarming system which is realized by wireless remote control system.This system chiefly consists of AT89C51 the system can processor.User can input several groups of telephone number regarded as alarming objects,The system can record some information 20 seconds to tell the site of the patient.And notice the rokonok of the patient.
上传时间： 2013-11-19
上传用户：wd450412225
在汽车发动机起动时，若发动机起动后起动机不能及时断电，将会烧毁起动机或损坏飞轮齿环；若变速器不在空档位置起动，则起动机的瞬间动力将使汽车位移，还可能引起交通事故和人身安全。为此介绍一种利用NXP P89LPC901单片机控制的汽车起动保护控制器，通过检测汽车起动开关、变速箱档位、发动机转速，实现对汽车发动机起动过程检测和保护。起动保护控制器在发动机起动过程中通过采用逐个关闭打开负载系统，解决汽车发动机过程中因起动电流大而对汽车电源的冲击影响,延长了电瓶寿命。 Abstract: When the automotive engine is started, the engine start motor and flywheel gear may be damaged， even traffic accidents and personal safeties may be caused by wrong operation or other factors.In order to ensure the automotive engine can be started normally and safely,it is necessary that the protecting measures and methods are considered in the automotive electrical control system.This paper introduces a kind of the automotive engine starting protect controller based on NXP P89LPC901 MCU.The controller can protect the engine starting process by detecting the starter key switch,transmission stall and engine speed.Through the use of close and open load system,the controller can solve the impact on automotive power because of the high-current load in the process of the automobile engine starting, and extend battery life.
上传时间： 2013-10-15
上传用户：mikesering
为满足矿井安全生产要求，介绍了一种以AT89C51单片机为主控器，对环境空气的温度、有毒易燃气体的浓度等进行检测的监控系统。该系统配合外围电路能实现对上述环境指标的控制并存储相关数据与上位PC机通信。它采用硬件抗干扰和软件抗干扰技术，以确保整个系统工作的准确性。 Abstract: In order to meet the needs of mine produce safety，a kind of intellignet mine ambient monotoring and control system based on AT89C51 is introduced.This system can detect the temperature of ambient of mine，the density of poisonous inflammable gas,combined external circuit.With its function part， this system can change above-mentioned elements.
上传时间： 2013-11-10
上传用户：wendy15
