为了有效地提升铅酸蓄电池的使用寿命，同时实现对充电过程的监控，设计出一种用单片机控制的36 V铅酸蓄电池充电电源。本电路采用反激式拓扑，连续电流工作模式，电源管理IC设计在电源的副边，由ELAN公司的EM78P258N单片机模拟，是用可编程器件模拟电源管理IC，实现智能电源低成本化的一次成功尝试，通过对单片机的软件设计实现了充电电源的状态显示、充电时间控制、报警、过温保护、过压保护、过流保护等功能。本充电器真正的实现了铅酸蓄电池的三段式充电过程，其最高输出功率可达90 W，效率约85%，成本不到20元，具有很高的市场竞争力。 Abstract: In order to extend the life of lead-acid battery efficiently and supervise the charging process meanwhile， a 36V lead-acid battery CHARGE powe supply controlled by microcontroller is designed. The CHARGEr is flyback switching power supply and works in CCM mode. A EM78P258N microcontroller made by ELAN microelectronics corporation is used as power management IC which is designed at the secondary circuit. The project is a successful attempt to low-cost intelligent power used microcontroller simulating power management IC. The CHARGEr also has the functions of the status reveal， CHARGE time control， alarming， thermal protect， current limit and overvoltage protect by the software design. The circuit actually implements the three-step CHARGE process， whose power is up to 90W and whose efficiency can get 85%. The net cost of this CHARGEr is less than 20 RMB， so that the CHARGEr is of powerful market competitiveness.
上传时间： 2013-11-16
上传用户：cepsypeng
The MAX3243E device consists of three line drivers, five line receivers, and a dual CHARGE-pump circuit with±15-kV ESD (HBM and IEC61000-4-2, Air-Gap DisCHARGE) and ±8-kV ESD (IEC61000-4-2, Contact DisCHARGE)protection on serial-port connection pins. The device meets the requirements of TIA/EIA-232-F and provides theelectrical interface between an asynchronous communication controller and the serial-port connector. Thiscombination of drivers and receivers matches that needed for the typical serial port used in an IBM PC/AT, orcompatible. The CHARGE pump and four small external capacitors allow operation from a single 3-V to 5.5-Vsupply. In addition, the device includes an always-active noninverting output (ROUT2B), which allowsapplications using the ring indicator to transmit data while the device is powered down. The device operates atdata signaling rates up to 250 kbit/s and a maximum of 30-V/ms driver output slew rate.
标签： MULTICHANNEL 5.5 TO RS
上传时间： 2013-10-19
上传用户：ddddddd
当拿到一张CASE单时，首先得确定的是能用什么母体才能实现此功能，然后才能展开对外围硬件电路的设计，因此首先得了解每个母体的基本功能及特点，下面大至的介绍一下本公司常用的IC：单芯片解决方案• SN8P1900 系列– 高精度 16-Bit 模数转换器– 可编程运算放大器 (PGIA)• 信号放大低漂移: 2V• 放大倍数可编程: 1/16/64/128 倍– 升压- 稳压调节器 (CHARGE-Pump Regulator)• 电源输入: 2.4V ~ 5V• 稳压输出: e.g. 3.8V at SN8P1909– 内置液晶驱动电路 (LCD Driver)– 单芯片解决方案 • 耳温枪 SN8P1909 LQFP 80 Pins• 5000 解析度量测器 SN8P1908 LQFP 64 Pins• 体重计 SN8P1907 SSOP 48 Pins单芯片解决方案• SN8P1820 系列– 精确的12-Bit 模数转换器– 可编程运算放大器 (PGIA)• Gain Stage One: Low Offset 5V, Gain: 16/32/64/128• Gain Stage One: Low Offset 2mV, Gain: 1.3 ~ 2.5– 升压- 稳压调节器• 电源输入: 2.4V ~ 5V• 稳压输出: e.g. 3.8V at SN8P1829– 内置可编程运算放大电路– 内置液晶驱动电路 – 单芯片解决方案 • 电子医疗器 SN8P1829 LQFP 80 Pins 高速/低功耗/高可靠性微控制器• 最新SN8P2000 系列– SN8P2500/2600/2700 系列– 高度抗交流杂讯能力• 标准瞬间电压脉冲群测试 (EFT): IEC 1000-4-4• 杂讯直接灌入芯片电源输入端• 只需添加1颗 2.2F/50V 旁路电容• 测试指标稳超 4000V (欧规)– 高可靠性复位电路保证系统正常运行• 支持外部复位和内部上电复位• 内置1.8V 低电压侦测可靠复位电路• 内置看门狗计时器保证程序跳飞可靠复位– 高抗静电/栓锁效应能力– 芯片工作温度有所提高: -200C ~ 700C 工规芯片温度： -400C ~ 850C 高速/低功耗/高可靠性微控制器• 最新 SN8P2000 系列– SN8P2500/2600/2700 系列– 1T 精简指令级结构• 1T: 一个外部振荡周期执行一条指令• 工作速度可达16 MIPS / 16 MHz Crystal– 工作消耗电流 < 2mA at 1-MIPS/5V– 睡眠模式下消耗电流 < 1A / 5V额外功能• 高速脉宽调制输出 (PWM)– 8-Bit PWM up to 23 KHz at 12 MHz System Clock– 6-Bit PWM up to 93 KHz at 12 MHz System Clock– 4-Bit PWM up to 375 KHz at 12 MHz System Clock• 内置高速16 MHz RC振荡器 (SN8P2501A)• 电压变化唤醒功能• 可编程控制沿触发/中断功能– 上升沿 / 下降沿 / 双沿触发• 串行编程接口
上传时间： 2013-10-21
上传用户：jiahao131
Abstract: Most hand-held products lack accurate battery-CHARGE monitors ("fuel gauges") because of the misconception that an accurate fuel gauge is difficult to achieve. This article debunks the myths and discusses how to accurately monitor CHARGE at all temperatures, CHARGE and disCHARGE rates, and aging conditions. 无线通信和数据在新一代手机和PDA中的融合为再一次的生产力飞跃创造了条件。。随之而来的将是经济的增长和全新的工作方式，在便携式计算机领域，PC笔记本曾经扮演了类似的开拓者角角。
上传时间： 2013-10-17
上传用户：erkuizhang
Abstract: Most hand-held products lack accurate battery-CHARGE monitors ("fuel gauges") because of the misconception that an accurate fuel gauge is difficult to achieve. This article debunks the myths and discusses how to accurately monitor CHARGE at all temperatures, CHARGE and disCHARGE rates, and aging conditions.
上传时间： 2014-03-18
上传用户：wenwiang
本软件是关于MAX338, MAX339的英文数据手册：MAX338, MAX339 8通道/双4通道、低泄漏、CMOS模拟多路复用器 The MAX338/MAX339 are monolithic, CMOS analog multiplexers (muxes). The 8-channel MAX338 is designed to connect one of eight inputs to a common output by control of a 3-bit binary address. The dual, 4-channel MAX339 is designed to connect one of four inputs to a common output by control of a 2-bit binary address. Both devices can be used as either a mux or a demux. On-resistance is 400Ω max, and the devices conduct current equally well in both directions. These muxes feature extremely low off leakages (less than 20pA at +25°C), and extremely low on-channel leakages (less than 50pA at +25°C). The new design offers guaranteed low CHARGE injection (1.5pC typ) and electrostatic disCHARGE (ESD) protection greater than 2000V, per method 3015.7. These improved muxes are pin-compatible upgrades for the industry-standard DG508A and DG509A. For similar Maxim devices with lower leakage and CHARGE injection but higher on-resistance, see the MAX328 and MAX329.
上传时间： 2013-11-12
上传用户：18711024007
Digital cameras have become increasingly popular over the last few years. Digital imagingtechnology has grown to new markets including cellular phones and PDA devices. With thediverse marketplace, a variety of imaging technology must be available. Imaging technologyhas expanded to include both CHARGE-coupled device (CCD) and CMOS image sensors.
标签： CoolRunner-II XAPP CPLD 390
上传时间： 2013-10-16
上传用户：18710733152
yright 2002 Cygnal Integrated Products, Inc. // // Filename: LIION_BC_MAIN.c // Target Device: 8051F300 // Created: 11 SEP 2002 // Created By: DKC // Tool chain: KEIL Eval C51 // // This is a stand alone battery CHARGEr for a Lithium ION battery. // It utilizes a buck converter, controlled by the on-chip 8-bit PWM, // to provide constant current followed by constant voltage battery CHARGE.
标签： LIION_BC_MAIN Integrated Filename Products
上传时间： 2013-12-23
上传用户：牧羊人8920
Linux 虚拟网络接口 实例 In the Linux (or Unix) world, most network interfaces, such as eth0 and ppp0, are associated with a physical device that is in CHARGE of transmitting and receiving data packets. However, some logical network interfaces don t feature any physical packet transmission. The most well-known examples of these "virtual" interfaces are the shaper and eql interfaces.
标签： Linux interfaces network world
上传时间： 2014-01-11
上传用户：zhangzhenyu
Many programs today suffer from the fact that their users have to connect using IP addresses. This is impossible for dialup users, whose IPs change all the time, and painful for LAN users who don t know their IP addresses or whose addresses also change. In addition, many collaborative programs could benefit from offering friends lists, showing friends as online or offline, providing status information. This kind of functionality is hard to provide, requiring a dedicated Internet database and a new client - client protocol. But it is offered today through a system called AwareNet, which is offered free of CHARGE and royalty
标签： addresses programs connect suffer
上传时间： 2013-12-05
上传用户：CHENKAI
