Tracking a moving object through several frames, provided changes from frame to frame are on the order of +-(10 + "X Range") pixels in the X direction and +-(10 + "Y Range") in the Y direction is done automatically BEcause of a relatively large area of exploration during the search for an optimal (new) position for a particular control point and a very strong force exerted by large values of the image gradient.
标签： frame Tracking provided changes
上传时间： 2015-11-17
上传用户：zgu489
This leon3 design is tailored to the Altera NiosII Startix2 Development board, with 16-bit DDR SDRAM and 2 Mbyte of SSRAM. As of this time, the DDR interface only works up to 120 MHz. At 130, DDR data can be read but not written. NOTE: the test bench cannot be simulated with DDR enabled BEcause the Altera pads do not have the correct delay models. * How to program the flash prom with a FPGA programming file 1. Create a hex file of the programming file with Quartus. 2. Convert it to srecord and adjust the load address: objcopy --adjust-vma=0x800000 output_file.hexout -O srec fpga.srec 3. Program the flash memory using grmon: flash erase 0x800000 0xb00000 flash load fpga.srec
标签： Development Startix2 tailored Altera
上传时间： 2014-01-19
上传用户：chongcongying
This submission includes the presentation and model files that were used in delivering a webinar on 12-15-05 that covered the topic of modeling Hybrid Electric Vehicles. Hybrid electric vehicles (HEVs) have proven they can substantially improve fuel economy and reduce emissions. BEcause HEVs combine an electric drive with the internal combustion engine (ICE) in the powertrain, the vehicle?s kinetic energy can be captured during braking and transformed into electrical energy in the battery. The dual power source also means that the ICE can be reduced in size and can operate at its most efficient speeds.
标签： presentation submission delivering includes
上传时间： 2015-12-24
上传用户：zl5712176
We address the problem of blind carrier frequency-offset (CFO) estimation in quadrature amplitude modulation, phase-shift keying, and pulse amplitude modulation communications systems.We study the performance of a standard CFO estimate, which consists of first raising the received signal to the Mth power, where M is an integer depending on the type and size of the symbol constellation, and then applying the nonlinear least squares (NLLS) estimation approach. At low signal-to noise ratio (SNR), the NLLS method fails to provide an accurate CFO estimate BEcause of the presence of outliers. In this letter, we derive an approximate closed-form expression for the outlier probability. This enables us to predict the mean-square error (MSE) on CFO estimation for all SNR values. For a given SNR, the new results also give insight into the minimum number of samples required in the CFO estimation procedure, in order to ensure that the MSE on estimation is not significantly affected by the outliers.
标签： frequency-offset estimation quadrature amplitude
上传时间： 2014-01-22
上传用户：牛布牛
In this paper, a new family of Cassinian wave-guides is proposed, simulating and calculation are finished with CST Microwave Studio that based on Finite Integral Technique (FIT), and some results are given. Electromagnetic field mode type of it is TE, electromagnetic field is stronger near neck region, and some resonance frequencies appear. The new Cassinian curve wave-guides will possess higher power than ones of the rectangular and elliptic wave-guides BEcause the height at the position where maximal electric field occurs is smaller.
标签： calculation wave-guides simulating Cassinian
上传时间： 2014-01-18
上传用户：netwolf
ST7529液晶驱动 The ST7529 is a driver & controller LSI for 32 gray scale graphic dot-matrix liquid crystal display systems. It generates 255 Segment and 160 Common driver circuits. This chip is connected directly to a microprocessor, accepts Serial Peripheral Interface (SPI), 8-bit/16-bit parallel or IIC display data and stores in an on-chip display data RAM. It performs display data RAM read/write operation with no external operating clock to minimize power consumption. In addition, BEcause it contains power supply circuits necessary to drive liquid crystal, it is possible to make a display system with the fewest components.
标签： 7529 controller dot-matrix graphic
上传时间： 2013-12-02
上传用户：奇奇奔奔
The 1.4 release of Java 2 Standard edition brings a load of new features - and the potential for frustration. Fret not, our new 4th edition has answers. The accelerated introduction lets you start writing code right away, and BEcause the book s classic quick reference contains all the classes in the essential Java packages, you can find exactly what you need to make Java s new version work for you.
标签： potential Standard features release
上传时间： 2014-11-27
上传用户：huannan88
μC/OS-II Goals Probably the most important goal of μC/OS-II was to make it backward compatible with μC/OS (at least from an application’s standpoint). A μC/OS port might need to be modified to work with μC/OS-II but at least, the application code should require only minor changes (if any). Also, BEcause μC/OS-II is based on the same core as μC/OS, it is just as reliable. I added conditional compilation to allow you to further reduce the amount of RAM (i.e. data space) needed by μC/OS-II. This is especially useful when you have resource limited products. I also added the feature described in the previous section and cleaned up the code. Where the book is concerned, I wanted to clarify some of the concepts described in the first edition and provide additional explanations about how μC/OS-II works. I had numerous requests about doing a chapter on how to port μC/OS and thus, such a chapter has been included in this book for μC/OS-II.
标签： OS-II compatible important Probably
上传时间： 2013-12-02
上传用户：jkhjkh1982
Capturing low-level network data can be hard in Java, but it s certainly not impossible If you want to capture network packets in your Java program, you ll need a little help BEcause no parts of the core Java APIAPI give access to low-level network
标签： impossible Capturing low-level certainly
上传时间： 2016-03-05
上传用户：yuanyuan123
Scotia Airlines is a new budget airline operating between Glasgow Airport and the Western Isles. It operates two 24-seater light passenger aircraft and requires a flight booking system. BEcause Scotia offers low cost air travel, there is a need to treat each flight as single cost centre and to be able to ascertain, at any moment, the amount of the cash taken for that flight. Reservations and bookings cannot be made until the flight details have been finalised (flight number, departure and arrival airports). A seat on a flight is considered booked when payment as been received for it. When a reservation is confirmed (changed to booked), the passenger name is checked against the original reservation. A flight can be in any of the following states: Available for bookings Checking in Boarding Closed
标签： operating Airlines Glasgow Airport
上传时间： 2016-03-25
上传用户：hgy9473
