HRVAS is a complete and self-contained heart rate variability analysis software (HRVAS) package. HRVAS offers several preprocessing options. HRVAS offers time-domeain, freq-domain, time-frequency, and nonlinear HRV analysis. All results can be exported to an Excel file. For processing many files HRVAS offers a bach processing feature. All settings/options can be saved to a .mat file and reloaded for future HRV analysis. Upon starting HRVAS all previously used settings/options are loaded.
标签： HRVAS时频分析
上传时间： 2021-09-19
上传用户：boboo
科学家与工程师数字信号处理指南The Scientist and Engineer Guide to Digital Signal Processing.pdf
标签： 数字信号处理
上传时间： 2021-11-11
上传用户：
NIVision for LabVIEW 由三个主要的函数模板组成： 常用视觉程序 （ VisionUtilities） , 图像处理（ Image Processing） , 和机器视觉（ MachineVision）
上传时间： 2021-12-03
上传用户：
The PW2301A uses advanced trench It utilizes the latest processing techniques to achieve the highcell density and reduces the on-resistance with high repetitive avalanche rating. These featurescombine to make this design an extremely efficient and reliable device for use in power switchingapplication and a wide variety of other applications
标签： pw2301a
上传时间： 2022-02-11
上传用户：
基于FPGA设计的相关论文资料大全 84篇用FPGA实现FFT的研究 刘朝晖 韩月秋 摘 要 目的 针对高速数字信号处理的要求，给出了用现场可编程门阵列(FPGA)实现的 快速傅里叶变换(FFT)方案.方法 算法为按时间抽取的基4算法，采用递归结构的块浮点运 算方案，蝶算过程只扩展两个符号位以适应雷达信号处理的特点，乘法器由阵列乘法器实 现.结果 采用流水方式保证系统的速度，使取数据、计算旋转因子、复乘、DFT等操作协 调一致，在计算、通信和存储间取得平衡，避免了瓶颈的出现.结论 实验表明，用FPGA 实现高速数字信号处理的算法是一个可行的方案. 关键词 离散傅里叶变换； 快速傅里叶变换； 块浮点运算； 可编程门阵列 分类号 TP39； TN957.511 Implementation of FFT with FPGA Technology Liu Zhaohui Han Yueqiu (Department of Electronics Engineering, Beijing Institute of Technology, Beijing 100081) Abstract Aim To propose a scheme for implementing FFT with FPGA in accor-dance with the requirement for high speed digital signal processing. Methods The structure of FPGA and requirement of system were considered in the experiment, radix-4 algorithm of DIT and recursive structure were adopted. The group float point arithmetic operation was used in the butterfly and the array multiplier was used to realize multiplication. Results The pipeline pattern was used to ensure the system speed, it made fetching data, calculating twiddle factor, complex multiplication and D
标签： fpga
上传时间： 2022-03-23
上传用户：
设计了农业温湿度智能控制系统,该系统采用DHT11温湿度传感器作为温湿度采集模块,单片机选用AT89C52代替并调用Virtual terminal模拟串口通信,LCD1604液晶显示器实时显示温湿度,实现了温湿度的测量、显示,可自动控制加热、降温、加湿、通风,实现温湿度控制以及超限报警处理,并利用Proteus与Keil进行实际电路的仿真。试验表明,该系统实现了可靠的温湿度监控。We described the design of an intelligent control system of agriculture temperature and humidity.The system uses DHT11 temperature and humidity sensor as the temperature and humidity acquisition module.The SCM adopts AT89C52 to replace and call the virtual terminal for simulating serial communication.LCD1604 displays temperature and humidity in real time,which implements the measurement and display of temperature and humidity.The system is able to automatically control heating,cooling,humidification and ventilation,to achieve temperature and humidity control and over-limit alarm processing.The system also uses Proteus and Keil for actual circuit simulation.The experiment shows that the system is capable of reliable temperature and humidity monitoring.
上传时间： 2022-03-26
上传用户：aben
本系统采用电动机电枢供电回路串接采样电阻的方式来实现对小型直流有刷电动机的转速测量。该系统主要由二阶低通滤波电路,小信号放大电路、单片机测量显示电路、开关稳压电源电路等组成。同时自制电机测速装置,用高频磁环作为载体,用线圈绕制磁环,利用电磁感应原理检测电机运行时的漏磁,将变化的磁场信号转化为磁环上的感应电流。用信号处理单元电路将微弱电信号转化为脉冲信号,送由单片机检测,从而达到准确测量电机的速度的要求。In this system, the sampling resistance of armature power supply circuit is connected in series to measure the speed of small DC brush motor. The system is mainly composed of second-order low-pass filter circuit, small signal amplifier circuit, single-chip measurement and display circuit, switching regulated power supply circuit and so on. At the same time, the self-made motor speed measuring device uses high frequency magnetic ring as the carrier, coil winding magnetic ring, and electromagnetic induction principle to detect the leakage of magnetic field during the operation of the motor, which converts the changed magnetic field signal into the induced current on the magnetic ring. The weak electric signal is transformed into pulse signal by signal processing unit circuit, which is sent to single chip computer for detection, so as to meet the requirement of accurate measurement of motor speed.
标签： 直流电动机
上传时间： 2022-03-26
上传用户：
随着光伏发电系统快速发展,以及电动汽车充电桩的普及,传统的剩余电流保护器无法满足实际需求。介绍了一款B型剩余电流保护器,采用磁调制剩余电流互感器和零序电流互感器采集剩余电流。根据GB/T 22794—2017标准要求,可识别1 kHz及以下的正弦交流、带和不带直流分量的脉动直流、平滑直流等剩余电流信号。经信号调理电路将电压信号送到单片机进行采集和判断。通过试验测试,该样机在测试精度和速度上均符合国家标准的相关要求。The rapid development of photovoltaic power generation systems and the popularity of electric vehicle charging piles make the traditional residual current protective devices unable to meet the actual demand.This paper proposed a type B residual current protective device,which uses the magnetically modulated residual current transformer and the zero sequence current transformer to acquire the residual current.According to the requirements of GB/T 22794—2017,the type B residual current protective device can detect sinusoidal AC residual current of 1kHz and below 1kHz,pulsating DC residual current with and without DC component,smooth DC residual current and so on.The signal processing circuit sends the voltage signal to the MCU for acquisition and judgment.Through experimental tests,the device meets the relevant requirements of national standards in terms of test accuracy and speed.
标签： 电流保护器
上传时间： 2022-03-27
上传用户：
温度控制如今已成为当代社会研究的热点之一,而温度检测在现代设备参数检测中也是一项极其重要的技术,应用十分广泛。与传统的测温方法相比,红外测温方法具有时间短、精度高、使用简单方便等优点。本文以环境温度为被测对象,设计了以STC89C52单片机为控制中心的红外测温装置,能够实现对目标温度的实时采集、处理、显示和报警等功能。本设计主要是由STC89C52单片机、红外测温传感器、LCD1602液晶显示器、按键和蜂鸣器等部分组成,采用非接触的方式对目标温度进行实时检测。Temperature control has become one of the hotspots in contemporary social research,and temperature detection is an extremely important technology in modern equipment parameter detection.Compared with traditional method,the infrared temperature measuring method has advantages of short time,high precision and convenient operation,etc.This paper consider environment temperature as research objects and designs an infrared temperature measuring device which employs the STC89C52singlechipas-control center,and it can realize timely collection,processing,display and alarm function of the target temperature.The design is mainly composed of STC89C52 singlechip,infrared temperature sensor,LCD1602monitor,keys and buzzer,etc.This design detects the target temperature by non-contact method.
上传时间： 2022-03-27
上传用户：jiabin
数字示波器功能强大,使用方便,但是价格相对昂贵。本文以Ti的MSP430F5529为主控器,以Altera公司的EP2C5T144C8 FPGA器件为逻辑控制部件设计数字示波器。模拟信号经程控放大、整形电路后形成方波信号送至FPGA测频,根据频率值选择采用片上及片外高速AD分段采样。FPGA控制片外AD采样并将数据输入到FIFO模块中缓存,由单片机进行频谱分析。测试表明:简易示波器可以实现自动选档、多采样率采样、高精度测频及频谱分析等功能。Digital oscilloscope is powerful and easy to use, but also expensive. The research group designed a low-cost digital oscilloscope, the chip of MSP430F5529 of TI is chosen as the main controller and the device of EP2C5T144C8 of Altera company is used as the logic control unit. Analog signal enter the programmable amplifier circuit, shaping circuit and other pre-processing circuit. The shaped rectangular wave signal is sent to FPGA for measure the frequency. According to the frequency value to select AD on-chip or off-chip high-speed AD for sampling. FPGA controls the off-chip AD sampling and buffers AD data by FIFO module. The single chip microcomputer receives the data, and do FFT for spectrum analysis. The test shows that the simple oscilloscope can realize automatic gain selection, sampling at different sampling rates, high precision frequency measurement and spectrum analysis.
上传时间： 2022-03-27
上传用户：
