虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

Antenna

  • 基于HITAG读写芯片HTRC110的读写设备设计

    Designing read/write device (RWD) units for industrial RF-Identification applications is strongly facilitated by the NXP Semiconductors HITAG Reader Chip HTRC110. All needed function blocks, like the Antenna driver, modulator demodulator and Antenna diagnosis unit, are integrated in the HTRC110. Therefore only a minimum number of additional passive components are required for a complete RWD. This Application Note describes how to design an industrial RF-Identification system with the HTRC110. The major focus is dimensioning of the Antenna, all other external components including clock and power supply, as well as the demodulation principle and its implementatio

    标签: HITAG HTRC 110 读写芯片

    上传时间: 2013-10-22

    上传用户:zhengjian

  • 基于C8051F系列单片机的无线收发电路设计

    基于幅移键控技术ASK(Amplitude-Shift Keying),以C8051F340单片机作为监测终端控制器,C8051F330D单片机作为探测节点控制器,采用半双工的通信方式,通过监控终端和探测节点的无线收发电路,实现数据的双向无线传输。收发电路采用直径为0.8 mm的漆包线自行绕制成圆形空心线圈天线,天线直径为(3.4±0.3)cm。试验表明,探测节点与监测终端的通信距离为24 cm,通过桥接方式,节点收发功率为102 mW时,节点间的通信距离可达20 cm。与传统无线收发模块相比,该无线收发电路在受体积、功耗、成本限制的场合有广阔的应用前景。 Abstract:  Based on ASK technology and with the C8051F340 and C8051F330D MCU as the controller, using half-duplex communication mode, this paper achieves bi-directional data transfer. Transceiver circuit constituted by enameled wire which diameter is 0.8mm and wound into a diameter (3.4±0.3) cm circular hollow coil Antenna. Tests show that the communication distance between detection and monitoring of the terminal is 24cm,the distance is up to 20cm between two nodes when using the manner of bridging and the node transceiver power is 102mW. Compared with the conventional wireless transceiver modules, the circuit has wide application prospect in small size, low cost and low power consumption and other characteristics.

    标签: C8051F 单片机 无线收发 电路设计

    上传时间: 2013-10-19

    上传用户:xz85592677

  • 无线电设计入门资料

    Abstract: The process of designing a radio system can be complex and often involves many project tradeoffs. Witha little insight, balancing these various characteristics can make the job of designing a radio system easier. Thistutorial explores these tradeoffs and provides details to consider for various radio applications. With a focus on theindustrial, scientific, medical (ISM) bands, the subjects of frequency selection, one-way versus two-way systems,modulation techniques, cost, Antenna options, power-supply influences, effects on range, and protocol selectionare explored.

    标签: 无线

    上传时间: 2013-12-13

    上传用户:eastgan

  • 数字卫星设备控制兼容的天线供电系统设计

    Abstract: This application note discusses a design for a phantom Antenna power-supply system compatible with theDigital Satellite Equipment Control (DiSEqC) communication standard, using the MAX16948 automotive dual, highvoltageLDO/switch. The presented application circuit provides a remote Antenna power supply and also enables onewaycommunication from the radio head unit to the remote Antenna. This system architecture offers flexibility inDiSEqC tone-burst frequency choice (100Hz to 30kHz), enabling users the ability to select the best frequency for theirapplication.

    标签: 数字卫星 控制 兼容 供电系统设计

    上传时间: 2013-11-17

    上传用户:fnhhs

  • 射频基础知识

    Radio frequency (RF) can be a complex subject to navigate, but it does not have to be. If you are just getting started with radios or maybe you cannot find that old reference book about Antenna aperture, this guide can help. It is intended to provide a basic understanding of RF technology, as well act as a quick reference for those who “know their stuff” but may be looking to brush up on that one niche term that they never quite understood. This document is also a useful reference for Maxim’s products and data sheets, an index to deeper analysis found in our application notes, and a general reference for all things RF.

    标签: 射频 基础知识

    上传时间: 2013-10-23

    上传用户:685

  • 无线技术指南

    Radio frequency (RF) can be a complex subject to navigate, but it does not have to be. If you are just getting started with radios or maybe you cannot find that old reference book about Antenna aperture, this guide can help. It is intended to provide a basic understanding of RF technology, as well act as a quick reference for those who “know their stuff” but may be looking to brush up on that one niche term that they never quite understood. This document is also a useful reference for Maxim’s products and data sheets, an index to deeper analysis found in our application notes, and a general reference for all things RF.

    标签: 无线技术

    上传时间: 2013-10-08

    上传用户:kinochen

  • 通过整合硬件分立收发器简化AISG的控制系统

    Abstract: This article describes the Antenna Interface Standards Group (AISG) standard in telecommunications and details itshardware implementation. It explains how a fully integrated transceiver such as the MAX9947 can help reduce space and cost, andsolve bus arbitrations in base-station tower equipment.

    标签: AISG 硬件 分立收发器 控制系统

    上传时间: 2014-12-30

    上传用户:wangchong

  • DN381 RFID接收器的基带电路

      Radio Frequency Identifi cation (RFID) technology usesradiated and refl ected RF power to identify and track avariety of objects. A typical RFID system consists of areader and a transponder (or tag). An RFID reader containsan RF transmitter, one or more Antennas and an RFreceiver. An RFID tag is simply an uniquely identifi ed ICwith an Antenna.

    标签: RFID 381 DN 接收器

    上传时间: 2013-10-17

    上传用户:lepoke

  • 高端特殊类型天线分类与外形

    天线(Antenna)是一种变换器,它把传输线上传播的导行波,变换成在无界媒介(通常是自由空间)中传播的电磁波,或者进行相反的变换。在无线电设备中用来发射或接收电磁波的部件。

    标签: 高端 天线 分类

    上传时间: 2013-10-23

    上传用户:小眼睛LSL

  • MAX16948双遥控天线LDO开关

      Abstract: This application note helps system designers choose the correct external components for use with the MAX16948 dualremote Antenna LDO/switch, thus ensuring that automobile-regulated phantom Antenna supply and output-current-monitoring circuitrymeet performance objectives. An electronic calculator is provided that helps specify the critical external components for theMAX16948, thus reducing design time. The calculator also determines the device's analog output voltage, output current-limitthreshold, and output current-sensing accuracies. The calculator includes new automatic Step By Step feature that assists designerswith component choice. To use the new automatic feature, click on the Step By Step button relative to the desired section.

    标签: 16948 MAX LDO 遥控天线

    上传时间: 2013-11-04

    上传用户:lhll918