this is a sample about usb out transmission,it s default installation is D:\\RedLogic\\RCII_samples, and the software environment is quatrusII 5.0,it is usefull for studying hardware and usb.
标签： transmission sample about this
上传时间： 2013-08-24
上传用户：座山雕牛逼
DAC0832是一个8位D/A转换器芯片，单电源供电，从+5V～+15V均可正常工作，基准电压的范围为±10V，电流建立时间为1μs，CMOS工艺，低功耗20mW。其内部结构如图9.1所示，它由1个8位输入寄存器、1个8位DAC寄存器和1个8位D/A转换器组成和引脚排列如图1所示。 • DAC0832工作方式• ADC0809工作方式要求掌握：• MCS-51单片机与D/A转换器的接口连接• MCS-51单片机与A/D转换器的接口连接• 初始化编程及应用了解：• 典型D/A转换器芯片DAC0832的管脚功能• 典型A/D转换器芯片ADC0809的管脚功能
上传时间： 2014-01-14
上传用户：zl520l
Abstract: This application note discusses the development and deployment of 3G cellular femtocell base stations. The technicalchallenges for last-mile residential connectivity and adding system capacity in dense urban environments are discussed, with 3Gfemtocell base stations as a cost-effective solution. Maxim's 3GPP TS25.104-compliant transceiver solution is presented along withcomplete radio reference designs such as RD2550. For more information on the RD2550, see reference design 5364, "FemtocellRadio Reference Designs Using the MAX2550–MAX2553 Transceivers."
标签： Base-Station Applications Single-Chip Transceiver
上传时间： 2013-11-07
上传用户：songrui
Single-Ended and Differential S-Parameters Differential circuits have been important incommunication systems for many years. In the past,differential communication circuits operated at lowfrequencies, where they could be designed andanalyzed using lumped-element models andtechniques. With the frequency of operationincreasing beyond 1GHz, and above 1Gbps fordigital communications, this lumped-elementapproach is no longer valid, because the physicalsize of the circuit approaches the size of awavelength.Distributed models and analysis techniques are nowused instead of lumped-element techniques.Scattering parameters, or S-parameters, have beendeveloped for this purpose [1]. These S-parametersare defined for single-ended networks. S-parameterscan be used to describe differential networks, but astrict definition was not developed until Bockelmanand others addressed this issue [2]. Bockelman’swork also included a study on how to adapt single-ended S-parameters for use with differential circuits[2]. This adaptation, called “mixed-mode S-parameters,” addresses differential and common-mode operation, as well as the conversion betweenthe two modes of operation.This application note will explain the use of single-ended and mixed-mode S-parameters, and the basicconcepts of microwave measurement calibration.
上传时间： 2014-03-25
上传用户：yyyyyyyyyy
Agilent AN 154 S-Parameter Design Application Note S参数的设计与应用 The need for new high-frequency, solid-state circuitdesign techniques has been recognized both by microwaveengineers and circuit designers. These engineersare being asked to design solid state circuitsthat will operate at higher and higher frequencies.The development of microwave transistors andAgilent Technologies’ network analysis instrumentationsystems that permit complete network characterizationin the microwave frequency rangehave greatly assisted these engineers in their work.The Agilent Microwave Division’s lab staff hasdeveloped a high frequency circuit design seminarto assist their counterparts in R&D labs throughoutthe world. This seminar has been presentedin a number of locations in the United States andEurope.From the experience gained in presenting this originalseminar, we have developed a four-part videotape, S-Parameter Design Seminar. While the technologyof high frequency circuit design is everchanging, the concepts upon which this technologyhas been built are relatively invariant.The content of the S-Parameter Design Seminar isas follows:
标签： S参数
上传时间： 2013-12-19
上传用户：aa54
Abstract: This application note discusses the development and deployment of 3G cellular femtocell base stations. The technicalchallenges for last-mile residential connectivity and adding system capacity in dense urban environments are discussed, with 3Gfemtocell base stations as a cost-effective solution. Maxim's 3GPP TS25.104-compliant transceiver solution is presented along withcomplete radio reference designs such as RD2550. For more information on the RD2550, see reference design 5364, "FemtocellRadio Reference Designs Using the MAX2550–MAX2553 Transceivers."
标签： Base-Station Applications Single-Chip Transceiver
上传时间： 2013-11-05
上传用户：超凡大师
项目描述: SQLite is a small C library that implements a self-contained, embeddable, zero-configuration SQL database engine. Features include
标签： zero-configuration self-contained implements embeddable
上传时间： 2013-11-26
上传用户：啊飒飒大师的
ADO.NET in a Nutshell is the most complete and concise source of ADO.NET information available. Besides being a valuable reference, this book covers a variety of issues that programmers face when developing web applications or web services that rely on database access. Most examples use Microsoft s C# language. The book s CD includes an add-in to integrate the reference with Visual Studio .NET help files.
标签： information ADO NET available
上传时间： 2015-01-11
上传用户：nanfeicui
ngrep strives to provide most of GNU grep s common features, applying them to the network layer. ngrep is a pcap-aware tool that will allow you to specify extended regular or hexadecimal expressions to match against data payloads of packets. It currently recognizes TCP, UDP and ICMP across Ethernet, PPP, SLIP, FDDI, Token Ring and null interfaces, and understands bpf filter logic in the same fashion as more common packet sniffing tools, such as tcpdump and snoop.
标签： applying features network strives
上传时间： 2014-01-15
上传用户：bcjtao
HomerMX is a message exchange service for wireless message formats such as SMS and MMS. HomerMX is a Web Services-based (SOAP/WSDL) gateway that is implemented in J2EE and runs under JBoss. It currently supports SMPP and Nokia s MMS.
标签： HomerMX message exchange wireless
上传时间： 2014-01-04
上传用户：huangld
