虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

电流测试

  • 基于C8051F020和Zigbee的汽车测试系统设计

    以C8051F020为核心处理器,设计无线传感器网络数据采集系统。系统采用SZ05-ADV型无线通讯模块组建Zigbee无线网络,结合嵌入式系统的软硬件技术,完成终端节点的8路传感器信号的数据采集。现场8路信号通过前端处理后,分别送入C8051F020的12位A/D转换器进行转换。经过精确处理、存储后的现场数据,通过Zigbee无线网络传送到上位机,系统可达到汽车试验中无线测试的目的。 Abstract:  This paper designs a wireless sensor network system for data acquisition with C8051F020 as core processors.The system used SZ05-ADV wireless communication module,set up a Zigbee wireless network, combined with hardware and software technologies of embedded systems,completed the end-node 8-locale sensor signal data acquisition.Eight locale signals were sent separately into the 12-bit ADC of C8051F020 for conversion through front treatment.After accurate processing and storage,the locale data was transmitted to the host computer through Zigbee wireless.The system achieves the purpose of wireless testing in vehicle trial.

    标签: C8051F020 Zigbee 汽车测试 系统设计

    上传时间: 2013-11-23

    上传用户:dsgkjgkjg

  • 基于C8051F040的方位角测试系统

    提出一种基于C8051F040的炮塔方位角测试系统的设计方案,给出测试系统的各个模块软硬件设计。炮塔方位角测试系统集数据采集,数据传输和数据显示等功能于一体,实现了炮塔方位角装置的离线检测。系统软件采用C51编写,对单片机进行有效电源管理,保证了系统的稳定性,可靠性。 Abstract:  This paper puts forwards a design of artillery position system based on C8051F040,describes all modules hardware and software design of measurement system.The system has the function of information collection,transmission,and display.It can measure artillery position system in offline.The system software using C51can manage the power of single chip microcomputer,guarantee the stability,reliability.

    标签: C8051F040 方位角 测试系统

    上传时间: 2014-12-27

    上传用户:7891

  • 基于DAC7512的数控直流恒流源设计

    为了解决磁放大器性能测试过程中,需要对其供给不同数值恒定电流的问题,设计了一种基于DAC7512和单片机的数控恒流源系统。该系统采用AT89C51作为主控器件,将计算机发送的电流控制字命令转换为D/A转换器控制字,通过模拟SPI通信接口,写D/A控制字到DAC7512,从而控制其输出相应数字电压值,经差动缩放电路、电压/电路变换电路和功率驱动电路,最后输出恒定电流。实验结果表明,恒流源输出电流调节范围为-45~+45 mA、精度为±0.1 mA,分辨率达0.024 4 mA,具有应用灵活,外围电路简单,可靠性高的特点。该数控直流恒流源也可为相关产品的测试系统研发提供参考。 Abstract:  In order to solve the need to supply different values constant current for the magnetic amplifier in testing process, numerical control constant current source system was designed based on DAC7512 chip and microcontroller technology. The system used the AT89C51 as the main chip, which can convert the current control word from computer into to D/A control words. And the system wrote D/A control word into the DAC7512 chip to control the output voltage value by the SPI communication interface, which can output corresponding constant current figures by scaling circuit, the V/I converter and power drive circuit. Experimental results show that the current source output current adjustment range is -45~+45mA, accuracy is ± 0.1mA, and resolution ratio is 0.024 4mA

    标签: 7512 DAC 数控直流 恒流源

    上传时间: 2014-12-27

    上传用户:invtnewer

  • 基于AVR单片机的船舶气象仪测试系统的设计

       针对船舶气象仪保障维修而设计的船舶气象仪测试系统,包括信息处理终端、主仪器检测模块、传感器检测模块,各个模块都采用基于AVR单片机的嵌入式系统,模块之间通过CAN总线进行通信。结果表明,船舶气象仪测试系统能够快速检测船舶气象仪故障,与单纯依靠人工方式排查故障相比,故障检测时间缩短了60%以上。 Abstract:  The test system of ship meteorological instrument was developed to satisfy the maintenance of ship meteorological instruments,which composed of information processing terminal, testing module of main instrument and testing module of sensors. Each of these modules included an embedded system based on microcontroller of AVR series and communicated with other module by CAN bus. The results show that the test system can judge the fault of ship meteorological instrument quickly and shorten the fault detection time as much as 60% compared with simple manual troubleshooting.

    标签: AVR 单片机 气象仪 测试系统

    上传时间: 2013-11-23

    上传用户:stvnash

  • 基于单片机控制的充电电池容量测试电路的设计

    摘要:随着电子技术的发展,镍镉和镍氢等充电电池的使用愈来愈多,购买和使用充电电池时,电池容量(Ah)成为人们关注的指标.本文采用一种基于AT89C2051单片机制作的电池容量测试电路,可对镍镉和镍氢等充电电池的容量进行自动测试,并以数字形式显示其测试结果,测量范围为0.01—9.99Ah.分析了电路硬件与软件设计实现,具有一定的实用价值.关键词:电池容量;单片机;硬件;软件

    标签: 单片机控制 充电电池 容量测试 电路

    上传时间: 2013-10-22

    上传用户:wsf950131

  • YC-53型便携式电流互感器校验装置

    采用RISC结构型单片机Atmega128作为微处理器,320×240点阵大屏幕液晶显示器,全中文界面,读数直观,测量迅速,可在规程要求的测量点自动进行测量。模拟线路采用电位差式测量原理,具有较高的抗电磁干扰能力和较好的稳定性,结合微处理器技术及系统的引入,使该产品成为高智能化数字测量仪器。本产品执行标准及检定规格:《JJG169-93互感器校验仪检定规程》、《JJG313-94测量用电流互感器检定规程》、《GB1208-1997电流互感器》、《DL/T668-1999测量用互感器检验装置》、《DL/T448-2000电能计量装置技术管理规程》,测量对象为0.5级及以下精度电流互感器。

    标签: YC 53 便携式 电流互感器

    上传时间: 2013-11-11

    上传用户:ginani

  • 基于STC89C52数控直流电源设计

    本文采用STC89C52单片机为核心控制器,实现了电流预置、步进调节以及LCD液晶同步显示电流预置值和实测值等功能,系统采用闭环控制方案,输出电压、电流值通过精密电阻采样反馈。测试表明系统性能可靠、纹波电流小、控制精度高、实用性强。

    标签: STC 89C C52 89

    上传时间: 2013-10-08

    上传用户:meiguiweishi

  • 纺织设备中金属旋转体振动的单片机测试系统

    摘要:纺织机械中金属旋转体在旋转过程中由于自身的不平衡或安装不合理等原因引起振动,对设备的运行产生不良影响。本文提供一种用单片机测试系统测试金属旋转体振动的方法,并介绍其软件和硬件的设计及原理。关键词纺织机械 机构 金属旋转体 振动测试系统

    标签: 纺织 旋转体 振动 单片机

    上传时间: 2014-12-27

    上传用户:012345

  • 基于单片机的AFM纳米机械性能测试系统

    摘要:为解决采用原子力显微镜(AFM)系统进行纳米机械性能测试中存在的不能够直接获得载荷?压深曲线以及不能够随意改变加载、保载、卸载时间等问题,对AFM系统进行了改造,开发了一套基于单片机的信号输入输出模块。将该模块与AFM控制系统相联,形成新的纳米机械性能测试系统。该系统信号输出精度为0.15mV,信号采集精度为0.3mV,工作台的移动灵敏度为1.53nm,可以动态改变垂直载荷,并实时获得载荷?压深曲线。通过单片机设置模拟信号的输出速率可以实现加载、保载和卸载速率的改变;结合二维微动精密工作台,可以实现较大范围内高精度的点阵压痕测试。通过在聚碳酸酯、聚二甲基硅氧烷等材料表面进行实验测试表明:该系统可以高速高精度地测量样品的纳米机械性能参数,包括对样品进行纳米压痕测试和对样品的纯弹性变形过程进行检测,如聚二甲基硅氧烷或者各种微梁等微小构件。关 键 词:原子力显微镜(AFM);单片机;纳米机械性能;载荷-压深曲线

    标签: AFM 单片机 纳米机械 性能测试

    上传时间: 2013-10-18

    上传用户:a296386173

  • 利用MCP3905/6进行符合IEC标准的有功电能表设计,A

    MCP3905/6 电能表集成电路(Intergrated Circuits,IC)为单相家用电表设计提供有功功率测量。这些器件包含符合国际电工委员会(International Electrotechnical Commission,IEC)所要求的特性,如空载门限和启动电流。此外, MCP3905/6 电表参考设计还给出了根据IEC标准的要求通过EMC抗干扰的系统级设计的例子。 本应用笔记中使用的电表参考设计演示板进行了IEC 认证要求的EMC 测试。这些测试由第三方进行,测试结果见本应用笔记的末尾。

    标签: 3905 MCP IEC 标准

    上传时间: 2013-10-17

    上传用户:ysjing