常见电容值的读取方法
上传时间: 2013-11-10
上传用户:WMC_geophy
贴片电容分类介绍
上传时间: 2014-12-23
上传用户:PresidentHuang
VISHAY ESTA功率电容选型指导.
上传时间: 2013-10-22
上传用户:dddddd
BP8Y系列频敏变阻器(以下简称变阻器)专用于电机功率1.5~200kW,频率为50Hz的YZR系列起重及冶金用三相异步电动机频繁操作条件下的起动及反接设备。该变阻器直接连接于异步电动机的转子回路中, 不需另装接触器等短接设备;能使电动机获得接近恒转矩的机械特性,是极为理想的起动元件。
上传时间: 2013-11-04
上传用户:guojin_0704
X电容是指跨于L-N之间的电容器, Y电容是指跨于L-G/N-G之间的电容器。(L=Line, N=Neutral, G=Ground).
标签: 电容
上传时间: 2014-12-23
上传用户:haohao
BP8R3系列频敏变阻器(以下简称变阻器)适用于电机功率22~2240kW,频率为50Hz的绕线型三相异步电动机不频繁操作条件下的偶尔短时起动。
上传时间: 2013-10-08
上传用户:togetsomething
分析了调幅信号和载波信号之间的相位差与调制信号的极性的对应关系,得出了相敏检波电路输出电压的极性与调制信号的极性有对应关系的结论。为了验证相敏检波电路的这一特性,给出3 个电路方案,分别选用理想元件和实际元件,采用Multisim 对其进行仿真实验,直观形象地演示了相敏检波电路的鉴相特性,是传统的实际操作实验所不可比拟的。关键词:相敏检波;鉴相特性;Multisim;电路仿真 Abstract : The corresponding relation between modulation signal polarity and difference phases of amplitudemodulated signal and the carrier signal ,the polarity of phase2sensitive detecting circuit output voltage and the polarity of modulation signal are correspondent . In order to verify this characteristic ,three elect ric circuit s plans are produced ,idea element s and actual element s are selected respectively. Using Multisim to carry on a simulation experiment ,and then demonst rating the phase detecting characteristic of the phase sensitive circuit vividly and directly. Which is t raditional practical experience cannot be com pared.Keywords :phase sensitive detection ;phase2detecting characteristic ;Multisim;circuit simulation
上传时间: 2013-11-23
上传用户:guanhuihong
在VFB运算放大器的反馈环路中使用一个电容是非常常见的做法,其目的是影响频率响应,就如在简单的单极点低通滤波器中一样,如下面的图1所示。结果将噪声增益绘制成了一幅波特图,用于分析稳定性和相位裕量
上传时间: 2013-10-29
上传用户:38553903210
触摸电容pcb布线
上传时间: 2013-10-10
上传用户:540750247
电容在EMC设计
上传时间: 2013-10-22
上传用户:jjj0202