虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

汽车协议

  • CAN总线协议解析

    CAN总线协议解析 CAN总线协议解析

    标签: CAN 总线 协议解析

    上传时间: 2013-10-08

    上传用户:wweqas

  • MODBUS协议程序C

    51单片机modbus rtu 协议 c语言例子

    标签: MODBUS 协议 程序

    上传时间: 2013-11-18

    上传用户:lu2767

  • MODBUS通讯协议及编程

    ModBus RTU协议

    标签: MODBUS 通讯协议 编程

    上传时间: 2013-11-07

    上传用户:long14578

  • TI最新BSL协议说明

    TI最新BSL协议说明。

    标签: BSL 协议

    上传时间: 2013-10-21

    上传用户:u789u789u789

  • 基于MC9S12HY32的电动汽车仪表盘设计

    以Freescale的S12系列16位微处理器MC9S12HY32为核心,为某电动汽车设计了一款仪表盘,实现了车速检测、步进电机控制、LCD显示、故障报警等功能。利用芯片内部资源特性设计了其硬件结构及电路,根据仪表盘的原理和工作方式设计了软件流程,并介绍了基于脉冲整形的车速信号检测的硬件设计及基于滑动时间窗口脉冲统计法的软件设计。装车试验运行稳定,有很高的实用价值。

    标签: MC9 S12 MC 9S

    上传时间: 2013-11-01

    上传用户:海陆空653

  • 单片机控制汽车语音技术

    单片机控制汽车语音技术

    标签: 单片机控制 汽车 语音技术

    上传时间: 2014-11-03

    上传用户:ouyang426

  • I2C总线协议详解

    串行单片机的数据传输协议。开始 结束 应答 数据传送

    标签: I2C 总线协议

    上传时间: 2013-10-22

    上传用户:alibabamama

  • PC机与单片机通信(RS232协议)

    0001、PC 机与单片机通信(RS232 协议).rar

    标签: 232 RS PC机与单片机 通信

    上传时间: 2014-10-31

    上传用户:牛布牛

  • 基于C8051F020和Zigbee的汽车测试系统设计

    以C8051F020为核心处理器,设计无线传感器网络数据采集系统。系统采用SZ05-ADV型无线通讯模块组建Zigbee无线网络,结合嵌入式系统的软硬件技术,完成终端节点的8路传感器信号的数据采集。现场8路信号通过前端处理后,分别送入C8051F020的12位A/D转换器进行转换。经过精确处理、存储后的现场数据,通过Zigbee无线网络传送到上位机,系统可达到汽车试验中无线测试的目的。 Abstract:  This paper designs a wireless sensor network system for data acquisition with C8051F020 as core processors.The system used SZ05-ADV wireless communication module,set up a Zigbee wireless network, combined with hardware and software technologies of embedded systems,completed the end-node 8-locale sensor signal data acquisition.Eight locale signals were sent separately into the 12-bit ADC of C8051F020 for conversion through front treatment.After accurate processing and storage,the locale data was transmitted to the host computer through Zigbee wireless.The system achieves the purpose of wireless testing in vehicle trial.

    标签: C8051F020 Zigbee 汽车测试 系统设计

    上传时间: 2013-11-23

    上传用户:dsgkjgkjg

  • 基于AVR的新型防汽车追尾安全装置设计

    针对目前汽车追尾事件频发问题,提出一种防汽车车前和车后追尾的安全装置设计。该设计以高性能、低功耗的8位AVR微处理器ATmega8L为核心,结合霍尔式车速传感器、激光雷达测距装置和MMA7260QT加速度传感器,能够兼顾车前和车后,摒弃以往设计中只考虑车前或车后单一性缺点,尤其适用于高速、夜晚或新手行车。 Abstract:  Aiming at the high frequency of vehicle rear-end collision,a safe device design of anti-vehicle rear-end collision is presented.In the design,the high-performance,low-power8-bit AVR microprocessor ATmega8L is utilized as a core combined with Hall-type speed sensor,laser-radar ranging devices and the acceleration sensor MMA7260QT.The design considers both the front and back of a car,and overcomes the drawbacks of former designs in which only the front or the back of the car is considered,so it is especially suitable for high-speed,night or the beginner’s driving.

    标签: AVR 汽车追尾 装置

    上传时间: 2013-10-14

    上传用户:GavinNeko