This application note demonstrates how to write an Inter Integrated Circuit bus driver (I2C) for the xA-S3 16-bitMicrocontroller from Philips Semiconductors.Not only the driver software is given. This note also contains a set of (exAmple) interface routines and a smalldemo application program. All together it offers the user a quick start in writing a complete I2C system applicationwith the PxAS3x.The driver routines support interrupt driven single master transfers. Furthermore, the routines are suitable foruse in conjunction with real time operating systems.
上传时间： 2013-11-02
上传用户：zw380105939
The xA-S3 is a member of Philips Semiconductors’ xA (eXtended Architecture) family of high performance 16-bit single-chip Microcontrollers. The xA-S3 combines many powerful peripherals on one chip. Therefore, it is suited for general multipurpose high performance embedded control functions.One of the on-chip peripherals is the I2C bus interface. This report describes worked-out driver software (written in C) to program / use the I2C interface of the xA-S3. The driver software, together with a demo program and interface software routines offer the user a quick start in writing a complete I2C - xAS3 system application.
上传时间： 2013-11-10
上传用户：liaofamous
用于开发菲利浦xA单片机的开发环境，同时含注册方式
上传时间： 2015-03-17
上传用户：zq70996813
UcOs ii的多任务操作系统全部原代码 包含这些cpu的原代码： 8051 68H11 8088 AVR xA 196 TI DSP 54XX ARM C167 68H12 68000 SH3
上传时间： 2015-05-14
上传用户：ruan2570406
这是基于蓝海微芯LJD-SY-xA+单片机开发系统的远程无线监控系统的DA及AD采集和数码显示的部分，GPRS无线控制部分正在整理，稍后再传
上传时间： 2015-07-03
上传用户：奇奇奔奔
用FFT分别计算xA(n) (p=8, q=2)与Xb(n) (a =0.1,f =0.0625)的16点循环卷积和线性卷积。
上传时间： 2013-12-09
上传用户：lizhizheng88
P3.18. An analog signal xA(t) = sin (100πt) is sampled using the following sampling intervals. In each case plot the spectrum of the resulting discrete-time signal. Ts= 0.1 ms, Ts= 1 ms, Ts = 0.01 Sec
标签： following intervals sampling sampled
上传时间： 2017-07-12
上传用户：shizhanincc
P3.20. Consider an analog signal xA (t) = sin (2πt), 0 ≤t≤ 1. It is sampled at Ts = 0.01, 0.05, and 0.1 sec intervals to obtain x(n). b) Reconstruct the analog signal ya (t) from the samples x(n) using the sinc interpolation (use ∆ t = 0.001) and determine the frequency in ya (t) from your plot. (Ignore the end effects.) C) Reconstruct the analog signal ya (t) from the samples x (n) using the cubic spline interpolation and determine the frequency in ya (t) from your plot. (Ignore the end effects.)
标签： Consider sampled analog signal
上传时间： 2017-07-12
上传用户：咔乐坞
买的开发板上带的52个应用于实物的程序，希望对大家有帮助
上传时间： 2013-11-04
上传用户：xymbian
TUXEDO连接数据库的例子，这里不使用xA协议，而是采用直接连接的方式
上传时间： 2013-12-20
上传用户：1079836864
