When the P89LPC90x is in programming mode all pins that are not used for programming are tri-stated. During programming mode the reset pin has a weak pull-up resistor.
标签： programming tri-stated are When
上传时间： 2015-11-03
上传用户：集美慧
以tri公司的基于NOR Flash 管理软件FMM为例，详细介绍嵌入式系统中如何根据Flash的物理特性来进行Flash存储管理
上传时间： 2014-01-24
上传用户：sqq
以tri公司的基于NORFlash的Flash管理软件FMM 为例，详细介绍嵌入式系统中如何根据 Flash 的物理特性来进行Flash存储管理
上传时间： 2014-01-10
上传用户：wfl_yy
Binary search Ham binsearch la mot ham de qui, giup tim gia tri tren mang so a[].Neu ham tra ve tri -1 la khong tim thay,neu ham tra ve tri khac -1 la tim thay tai vi tri la gia tri tra ve
上传时间： 2017-05-15
上传用户：BIBI
GPIO (General Purpose Input and Output ports) with microprocessor programmable tri-state bus interface
标签： microprocessor programmable tri-state General
上传时间： 2017-06-13
上传用户：hxy200501
The tri-Mode Ethernet MAC (TEMAC) UltraController-II module is a minimal footprint,embedded network processing engine based on the PowerPC™ 405 (PPC405) processor coreand the TEMAC core embedded within a Virtex™-4 FX Platform FPGA. The TEMACUltraController-II module connects to an external PHY through Gigabit Media IndependentInterface (GMII) and Management Data Input/Output (MDIO) interfaces and supports tri-mode(10/100/1000 Mb/s) Ethernet. Software running from the processor cache reads and writesthrough an On-Chip Memory (OCM) interface to two FIFOs that act as buffers between thedifferent clock domains of the PPC405 OCM and the TEMAC.
上传时间： 2013-10-26
上传用户：yuzsu
This application note provides step-by-step instructions on how to recreate a tri-Mode Ethernet(TEMAC) performance testing system using the ML405 board and MontaVista Linux 4.0. Thisapplication note shows how to set up a simple EDK Base System Builder system on the ML405Evaluation Platform and run performance tests. The network architecture for the test isdescribed. A system is built and downloaded into the FPGA. A MontaVista Linux kernel isconfigured, built, and downloaded into the ML405 Evaluation Platform. The instructions forobtaining and setting up the software used to perform the measurements, netperf, are given.
上传时间： 2013-11-11
上传用户：saharawalker
2． Using Gaussian elimination method and Gaussian elimination method with row scaled method to solve the following tri-diagonal system for n=10 and 100
标签： method elimination Gaussian scaled
上传时间： 2013-12-31
上传用户：lyy1234
SOPC实验--Hello World实验:启动Quartus II软件，选择File→New Project Wizard，在出现的对话框中填写项目名称 2、 点击Finish，然后选择“是”。选择Assignments→Device，改写各项内容。Family改为CycloneII，根据实验板上的器件选择相应的器件，本实验选择EP2C5T144C8,点击对话框中的Device & Pin Options，在Configuration中，选项Use Configuration Device为EPCS1，选项Unused Pins为As inputs,tri-stated.
上传时间： 2014-01-13
上传用户：梧桐
The SP486 and SP487 are low–power quad differential line drivers meeting RS-485 and RS-422 standards. The SP486 features a common driver enable control the SP487 provides independent driver enable controls for each pair of drivers. Both feature tri–state outputs and wide common–mode input range. Both are available in 16–pin plastic DIP and SOIC packages.
标签： differential and standard drivers
上传时间： 2014-01-13
上传用户：tianyi223
