It is a server.................. made in C sharp..........................
上传时间： 2013-12-14
上传用户：jyycc
source code for RDA C# sharp .....
上传时间： 2017-08-18
上传用户：zhengjian
C programming is a craft that takes years to perfect. A reasonably sharp person can learn the basics of C quite quickly. But it takes much longer to master the nuances of the language and to write enough programs, and enough different programs, to become an expert. In natural language terms, this is the difference between being able to order a cup of coffee in Paris, and (on the Metro) being able to tell anative Parisienne where to get off. This book is an advanced text on the ANSI C programming language. It is intended for people who are already writing C programs, and who want to quickly pick up some of the insights and techniques of experts.
标签： programming reasonably perfect basics
上传时间： 2013-12-20
上传用户：ls530720646
LS055R1SX04 sharp 2K屏资料，详细datasheet，希望对大家有帮助
标签： 2K屏
上传时间： 2022-04-25
上传用户：默默
汽车仪表总成是汽车和驾驶员进行信息交互的窗口。传统的汽车仪表总成采用了大量机械器件、模拟电路和少量简单数字电路的方式设计。它体积大，精确和稳定性低，显示信息少，控制按钮繁复。本项目以当前主流的嵌入式技术为基础，设计了一种以大尺寸LCD触摸屏为主要显示控制界面，以CAN总线和其他接口为信息采集渠道，以高速嵌入式ARM9微控制器为处理单元的车载信息显控终端。 作者在该项目中负责车载信息显控终端的样机设计，用Prote199完成原理图和PCB图的设计，编写测试程序对主要硬件进行测试。软件上移植Linux操作系统并编写LCD驱动程序。 论文设计的车载信息显控终端以SAMSUNG公司S3C2410ARM9微控制器为核心，以Microchip公司的MCP2515芯片为CAN总线控制器，以sharp公司LQ080V3DG01型号的8英寸LCD屏为显控接口。存储器方面外扩了NOR FLASH、NAND FLASH、SDRAM。接口方面设计了CAN、USB、RS232、以太网等标准接口，和GPIO、AD等接口。软件上本车载信息显控终端采用自行剪裁移植的Linux操作系统，并移植了相应的LCD驱动程序。 论文主要阐述了车载信息显控终端的硬件设计，详细分析了Linux在S3C2410微控制器系统上的移植，并将在软硬件调试过程中总结的经验与大家分享。 本车载信息显控终端是对汽车仪表总成数字化和虚拟化显示控制的一个有益尝试，离最后的实用化和产品化还待进一步研究。
上传时间： 2013-05-30
上传用户：hechao3225
This document was developed under the Standard Hardware and Reliability Program (sharp) TechnologyIndependent Representation of Electronic Products (TIREP) project. It is intended for use by VHSIC HardwareDescription Language (VHDL) design engineers and is offered as guidance for the development of VHDL modelswhich are compliant with the VHDL Data Item Description (DID DI-EGDS-80811) and which can be providedto manufacturing engineering personnel for the development of production data and the subsequent productionof hardware. Most VHDL modeling performed to date has been concentrated at either the component level orat the conceptual system level. The assembly and sub-assembly levels have been largely disregarded. Under thesharp TIREP project, an attempt has been made to help close this gap. The TIREP models are based upon lowcomplexity Standard Electronic Modules (SEM) of the format A configuration. Although these modules are quitesimple, it is felt that the lessons learned offer guidance which can readily be applied to a wide range of assemblytypes and complexities.
上传时间： 2014-12-23
上传用户：xinhaoshan2016
针对众多低成本数据采集需求，采用带有片上USB控制器和D/A转换器的混合信号微处理器C8051F340，设计了一款可通过USB接口和LabVIEW图形用户界面实现与PC机联机的数据采集器，同时借助系统的SD卡存储独立实现现场长时间采集数据。该数据采集器成本低，结构简单，体积小，已成功用于工业现场。 Abstract: Aiming at the need of low cost data acquisition, a data acquisition device is designed based on C8051F340 which is a mixed-signal microcontroller and integrates USB controller and A/D controller on a chip.The data acquisition device which can combine with PC by USB interface and LabVIEW graphical user interface,can realize data acquisition. At the same time,it can be solely run a long time in virtue of SD card in field.The date aequisition device features low cost,simple structure and little sharp, and it has been used in industry field.
上传时间： 2014-05-31
上传用户：1109003457
This document was developed under the Standard Hardware and Reliability Program (sharp) TechnologyIndependent Representation of Electronic Products (TIREP) project. It is intended for use by VHSIC HardwareDescription Language (VHDL) design engineers and is offered as guidance for the development of VHDL modelswhich are compliant with the VHDL Data Item Description (DID DI-EGDS-80811) and which can be providedto manufacturing engineering personnel for the development of production data and the subsequent productionof hardware. Most VHDL modeling performed to date has been concentrated at either the component level orat the conceptual system level. The assembly and sub-assembly levels have been largely disregarded. Under thesharp TIREP project, an attempt has been made to help close this gap. The TIREP models are based upon lowcomplexity Standard Electronic Modules (SEM) of the format A configuration. Although these modules are quitesimple, it is felt that the lessons learned offer guidance which can readily be applied to a wide range of assemblytypes and complexities.
上传时间： 2013-11-20
上传用户：pzw421125
国外游戏开发者杂志2000年第八期配套代码，包括Brian sharp的implicit-surface fluid的例子代码，例子中使用了Lander的动画库
上传时间： 2015-01-05
上传用户：wsf950131
国外游戏开发者杂志2000年第二期配套代码，包含了Brian sharp地图分块的例子和代码和Jeff Lander的动画阴影的例子
上传时间： 2014-12-05
上传用户：CHINA526
