Digitemp Jr. is a device that is designed to measure and report ambient temperature. When connected to an RS-232 port on any PC, it will periodically measure and report in ASCII form the ambient temperature in degrees Celsius. These temperature readings can be monitored with any terminal program. If the terminal program supports capture to disk, the temperature readings can be saved to disk for further analysis with a spreadsheet program or other data analysis tool. The simple ASCII output format of Digitemp Jr. makes it relatively easy to write custom software for receiving, recording, and analyzing ambient temperature data. Best of all, Digitemp Jr. requires no external power supplies or batteries. It is powered directly by the RS-232 port.
上传时间： 2013-10-20
上传用户：Maple
首先研究CAN总线和SAE J1939协议，提出一种基于MC9S12HZ256微控制器的总线式汽车数字仪表解决方案。详细介绍SAE J1939协议的报文帧格式及应用层协议中发动机相关参数的定义，以及步进电机及其驱动和车速信号的处理方法。该数字仪表系统硬件平台由微处理器和信号采集和信息处理及显示等模块组成。软件设计部分编程实现了对CAN总线和各传感器数据的读取、处理。该系统能够实时反映车辆工况。 Abstract: In this paper，CAN bus and SAE J1939protocol are researched，and a vehicle digital instrument solution based on MC9S12HZ256MCU is proposed.The message frame format and some engine-related parameters’definition in SAE J1939application layer protocol are introduced in detail.Stepper motor and its driver，the methods of speed signal process-ing are also introduced.The hardware platform of vehicle digital instrument is composed by MCU，signal acquisition mod-ule，and signal processing and displaying module.Data receiving and processing from CAN bus and sensors are accom-plished by programming，and vehicle condition can be reflected in real-time.
上传时间： 2013-10-20
上传用户：huannan88
介绍了基于单片机C8051F020的通用串口适配器的设计与实现方法，即由单片机控制的智能化一对多口收发信号转换器。通过采用C51对单片机进行编程，控制与RS-232（标准RS-232电平）、RS232(TTL电平)、RS-422接口的数据通信；采用C++ Builder作为开发平台，通过RS-232接口实现上位机对适配器各个通信端口的控制。 Abstract: Design and realization of a universal serial port adapter based on the MCU C8051F020 are introduced.The adapter is an intelligent one-to-more receiving and transmitting signal converter controlled by the MCU. By programming the MCU with the language C51,MCU control data communication between the MCU and RS-232(RS-232 level),RS-232(TTL level),RS-422 port; Using C++ Builder as the development plane, by one RS232 port, the upper PC can control each of the communication port of the adapter.
上传时间： 2013-11-19
上传用户：hebanlian
介绍了CAN总线和P87C591单片机的特点，给出了基于P87C591单片机的信号采集节点的软、硬件设计，指出了硬件电路设计中应注意的问题，在软件设计中重点介绍了节点初始化、报文发送和报文接收等子程序。 Abstract: The features of CAN Bus and the microcontroller P87C591 are introduced, and the design of hardware circuit and soft configuration of the signals collection node based on P87C591 are presented. The problems in designing hardware circuit are discussed.Initialization subprogram, transmiting subprogram and receiving subprogram are emphasized in soft configuration.
上传时间： 2013-11-03
上传用户：BIBI
针对UHF读写器设计中，在符合EPC Gen2标准的情况下，对标签返回的高速数据进行正确解码以达到正确读取标签的要求，提出了一种新的在ARM平台下采用边沿捕获统计定时器数判断数据的方法，并对FM0编码进行解码。与传统的使用定时器定时采样高低电平的FM0解码方法相比，该解码方法可以减少定时器定时误差累积的影响；可以将捕获定时器数中断与数据判断解码相对分隔开，使得中断对解码影响很小，实现捕获与解码的同步。通过实验表明，这种方法提高了解码的效率，在160 Kb/s的接收速度下，读取一张标签的时间约为30次/s。 Abstract: Aiming at the requirement of receiving correctly decoded data from the tag under high-speed communication which complied with EPC Gen2 standard in the design of UHF interrogator， the article introduced a new technology for FM0 decoding which counted the timer counter to judge data by using the edge interval of signal capture based on the ARM7 platform. Compared with the traditional FM0 decoding method which used the timer timed to sample the high and low level， the method could reduce the accumulation of timing error and could relatively separate capture timer interrupt and the data judgment for decoding， so that the disruption effect on the decoding was small and realizd synchronization of capture and decoding. Testing result shows that the method improves the efficiency of decoding， at 160 Kb/s receiving speed， the time of the interrogator to read a tag is about 30 times/s.
上传时间： 2013-11-10
上传用户：liufei
Linux 虚拟网络接口 实例 In the Linux (or Unix) world, most network interfaces, such as eth0 and ppp0, are associated with a physical device that is in charge of transmitting and receiving data packets. However, some logical network interfaces don t feature any physical packet transmission. The most well-known examples of these "virtual" interfaces are the shaper and eql interfaces.
标签： Linux interfaces network world
上传时间： 2014-01-11
上传用户：zhangzhenyu
This book describes the following communications applications: Mail, Message Handler( MH), Transmission ControlProtocol/ Internet Protocol(TCP/ IP), Basic Networking Utilities( BNU), and Asynchronous Terminal Emulation( ATE). It provides overviews, concepts, and procedures on receiving and sending mail and messages, transferring files( ftp command), printing files from and to a remote system, running commands on other systems, communicating between local and remote systems, and customizing the communications environment.
标签： communications applications Transmiss describes
上传时间： 2013-12-18
上传用户：woshini123456
TI DSP2812 can总线程序,可以用这个程序设计can总线收发数据,已经在自己的开发板上测试过,运行良好-TI DSP2812 the can main line procedure, may use this programming can main line receiving and dispatching data, has already tested on own development board, the movement is good
上传时间： 2015-12-03
上传用户：ls530720646
This project aim was to build wireless software modem for data communication between two computers using an acoustic interface in the voice frequency range (20Hz– 20,000Hz). The transmitting antenna is a speaker (frequency response of: 90Hz – 20,000Hz) and the receiving antenna is a microphone (frequency response of: 100Hz – 16,000Hz). The test files used as information files were text files. This goal was attained both in an incoherent scheme and in a coherent scheme. Build under Matlab code, our modem uses OFDM (orthogonal frequency division multiplexing) modulation, synchronization by LMS sequence, channel estimation (no equalizer) via pilot tones. The symbols are either PSK or ASK for a constellation size of 2 or 4. To optimize the probability of error, these symbols were mapped using Gray mapping. Report
标签： communication computers software wireless
上传时间： 2014-05-29
上传用户：wangdean1101
SMSTransceiver (short message service transmitter and receiver [transceiver]) is a tool for sending and receiving SMS via a serial or infrared connection between PC and a mobile phone.
标签： SMSTransceiver transmitter transceiver receiver
上传时间： 2014-01-04
上传用户：han_zh
