This source code is for using CM8880 generator and recognition phone pulses and calling algoritm for pic 16f877
标签： recognition and for generator
上传时间： 2014-01-27
上传用户：xc216
Spectral analysis of Gaussian pulses
标签： Spectral Gaussian analysis pulses
上传时间： 2014-11-27
上传用户：tyler
Most satellite dish actuators send a series of pulses to indicate their position. By counting pulses the positioner knows where the dish is pointing. It is possible to use a serial port and Linux with RTAI patches in order to count these pulses, thus minimising the external hardware required for a positioner. The zip contains instructions, circuit diagrams and example code.
标签： satellite actuators counting indicate
上传时间： 2014-12-03
上传用户：netwolf
The SN65LBC170 and SN75LBC170 aremonolithic integrated circuits designed forbidirectional data communication on multipointbus-transmission lines. Potential applicationsinclude serial or parallel data transmission, cabledperipheral buses with twin axial, ribbon, ortwisted-pair cabling. These devices are suitablefor FAST-20 SCSI and can transmit or receivedata pulses as short as 25 ns, with skew lessthan 3 ns.These devices combine three 3-state differentialline drivers and three differential input linereceivers, all of which operate from a single 5-Vpower supply.The driver differential outputs and the receiverdifferential inputs are connected internally to formthree differential input/output (I/O) bus ports thatare designed to offer minimum loading to the buswhenever the driver is disabled or VCC = 0. Theseports feature a wide common-mode voltage rangemaking the device suitable for party-lineapplications over long cable runs.
上传时间： 2013-10-13
上传用户：ytulpx
This project is created using the Keil ARM CA Compiler. The Logic Analyzer built into the simulator may be used to monitor and display any variable or peripheral I/O register. It is already configured to show the PWM output signal on PORT3.0 and PORT3.1 This ARM Example may be debugged using only the uVision Simulator and your PC--no additional hardware or evaluation boards are required. The Simulator provides cycle-accurate simulation of all on-chip peripherals of the ADuC7000 device series. You may create various input signals like digital pulses, sine waves, sawtooth waves, and square waves using signal functions which you write in C. Signal functions run in the background in the simulator within timing constraints you configure. In this example, several signal functions are defined in the included Startup_SIM.INI file.
标签： the Analyzer Compiler project
上传时间： 2013-12-19
上传用户：Yukiseop
Decoding most of the infrared signals can be easily handled by PIC16C5X microcontrollers. This application note describes how this decoding may be done. The only mandatory hardware for decoding IR signals is an infrared receiver. The use of two types is described here. Both are modular types used often by the consumer electronics industry. The first type responds to infrared signals modulated at about 40 kHz. The second responds to non-modulated infrared pulses and has a restricted range. The hardware costs of each approach will be less than two dollars.
标签： microcontrollers Decoding infrared handled
上传时间： 2015-05-24
上传用户：ruan2570406
