虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

primary

  • IEEE_Verilog_2001

    The Verilog Hardware Description Language (HDL) is defined in this standard. Verilog HDL is a formal notation intended for use in all phases of the creation of electronic systems. Because it is both machine readable and human readable,it supports the development,verification, synthesis,and testing of hardware designs; the communication of hardware design data; and the maintenance,modification,and procurement of hardware. The primary audiences for this standard are the implementors of tools supporting the language and advanced users of the language.

    标签: ieee verilog

    上传时间: 2021-11-09

    上传用户:

  • 50W隔离型离线式DC.pdf

    ABSTRACTThe flyback power stage is a popular choice for single and multiple output dc-to-dc converters at powerlevels of 150 Watts or less. Without the output inductor required in buck derived topologies, such as theforward or push-pull converter, the component count and cost are reduced. This application note will reviewthe design procedure for the power stage and control electronics of a flyback converter. In these isolatedconverters, the error signal from the secondary still needs to cross the isolation boundary to achieveregulation. By using the UC3965 Precision Reference with Low Offset Error Amplifier on the secondaryside to drive an optocoupler and the UCC3809 Economy primary Side Controller on the primary side, asimple and low cost 50 Watt isolated power supply is realized.

    标签: 隔离

    上传时间: 2021-11-24

    上传用户:kingwide

  • IW3617 230V 调光设计参考.pdf

    General Design Specification:1. AC Input Range 180-264Vac, Isolated ac-dc offline, 12LEDS,Output 700mA2. Intelligent wall dimmer detections(Leading-edge dimmer , Trailing-edgedimmer , No-dimmer)3. Multiple dimming control scheme4. Wide dimming range from 1% up to 100%5. No visible flicker6. Resonant control to achieve high efficiency7. High Power Factor, 0.9 without dimmer8. Temperature degrade control to adjust the LED9. primary-only Sensing eliminates opto-isolator feedback and simplifies design

    标签: iw3617

    上传时间: 2021-12-03

    上传用户:canderile

  • 基于模型—数据融合的中国区域碳水通量动态模拟及分析

    准确量化和预测陆地生态系统碳水通量对于理解陆气间相互作用,预测未来气候变化和控制温室效应具有重要意义。通量观测和模型模拟是目前研究碳水通量的两种主要方法。通量观测精度较高,但观测范围局限、站点分布不均匀,易受环境影响,难以区域扩展;模型模拟可实现不同尺度参量估算,但由于理想化假设、模型参数和驱动数据等限制,导致其模拟结果往往与真实值存在较大偏差。模型-数据融合方法主要是通过参数估计和数据同化两种技术集成观测和模型信息,建立两者相互制约调节的优化关系,以提高模型结果与真实值之间的匹配程度。基于该思路,本研究在地面观测数据、遥感卫星资料以及相关气候环境数据基础上,重点突破全球动态植被模型(Lund-Potsdam-Jena Dynamic Globa Vegetation Model.LPJ-DGVM)敏感参数优化方法,获取适宜中国的参数化方案:在此基础上,引入数据同化算法,将遥感卫星产品信息与模型相融合,在模拟过程中不断校正原有模型模拟轨迹,提高模型适用性。将以上改进的模型推广至中国区域,实现对20002015年中国地区总初级生产力(Gross primary Productivity GPP)和敬发(Evapotranspiration,ET的空间格局模拟及分析。主要结论如下1)将LP」DGwM中所选出的22个可调参数(涉及光合、呼吸、水平衡异速生长、死亡、建立以及土壤和掉落物分解共七个作用领域)在各自取值范围内随机获得不同的参数组合,结果表明22个参数可引起GPP和ET模拟结果产生较大的不确定性,尤其集中在生长季。所有站点GPP相对不确定性(Relative Uncertainty,RU)基本保持在09-1.25之间,不具有明显的年际变异性:ET相对不确定性RU月变化趋势明显,且基本处于0.5以下,明显低于GPP,说明所筛选的22个参数对GP模拟产生的影响更为显著。

    标签: 数据融合

    上传时间: 2022-03-16

    上传用户:shjgzh

  • Qi无线充电原理

    近距电能传输——高效安全近距电能传输一般基于电磁感应原理进行。在此技术基础上,当接收器邻近发射器时才会进行电能传输。电磁感应技术的历史长达百年,多年米一直应用于各类电子产品中—如此普及全因其简单、高效以及安全技术概览以下将为你简要介绍无线电能传输技术。System Overview(Communication)Receiver sends messagesTo provide control information to the transmitterBy load modulation on the power signaTransmitter receives messagesTo receive control information frorn the recelverBy de-modulation of the reflected loadPower Pick Up( Receiver)Secondary coil (L Serial resonance capacitor (C) for efficient power transfer Parallel resonance capacitor(C, )for detection purposes Rectifier: full bridge(diode, or switched)+ capacitor Output switch for(dis)connecting the loadReceiver modulates load by Switching modulation resistor(R,n),or Switching modulation capacitor(Ca)Transmitter de-modulates reflected load by Sensing pnmary coil curent (p)and/o Sensing primary coil voltage (V,

    标签: qi 无线充电

    上传时间: 2022-03-31

    上传用户:

  • sony CMOS传感器 IMX385LQR-C DataSheet

    DescriptionThe IMX385LQR-C is a diagonal 8.35 mm (Type 1/2) CMOS active pixel type solid-state image sensor with a squarepixel array and 2.13 M effective pixels. This chip operates with analog 3.3 V, digital 1.2 V, and interface 1.8 V triplepower supply, and has low power consumption. High sensitivity, low dark current and no smear are achieved throughthe adoption of R, G and B primary color mosaic filters. This chip features an electronic shutter with variablecharge-integration time.(Applications: Surveillance cameras)

    标签: CMOS传感器 IMX385LQR-C

    上传时间: 2022-06-18

    上传用户:

  • sony CMOS传感器 IMX178LQJ-C dataSheet

    sony CMOS传感器datasheet,IMX178LQJ-C_Data_SheetDescriptionThe IMX178LQJ-C is a diagonal 8.92 mm (Type 1/1.8) CMOS active pixel type image sensor with a square pixelarray and 6.44 M effective pixels. This chip operates with analog 2.9 V, digital 1.2 V and interface 1.8 V triple powersupply, and has low power consumption.High sensitivity, low dark current and no smear are achieved through the adoption of R, G and B primary colormosaic filters.This chip features an electronic shutter with variable charge-integration time.(Applications: Surveillance cameras, FA cameras, Industrial cameras)

    标签: CMOS传感器 IMX178LQJ-C

    上传时间: 2022-06-18

    上传用户: