设计一种基于AT89C52的语音录放系统,利用单片机、ISD2560语音录放器件、麦克风、扬声器等元器件实现硬件电路的设计,并利用C51高级语言设计ISD2560器件控制字的写入和定时中断程序。经软硬件调试,结果表明该系统录放效果良好,具有一定的工程实用价值。 Abstract: Voice recording and playback system based on AT89C52is designed in this paper.Using the single-chip microcomputer,voice recording and playback chip ISD2560,microphone and speaker to realize the hardware circuit design.Writing ISD2560control words and timing interrupt procedures are designed by C51advanced language.Through the hardware and software test,voice recording and playback system play better voice,and this system has some engineering practical values.
上传时间: 2013-10-20
上传用户:ywcftc277
针对盘山路存在的转弯盲区,即在转弯时司机无法得知弯路对面是否有车辆通过,设计一种基于C8051F310的山路转弯预防警示系统。该系统利用一阶滤波算法检测山路转弯时是否有车辆通过。运用该算法可增强系统检测的实时性,提高检测机动车辆的灵敏度,同时大大减少环境温度对检测的干扰。试验表明该系统能够正确指示出在山路转弯时是否有车辆通过,目前该系统已安装在盘山路上,可大大减少事故的发生率。 Abstract: Aiming at passing hilly road,there is a turn blind spot.Motormen usually do not know if the passing of vehicles pass the road.So a system of defending accident on hilly road is designed,which is based on MCU C8051F310.The sys-tem uses the first-order filter algorithm to detect whether there are passing vehicles.This algorithm enhances the real-time detection and improves the sensitivity of detection vehicles.Meanwhile,it reduces the detection interference of environmen-tal temperature.The experimental results show that this system can exactly indicate if there are passing vehicles.At present,the system has been successfully applied to hilly road.The system can greatly decrease accident.
上传时间: 2013-10-10
上传用户:归海惜雪
介绍一种基于C8051F060单片机和NAND Flash的数据采集存储系统,该系统可实现3路信号采样,每路采样率为5KS/s,通过异步串行通信接口实现数据传输。并详细说明系统的软件设计。 Abstract: An acquisition and storage system based on C8051F060and NAND Flash is designed in this paper.The system is used to sample three-channel of signal,5KSPS each channel,and can upload data to test bench through UART(Universal Asynchronous Receiver/Transmitter).The software design is discussed in detail.
上传时间: 2013-10-12
上传用户:Jesse_嘉伟
采用单片机AT89C2051实现温度测量与控制,键盘和显示电路实现温度的设定、修改、清零以及当前温度值的显示,并对温度超过上下限进行报警。阐述了该系统设计的硬件和软件设计。 Abstract: The system of temperature measuring and controling is realized based on AT89C2051.The keyboard and display circuit is designed,which can be used for setting and modifying temperature value,resetting and displaying the present temperature value.At the same time the warning circuit is also designed in the system,which can deal with the alarm when temperature exceeds the upper limit and the lower limit.The hardware and software design of the system are explained.
上传时间: 2013-11-18
上传用户:leehom61
针对众多低成本数据采集需求,采用带有片上USB控制器和D/A转换器的混合信号微处理器C8051F340,设计了一款可通过USB接口和LabVIEW图形用户界面实现与PC机联机的数据采集器,同时借助系统的SD卡存储独立实现现场长时间采集数据。该数据采集器成本低,结构简单,体积小,已成功用于工业现场。 Abstract: Aiming at the need of low cost data acquisition, a data acquisition device is designed based on C8051F340 which is a mixed-signal microcontroller and integrates USB controller and A/D controller on a chip.The data acquisition device which can combine with PC by USB interface and LabVIEW graphical user interface,can realize data acquisition. At the same time,it can be solely run a long time in virtue of SD card in field.The date aequisition device features low cost,simple structure and little sharp, and it has been used in industry field.
上传时间: 2014-05-31
上传用户:1109003457
为了解决磁放大器性能测试过程中,需要对其供给不同数值恒定电流的问题,设计了一种基于DAC7512和单片机的数控恒流源系统。该系统采用AT89C51作为主控器件,将计算机发送的电流控制字命令转换为D/A转换器控制字,通过模拟SPI通信接口,写D/A控制字到DAC7512,从而控制其输出相应数字电压值,经差动缩放电路、电压/电路变换电路和功率驱动电路,最后输出恒定电流。实验结果表明,恒流源输出电流调节范围为-45~+45 mA、精度为±0.1 mA,分辨率达0.024 4 mA,具有应用灵活,外围电路简单,可靠性高的特点。该数控直流恒流源也可为相关产品的测试系统研发提供参考。 Abstract: In order to solve the need to supply different values constant current for the magnetic amplifier in testing process, numerical control constant current source system was designed based on DAC7512 chip and microcontroller technology. The system used the AT89C51 as the main chip, which can convert the current control word from computer into to D/A control words. And the system wrote D/A control word into the DAC7512 chip to control the output voltage value by the SPI communication interface, which can output corresponding constant current figures by scaling circuit, the V/I converter and power drive circuit. Experimental results show that the current source output current adjustment range is -45~+45mA, accuracy is ± 0.1mA, and resolution ratio is 0.024 4mA
上传时间: 2014-12-27
上传用户:invtnewer
通过对程控滤波器的理论分析,在研究MAX262的功能和单片机的SPI总线通信的基础上,提出了基于MAX262的程控滤波器设计方案,设计了程控滤波器的软硬件,并给出了测试结果。 Abstract: By analyzing the programmable filter,the paper puts forward a programmable filter system design based on MAS262 on basic of studying MAS262 features and SPI bus communication.Software and hardware of the programmmable filter are designed,and the test result is given.
上传时间: 2013-11-15
上传用户:wxhwjf
以AVR单片机ATmega8和USB接口器件PDIUSBD12为核心,基于标准的USB1.1协议,设计一种通用USB接口模块,以满足嵌入式系统中对USB接口的需求。对模块的硬件电路或单片机固件程序的硬件接口层稍加修改即可用于其他各种微处理器。该模块可为各种嵌入式系统增加USB接口,实现与USB主机系统通信。 Abstract: Based on AVR microcontroller ATmega8 and USB interface chip PDIUSBD12, a general USB interface module is designed according to USB1.1 protocol for various requirements of embedded systems. Only with few modifications in circuit or hardware abstract layer of firmware, the module can be used on many types of microprocessors. All kinds of embedded systems can realize high speed and stable communication with USB host systems, owing to the facility of this module.
上传时间: 2014-01-08
上传用户:赵云兴
介绍了电力操作电源与智能电池巡检系统的特点,给出了一种基于超低功耗单片机MSP430 F149针对中小型变电站自动化运行的专用设备的基本设计原理及实现方法,最后给出了详细硬件构成和软件实现。该系统能满足中小型变电站安全、可靠、自动运行的要求,并通过与上位机的串行通信实现变电站的远程管理和控制。 Abstract: The characters of the intelligent battery data logging system of the electric operation power are introduced.The basic design principle and the implemented methods of the special equipment which only designed for the middle or small transformer substation based on MSP430F149 are prescribed. Finally, the hardware block diagram and the software flow chart are also given. The function that the system finally needs to realize can basically meet with the middle or small transformer substation’s satisfy, reliably,and automatic running.And it can also realize the transformer substation long-distance management and control by serial communicating with the host computer.
上传时间: 2013-11-25
上传用户:黄华强
为解决输油管道温度压力参数实时监测的问题,设计了以C8051F930单片机作为控制核心的超低功耗输油管道温度压力远程监测系统。现场仪表使用高精度电桥采集数据,通过433 MHz短距离无线通信网络与远程终端RTU进行通信,RTU通过GPRS网络与PC上位机进行远程数据传输,在上位机中实现数据存储和图形化界面显示,从而实现输油管道温度压力参数的实时监测和异常报警。经实验证明,该系统的12位数据采集精度满足设计要求,漏码率小于1%,正常工作时间超过5个月,能实时有效地监测输油管道的温度压力参数,节省大量人工成本,有效预防管道参数异常造成的经济损失和环境污染。 Abstract: In order to solve the problems on real-time monitoring of pipeline temperature and pressure parameters, the ultra-low power remote pipeline temperature and pressure monitoring system was designed by using the single chip processor C8051F930 as the control core. The high-precision electric bridge was used in field instruments for data collection, the 433MHz short-range wireless communication network was used to make communication between field instrument and RTU, the GPRS was used by the RTU to transmit data to the PC host computer, and the data was stored and displayed in the PC host computer, so the real-time monitoring and exception alerts of pipeline temperature and pressure parameters were achieved. The experiment proves that the system of which error rate is less than 1% over five months working with the 12-bit data acquisition accuracy can effectively monitor the pipeline temperature and pressure parameters in real time, it saves a lot of labor costs and effectively prevents environmental pollution and economic losses caused by abnormal channel parameters.
上传时间: 2013-11-07
上传用户:cuibaigao