这是一个带声音的弹球小游戏，通过VGA口显示，通过扩展口JA的 pin4和 pin GND输出声音， BTN3 BTN2 控制挡板左右移动，弹球和挡板都自带动画效果
标签： 小游戏
上传时间： 2013-11-29
上传用户：Miyuki
手机硬件图，夏新手机芯片pin脚位置说明
标签： 手机硬件
上传时间： 2016-12-07
上传用户：远远ssad
The FM24C256/C256L/C256LZ devices are 256 Kbits CMOS nonvolatile electrically erasable memory. These devices offer the designer different low voltage and low power options. They conform to all requirements in the Extended IIC 2-wire protocol. Furthermore, they are designed to minimize device pin count and simplify PC board layout requirements.
标签： 256 electrically nonvolatile erasable
上传时间： 2016-12-11
上传用户：lps11188
The SP486 and SP487 are low–power quad differential line drivers meeting RS-485 and RS-422 standards. The SP486 features a common driver enable control the SP487 provides independent driver enable controls for each pair of drivers. Both feature tri–state outputs and wide common–mode input range. Both are available in 16–pin plastic DIP and SOIC packages.
标签： differential and standard drivers
上传时间： 2014-01-13
上传用户：tianyi223
这个程序用于控制你的UMTS PCCard，输入SIM PIN码，发送和接收SMS短信，并监控网络连接。
上传时间： 2017-03-30
上传用户：梧桐
This is a source of 13.560MHz RFID card reader for TRH031M as ATMEGA8-16AU MPU. The title is 3Alogics TRH031M 13.56MHz RFID Reader V1.0. project : RFID Reader V2.0 Target : MEGA8-16AU Crystal: 16.000 Mhz Input : TRH031M RFID 13.56MHz Output : RS232C 115200,N,8,1 Compiler : ICC-AVR V6.26C // Pin configuration for ATMEGA8-16AU TQFP32 // #30 RXD <--- RXD (SP3232) // #31 TXD ---> TXD (SP3232) // #32 PD2/INT0 <--- INTR (TRH031M) // # 1 PD3/INT1 ---> RST (TRH031M) // # 2 PD4 ---> D4 (TRH031M) // # 9 PD5 ---> D5 (TRH031M) // #10 PD6 ---> D6 (TRH031M) // #11 PD7 ---> D7 (TRH031M) // #12 PB0 ---> D0 (TRH031M) // #13 PB1 ---> D1 (TRH031M) // #14 PB2 ---> D2 (TRH031M) // #15 PB3 ---> D3 (TRH031M) // #16 PB4 ---> CSB (TRH031M) // #17 PB5 ---> LED // #23 PC0 ---> A0 (TRH031M) // #24 PC1 ---> A1 (TRH031M) // #25 PC2 ---> A2 (TRH031M) // #26 PC3 ---> ALE (TRH031M) // #27 PC4 ---> /RD (TRH031M) // #28 PC5 ---> /WR (TRH031M)
标签： 13.560 ATMEGA 3Alogi source
上传时间： 2017-03-31
上传用户：s363994250
The AT24C512 provides 524,288 bits of serial electrically erasable and programmable read only memory (EEPROM) organized as 65,536 words of 8 bits each. The device鈥檚 cascadable feature allows up to four devices to share a common two-wire bus. The device is optimized for use in many industrial and commercial applications where lowpower and low-voltage operation are essential. The devices are available in spacesaving 8-pin PDIP, 8-lead EIAJ SOIC, 8-lead JEDEC SOIC, 8-lead TSSOP, 8-lead Leadless Array (LAP), and 8-lead SAP packages. In addition, the entire family is available in 2.7V (2.7V to 5.5V) and 1.8V (1.8V to 3.6V) versions.
标签： electrically programmable provides erasable
上传时间： 2017-04-09
上传用户：cc1015285075
第一代Sandstorm家族，与JTAG复用的GPIO可以直接配置。但是不够安全，意外的配置有可能导致JTAG连接失效。 对于第二代Fury和第三代DustDevil家族，由于GPIOLOCK等寄存器的保护，相关Pin默认为JTAG功能而不允许直接配置为GPIO功能。如果要想配置为GPIO功能，则必须首先执行解锁操作。 详见GPIO文档和例程。
上传时间： 2017-04-10
上传用户：wkchong
this is a document relating to the davicom ic Dm9000. this document has inportant programming tips relating to the DM9000 hardware pin IOR.
标签： document this programming inportant
上传时间： 2017-06-02
上传用户：气温达上千万的
The objective is to set up SPI communication between VTI Technologies digital pressure sensor component and an MCU of an application device ATMEGA16L. In this code example: ?The MCU is configured ?SCP1000-D01 is initialized and configured ?The high resolution measurement mode is activated ?Temperature and pressure information is read always when the DRDY pin is in high state Please refer to the document "SCP1000 Product Family Specification 8260800" for further information on SCP1000 register addressing and SPI communication. This document applies to the SCP1000-D01.
标签： communication Technologies objective pressure
上传时间： 2017-06-17
上传用户：youmo81
