虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

operation-centric

  • 微处理器dsPIC33F在微机保护装置中的应用

    数字信号处理器dsPIC33F集多通道高精度A/D转换、多通讯模式、看门狗、CMOS Flash技术等于一体,其内部可完成所有数据操作,实现总线不出芯片技术。将该处理器应用于微机保护装置,提出基于dsPIC33F微处理器的微机保护装置的设计方案,给出相应的接口电路与软件流程。该设计方案结构简单,性价比及可靠性高,开发周期短,具有一定的实用推广价值。所研制的微机保护装置现场运行效果良好。 Abstract:  The dsPIC33F microprocessor has a plentiful interior resource which contains multi-channel,high precision A/D converters,multi-communication module,watchdog,CMOS Flash technology,and so on.All data manipulations is accomplished interiorly.What is more,it makes the technology that bus does not go beyond the chip comes into practice.The paper put forwards a design scheme based on dsPIC33F microprocessor.The scheme has the advantages of simple structure,high reliability and shortened exploitation cycle.What is more,it has definite practicality and reference.The microcomputer protection device has been put into operation with excellent effects.

    标签: dsPIC 33F 33 微处理器

    上传时间: 2013-11-16

    上传用户:开怀常笑

  • 基于ATmega16的标记机控制系统

    介绍了当前普通标记机控制系统现状及其存在缺点,给出气动标记机及相频修正PWM模式的工作原理。采用ATmega16单片机和USB转换RS232接口器件CH341T实现驱动控制系统与PC的实时通讯,标记控制系统可升级到USB接口。采用基于ATmega16的相频修正PWM替换555振荡电路产生的PWM,可直接通过软件调整PWM信号。使用达林顿三极管TIP122替代直流继电器驱动高频电磁阀,使得电磁阀驱动电路简单,成本低廉。该控制系统已成功应用于气动标记机。 Abstract:  In this paper,the actuality and demerit of the common gas marking machine control systems are described.The operation principle of the gas marking machine and the phase and frequency correct PWM of ATmega16is introduced.The real-time communication between the driving control system and PC by CH341T which its function is translated USB to RS232is realized,the control systems is updated grade to USB interface.The PWM signal can be adjustable by software for the555surge circuit was substituted by the phase and frequency.The high frequency electromagnetic value’s driving circuit by DC relay is replaced by TIP122,therefore,the circuit is become simple and the cost cheap.The control systems has been widely used in gas marking machine.

    标签: ATmega 16 标记 控制系统

    上传时间: 2013-10-18

    上传用户:1427796291

  • 基于AT89C52单片机的温度巡回检测系统设计

    阐述了一个由上位PC机和AT89C52下位单片机组成的主从分布式温度巡回检测系统。主从机采用RS-485 串行通讯标准进行通信,可在下位单片机实现基本的温度数据巡回检测基础上,由上位PC机实现综合处理功能或扩展为远程操作。整个系统具有巡检速度快,扩展性好的特点。 Abstract:  In this paper,a top PC and AT89C52 under-bit microcontrollers from the main component of the tour distributed temperature detection system is presented. Master and slave can use RS-485 serial communication standards for communications.Based on next-bit machine for basic goods temperature detected data Tour, the top can achieve the integrated treatment of PC functions or for the expansion of long-distance operation. The entire inspection system is fast, expansion.

    标签: 89C C52 AT 89

    上传时间: 2013-10-13

    上传用户:zhoujunzhen

  • NXP P89LPC901单片机汽车起动保护控制器设计

    在汽车发动机起动时,若发动机起动后起动机不能及时断电,将会烧毁起动机或损坏飞轮齿环;若变速器不在空档位置起动,则起动机的瞬间动力将使汽车位移,还可能引起交通事故和人身安全。为此介绍一种利用NXP P89LPC901单片机控制的汽车起动保护控制器,通过检测汽车起动开关、变速箱档位、发动机转速,实现对汽车发动机起动过程检测和保护。起动保护控制器在发动机起动过程中通过采用逐个关闭打开负载系统,解决汽车发动机过程中因起动电流大而对汽车电源的冲击影响,延长了电瓶寿命。 Abstract:  When the automotive engine is started, the engine start motor and flywheel gear may be damaged, even traffic accidents and personal safeties may be caused by wrong operation or other factors.In order to ensure the automotive engine can be started normally and safely,it is necessary that the protecting measures and methods are considered in the automotive electrical control system.This paper introduces a kind of the automotive engine starting protect controller based on NXP P89LPC901 MCU.The controller can protect the engine starting process by detecting the starter key switch,transmission stall and engine speed.Through the use of close and open load system,the controller can solve the impact on automotive power because of the high-current load in the process of the automobile engine starting, and extend battery life.

    标签: NXP LPC 901 P89

    上传时间: 2013-10-15

    上传用户:mikesering

  • 基于C8051F020的触摸屏驱动控制

    C8051F020单片机通过SPI接口驱动四线电阻式触摸屏控制器TSC2046,利用中断方式驱动TSC2046设计软件。介绍了触摸屏的工作原理、TSC2046工作方式以及典型应用电路。 Abstract:  The C8051F020 MCU is connected with the TSC2046 which is a 4-wire touch screen controller. The TSC2046 is controlled by interrupt mode, the? operation principle of touch screen is introduced. The operation mode of TSC2046 and typical application circuit are also discussed.

    标签: C8051F020 触摸屏 驱动控制

    上传时间: 2014-12-27

    上传用户:hwl453472107

  • 基于C8051F320的模拟枪战系统设计

    提出了一种基于C8051F320的红外模拟枪战系统设计方案。介绍了红外模拟枪战系统的构成,给出了硬件选型、系统硬软件设计。利用红外抗对系统的工作原理,系统获得良好效果。 Abstract:  This paper presents the design of simulated gunfight system based on C8051F320.Introduces system structure,and puts forward hardware selection of infrared simulated gunfight system and system hardware and software designs.Using the operation principle of infrared antagonizing system,the system result is good.

    标签: C8051F320 模拟 系统设计

    上传时间: 2013-11-20

    上传用户:南国时代

  • 基于MPC555与CS8900A的以太网扩展设计

       介绍了MPC555与CS8900A扩展以太网的硬件设计图。以NUCLUES PLUS操作系统为基础,介绍了网卡软件驱动程序的编制,给出了以太网协议包嵌入NUCLEUS PLUS操作系统的实现方法。 Abstract:  The Ethernet extension hardware design of MPC555 and CS8900A are introduced,and the software driven program based on NUCLEUS PLUS operation system and the technique that Ethernet protocol embedded in NUCLEUS PLUS real operation system are discussed.

    标签: 8900A 8900 MPC 555

    上传时间: 2013-10-23

    上传用户:xiehao13

  • 基于MSP430F149的智能电池巡检系统的设计

    介绍了电力操作电源与智能电池巡检系统的特点,给出了一种基于超低功耗单片机MSP430 F149针对中小型变电站自动化运行的专用设备的基本设计原理及实现方法,最后给出了详细硬件构成和软件实现。该系统能满足中小型变电站安全、可靠、自动运行的要求,并通过与上位机的串行通信实现变电站的远程管理和控制。 Abstract:  The characters of the intelligent battery data logging system of the electric operation power are introduced.The basic design principle and the implemented methods of the special equipment which only designed for the middle or small transformer substation based on MSP430F149 are prescribed. Finally, the hardware block diagram and the software flow chart are also given. The function that the system finally needs to realize can basically meet with the middle or small transformer substation’s satisfy, reliably,and automatic running.And it can also realize the transformer substation long-distance management and control by serial communicating with the host computer.

    标签: 430F F149 MSP 430

    上传时间: 2013-11-25

    上传用户:黄华强

  • 基于ADuC841的膜片钳放大器系统设计

    为降低成本和解决现有膜片钳放大器系统中PC机的干扰问题,研究了一种基于单片机的膜片钳放大器小系统。该系统采用ADI公司生产的ADuC841作为控制核心,并且配置相应的液晶显示模块LCM3202401。模拟电路部分采用高输入阻抗的AD8627实现微电流信号的采集,并由后级电路进行信号的放大和电阻电容的补偿。它具有硬件电路简单、体积小、使用方便的特点。既可以单独作为小系统实现采集和显示,也可以通过红外方式和PC机进行通讯,在PC机上进行信号的处理。 Abstract:  In order to reduce cost and resolve the interferential problem with PC in existing patch clamp amplifiers, a small patch clamp amplifier system design based on microcontroller is studied. It adopts a new high performance microconverter ADuC841 by the ADI as the control core in the system, configuring a liquid crystal module LCM3202401. In the analog circuit, AD8627 with high input impedance is used to detect the low current,signal magnification, as well as resistance and capacitance compensation are accomplished by subsequent circuits. It has the advantage of simple hardware circuit design, small volume and convenient operation. It can either be used as an independent system to measure and show signal detected or transmit to PC by infrared ray.

    标签: ADuC 841 膜片钳 放大器

    上传时间: 2013-11-06

    上传用户:yy_cn

  • 基于双ATmega128的安检力学试验机设计

    针对当前安检力学试验机所能完成的试验种类单一、自动化程度低等问题,提出一种以ATmega128单片机为核心控制器的安检力学试验机的设计。详细阐述了该安检力学试验机各个组成部分的设计原理和方案,并且给出了各部分的软件设计思想和操作流程。经过大量测试试验表明:设计的安检力学试验机可以完成多达十余种的力学安检试验,完全符合相关国家标准,并且具有数据采集精度高、传输速度快、操作安全简便等特点,实现了安检设备的多功能化、数字化和自动化。 Abstract:  Currently, many mechanical security testing machines have only one function. The degree of automation of them is low. To solve those problems, a new kind of mechanical security testing machine, using ATmega128 micro-controller as its core controller, has been advanced. It describes the components of the machine. The principles and the scheme in the designing processes are presented in detail, and the software architecture and the operation processes of each part are given. After having done many testing, we have reached the following conclusions: the mechanical security testing machine presented can do over ten mechanical security tests complying with related national standards. It has high data acquisition accuracy and high transmission speed. The operation of the machine is simple and safe. In general, this machine is a multi-functional, highly automatic, digitalized security testing device.

    标签: ATmega 128 安检 试验机

    上传时间: 2013-11-05

    上传用户:a67818601