虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

mID-point

  • 基于单总线式无线温度采集系统设计

    为提高温度测量效率,降低系统的成本,扩展传输距离,设计出一种新型温度采集系统。单片机通过控制具有单总线方式的温度传感器DS18B20实现对温度的测量,同时单片机通过控制具有单总线方式300~450MHz频率范围内的MAX7044与MAX7033无线发射与接收芯片实现温度数据的无线传输。与传统温度采集系统相比,该系统利用单总线方式连接,采用无线传输方式实现远距离通信,易于系统的集成与扩展。实验结果表明,该系统结构简单、方便移植,能够同时实现多达上百点温度的测量与500m范围的传输。 Abstract:  To improve the temperature measurement efficiency and reduce system cost,expansion of transmission distance,a new type of temperature acquisition system is designed.Microcontroller controlled temperature sensor DS18B20which has a single-bus achieves temperature measurement,while microcontroller by controlled the MAX7044and MAX7033chip with a single-bus and having300~450MHz radiofrequency to achieve the wireless transmission of temperature data.Compared with conventional temperature acquisition system,the system uses single-bus connected,and uses wireless transmission means to achieve long-distance communications,easy-to-system integration and expansion.The experimental results show that the system is simple,convenient transplantation,and can be implemented in as many as a hundred-point temperature measure-ment and the transmission range of500meters.

    标签: 单总线 无线温度 采集 系统设计

    上传时间: 2013-10-29

    上传用户:515414293

  • 基于MS5534B的微功耗气压数据采集

    气压是气象监测中的一个重要参数,提出了一种气压数据采集模块设计方案,该模块采用数字气压传感器MS5534B、MSP430单片机MSP430F2272和带实时时钟(RTC)64 KB铁电存储器。通过低功耗软件设计方法以微安级整体平均功耗实现了气压数据的采集和存储,适合电池供电的连续高精度气压采集应用。给出了模块的软硬件设计以及MS5534B的性能指标和使用经验。 Abstract:  Air pressure is an important parameter in weather monitor.This paper futs forward a new design scheme of low power-air pressure data acquisition module.The module uses a digital output barometer sensor MS5534B,MSP430 microcontroller MSP430F2272 and integrated RTC 64KB FRAM,precision air pressure measurement and storage chip.Another point of this module is low power consumption, so it is well suited for battery powered air pressure data acquisition applications. At the same time,the software and hardware deign of module is presented,And the speciaties and use notices of MS5534B are given.

    标签: 5534B 5534 MS 微功耗

    上传时间: 2014-12-27

    上传用户:drink!

  • 基于UC3854A控制的PFC中分岔现象仿真研究

       为深入了解基于UC3854A控制的PFC变换器中的动力学特性,研究系统参数变化对变换器中分岔现象的影响,在建立Boost PFC变换器双闭环数学模型的基础上,用Matlab软件对变换器中慢时标分岔及混沌等不稳定现象进行了仿真。在对PFC变换器中慢时标分岔现象仿真的基础上,分析了系统参数变化对分岔点的影响,并进行了仿真验证。仿真结果清晰地显示了输入整流电压的幅值变化对系统分岔点的影响。 Abstract:  In order to better understand the dynamics characteristic of power factor correction converter based on UC3854A, and make the way that parameters change influences the bifurcation phenomena of the system clearly. The math model of the two closed loop circuits to the Boost PFC (Power Factor Correction) converter controller was built. Then, with the help of Matlab, the simulation for nonlinear phenomena such as chaos and slow-scale bifurcation in the PFC converter was made. Finally the factors that have influence to the phenomenon of bifurcation under slow-scale in PFC converter were analyzed. The simulation results clearly show the parameters change influences the bifurcation point of the system.

    标签: 3854A 3854 PFC UC

    上传时间: 2013-10-17

    上传用户:杜莹12345

  • MPLAB C30用户指南(英文)

    MPLAB C30用户指南(英文) HIGHLIGHTSThe information covered in this chapter is as follows:• About this Guide• Recommended Reading• Troubleshooting• The Microchip Web Site• Development Systems Customer Notification Service• Customer Support Document LayoutThe document layout is as follows:• Chapter 1: Compiler Overview – describes MPLAB C30, development tools andfeature set.• Chapter 2: Differences between MPLAB C30 and ANSI C – describes thedifferences between the C language supported by MPLAB C30 syntax and thestandard ANSI-89 C.• Chapter 3: Using MPLAB C30 – describes how to use the MPLAB C30 compilerfrom the command line.• Chapter 4: MPLAB C30 Runtime Environment – describes the MPLAB C30runtime model, including information on sections, initialization, memory models, thesoftware stack and much more.• Chapter 5: Data Types – describes MPLAB C30 integer, floating point and pointerdata types.• Chapter 6: Device Support Files – describes the MPLAB C30 header and registerdefinition files, as well as how to use with SFR’s.• Chapter 7: Interrupts – describes how to use interrupts.• Chapter 8: Mixing Assembly Language and C Modules – provides guidelines tousing MPLAB C30 with MPLAB ASM30 assembly language modules.

    标签: MPLAB C30 用户 英文

    上传时间: 2013-10-21

    上传用户:13925096126

  • A Single-Chip Pulsoximeter Des

    This application report discusses the design of non-invasive optical plethysmographyalso called as pulsoximeter using the MSP430FG437 Microcontroller (MCU). Thepulsoximeter consists of a peripheral probe combined with the MCU displaying theoxygen saturation and pulse rate on a LCD glass. The same sensor is used for bothheart-rate detection and pulsoximetering in this application. The probe is placed on aperipheral point of the body such as a finger tip, ear lobe or the nose. The probeincludes two light emitting diodes (LEDs), one in the visible red spectrum (660nm) andthe other in the infrared spectrum (940nm). The percentage of oxygen in the body isworked by measuring the intensity from each frequency of light after it transmitsthrough the body and then calculating the ratio between these two intensities.

    标签: Pulsoximeter Single-Chip Des

    上传时间: 2013-10-27

    上传用户:黑漆漆

  • X-tal oscillators on 8-bit mic

    <Almost since the introduction of microcontrollers as electronic components there always has been an oscillatorcircuit on the device to make it work. From application point of view only some external components wererequired to make it work. However, to make sure that it will always work required more effort. This report is basedon feedback from the market from customers applying 8-bit mircrocontrollers.>

    标签: oscillators X-tal bit mic

    上传时间: 2013-11-12

    上传用户:穿着衣服的大卫

  • 基于单DSP的VoIP模拟电话适配器研究与实现

    基于单DSP的VoIP模拟电话适配器研究与实现:提出和实现了一种新颖的基于单个通用数字信号处理器(DSP)的VoIP模拟电话适配器方案。DSP的I/O和存储资源非常有限,通常适于运算密集型应用,不适宜控制密集型应用[5]。该系统高效利用单DSP的I/O和片内外存储器资源,采用μC/OS-II嵌入式实时操作系统,支持SIP和TCP-UDP/IP协议,通过LAN或者宽带接入,使普通电话机成为Internet终端,实现IP电话。该系统软硬件结构紧凑高效,运行稳定,成本低,具有广阔的应用前景。关键词:模拟电话适配器;IP电话;数字信号处理器;μC/OS-II 【Abstract】This paper presents a VoIP ATA solution based on a single digital signal processor (DSP). DSPs are suitable for arithmetic-intensiveapplication and unsuitable for control-intensive application because of the limitation of I/O and memory resources. This solution is based on a 16-bitfixed-point DSP and μC/OS-II embedded real-time operating system. It makes good use of the limited resources, supports SIP and TCP-UDP/IPprotocol. It can connect the analog telephone to Internet and realize the VoIP application. This system has a great future for its high efficiency andlow cost.【Key words】Analog telephone adapter (ATA); Voice over Internet protocol (VoIP); Digital signal processor (DSP); μC/OS-II Research and Implementation of VoIPATA Based on Single DSP

    标签: VoIP DSP 模拟电话 适配器

    上传时间: 2013-11-20

    上传用户:Wwill

  • 基于LabVIEW和单片机的空调温度场测量系统的研究

    基于LabVIEW和单片机的空调温度场测量系统的研究:室内温度是空调系统舒适性的重要指标,对其及时、准确地测量显得非常重要。介绍单片机AT89C51 和数字式、单总线型温度传感器DS18B20 组成矩形测量网络采集空调室内40 点温度,LabVIEW作为开发平台,二者之间通过串口实现数据通信,利用LabVIEW强大的数据处理和显示功能对采集的空调温度场数据进行实时处理、分析和显示,详细介绍了系统的硬件结构和软件模块的设计方案。关键词:单片机;DS18B20 ;LabVIEW;串行通信 Abstract : Temperature is a very important criterion of air condition system′s comfort , so it is very significant to measure it accurately and real timely. This paper int roduces a data acquisition system of measuring 40 point s temperature for air condition room based on single wire digital sensor DS18B20 and microcont roller AT89C51 which are composed of rectangle measuring meshwork. The data communication between LabVIEW and microcont roller is executed via serial port ,and the temperature field data of air condition room are processed analyzed and displayed on LabVIEW. The hardware and software modules are also given in detail.Keywords : single chip ;DS18B20 ;LabVIEW; serial communication

    标签: LabVIEW 单片机 空调 温度场

    上传时间: 2014-05-05

    上传用户:KSLYZ

  • MPC106 PCI Bridge/Memory Contr

    In this document, the term Ô60xÕ is used to denote a 32-bit microprocessor from the PowerPC architecture family that conforms to the bus interface of the PowerPC 601ª, PowerPC 603ª, or PowerPC 604 microprocessors. Note that this does not include the PowerPC 602ª microprocessor which has a multiplexed address/data bus. 60x processors implement the PowerPC architecture as it is speciÞed for 32-bit addressing, which provides 32-bit effective (logical) addresses, integer data types of 8, 16, and 32 bits,and ßoating-point data types of 32 and 64 bits (single-precision and double-precision).1.1 Overview The MPC106 provides an integrated high-bandwidth, high-performance, TTL-compatible interface between a 60x processor, a secondary (L2) cache or additional (up to four total) 60x processors, the PCI bus,and main memory. This section provides a block diagram showing the major functional units of the 106 and describes brießy how those units interact.Figure 1 shows the major functional units within the 106. Note that this is a conceptual block diagram intended to show the basic features rather than an attempt to show how these features are physically implemented on the device.

    标签: Bridge Memory Contr MPC

    上传时间: 2013-10-08

    上传用户:18711024007

  • STM32TS60 数字电阻型多触摸屏控制方案

    ST 公司的STM32TS60 是集成了I2C,SPI,UART 和USB 接口的数字电阻型多触摸屏控制器, 能同时跟踪多达10 个单独的触摸,分辨率达0.17mm,触摸屏扫描速率达125 Hz 到 250 Hz, 主要用于游戏机,智能手机,PMP,PND,MID 和笔记本电脑.本文介绍STM32TS60 主要特 性,2.5”-6”屏单器件应用电路。    

    标签: STM 32 60 TS

    上传时间: 2013-10-21

    上传用户:dingdingcandy