This application note provides step-by-step instructions on how to recreate a Tri-Mode Ethernet(TEMAC) performance testing system using the ML405 board and MontaVista Linux 4.0. Thisapplication note shows how to set up a simple EDK Base System Builder system on the ML405Evaluation Platform and run performance tests. The network architecture for the test isdescribed. A system is built and downloaded into the FPGA. A MontaVista Linux kernel isconfigured, built, and downloaded into the ML405 Evaluation Platform. The instructions forobtaining and setting up the software used to perform the measurements, netperf, are given.
上传时间： 2013-11-11
上传用户：saharawalker
USB Manager(usbmgr) 0.4.8 Shuu Yamaguchi <shuu@wondernetworkresources.com> Special Helper: Philipp Thomas When USB devices connect to or disconnect from a USB hub, the usbmgr works as the following according to configuration. a) It loads and unloads files Linux kernel modules. b) It execute file to setup USB devices.
标签： wondernetworkresources Yamaguchi Manager Special
上传时间： 2014-01-27
上传用户：zhaiyanzhong
Jollen-Kit! 2006 是非常積極進行中的專案，所有紀錄與更新將同步揭示於本網頁。 快速下載 U-Boot 的 binary code：U-Boot binary - 2006/01/03 Linux kernel 2.4.18 for jk2410：uimage.img - 2006/01/06 可開機的 Base root filesystem： urootfs.img -2006/01/07 (without tftp) 可開機的 Base root filesystem： urootfs2.img -2006/03/10 (Busybox 1.10 with tftp) GNU cross toolchain：arm-9tdmi-linux-gnu.tar.gz (armpath by Joe) 安裝方法: # cd / (切換到 / 根目錄) # tar jxf <路徑>/arm-9tdmi-linux-gnu.tar.gz (將檔案解開) "Hello, World!" 在 ARM9 的範例：hello_arm.tar.gz (使用Makefile) 其它工具與原始碼下載 驅動程式模組
标签： Jollen-Kit 2006
上传时间： 2015-06-16
上传用户：xz85592677
x-load，一个非常有用的bootloader，用来直接从Nand lflash 启动嵌入式linux kernel
标签： x-load
上传时间： 2015-06-29
上传用户：cainaifa
Over the years, this bestselling guide has helped countless programmers learn how to support computer peripherals under the Linux operating system, and how to develop new hardware under Linux. Now, with this third edition, it s even more helpful, covering all the significant changes to Version 2.6 of the Linux kernel. Includes full-featured examples that programmers can compile and run without special hardware.
标签： bestselling programmers countless compute
上传时间： 2014-01-13
上传用户：小草123
Abstract: By using gateway systems on large 32-bit platforms, networks of small, 8- and 16-bit microcontrollers can be monitored and controlled over the Internet. With embedded Linux, these gateways are easily moved from full-blown host PCs to embedded platforms like the PC104. In this class you will learn about hardware platforms that support embedded Linux, Linux kernel configuration, feature selection, installation, booting and tuning.
标签： bit platforms Abstract networks
上传时间： 2014-01-05
上传用户：kytqcool
基于ecos的redboot，该包支持多种处理器。用户可以根据自己硬件平台，通过ecosconfig来配置，配置界面和编译linux kernel差不多。本包已经正对Intel IXP2400平台做了相应配置，硬件平台为双CUP架构。压缩文件中有更为详细的说明。
上传时间： 2014-01-09
上传用户：siguazgb
简要的讲解了一下，linux kernel的启动过程。
标签：
上传时间： 2016-02-15
上传用户：410805624
1.under bootloader 1)cd your_dir/mrua_EM8620L_2.5.115.RC8_dev.arm.bootirq/MRUA_src/loader 2)将flash_v3.c改名为flash.c替换原来的flash.c 3)编译 2.under linux kernel 1)cd armutils_2.5.108.0/build_arm/linux-2.4.22-em86xx/drivers/mtd 2)将mtdblock_v4.c改名为mtdblock.c替换原来的mtdblock.c 3)cd armutils_2.5.108.0/build_arm/linux-2.4.22-em86xx/drivers/mtd/chips 4)将cfi_cmdset_0002_v4.c改名为cfi_cmdset_0002.c替换原来的cfi_cmdset_0002.c 5)编译。 note:如果在使用cat等指令写flash的过程中出现下面的信息： Flash write to Buffer aborted @ 0x****** = 0x****** 是正常信息。
标签： bootloader MRUA_src your_dir bootirq
上传时间： 2013-12-17
上传用户：阳光少年2016
这本书非常之不错，详细介绍linux kernel source，对深入学习linux的人有很大帮助
标签：
上传时间： 2016-11-22
上传用户：jackgao
