UART RS-232 hyperterminal (ASM).rar，为ADI DSPBF533串口汇编的程序示例代码
标签： hyperterminal UART 232 ASM
上传时间： 2013-12-15
上传用户：tyler
This program allows reading or writing values to and from the DSP through hyperterminal serial port interface.
标签： hyperterminal program reading writing
上传时间： 2014-01-19
上传用户：gyq
This program writes a lcd hyperterminal and everything you type on your keyboard to pc, using codevisionavr.
标签： hyperterminal everything keyboard program
上传时间： 2013-12-17
上传用户：gundamwzc
This example provides a description of how to use the USART with hardware flowcontrol and communicate with the hyperterminal.First, the USART2 sends the TxBuffer to the hyperterminal and still waiting fora string from the hyperterminal that you must enter which must end by '\r'character (keypad ENTER button). Each byte received is retransmitted to thehyperterminal. The string that you have entered is stored in the RxBuffer array. The receivebuffer have a RxBufferSize bytes as maximum. The USART2 is configured as follow: - BaudRate = 115200 baud - Word Length = 8 Bits - One Stop Bit - No parity - Hardware flow control enabled (RTS and CTS signals) - Receive and transmit enabled - USART Clock disabled - USART CPOL: Clock is active low - USART CPHA: Data is captured on the second edge - USART LastBit: The clock pulse of the last data bit is not output to the SCLK pin
上传时间： 2013-10-31
上传用户：yy_cn
This is an excillent utility to connect your serial devices and see their output. It is a better utility than hyperterminal
标签： excillent connect devices utility
上传时间： 2017-06-29
上传用户：aeiouetla
Installation of PelcoNet NET300 requires support from your network administrator. Contact your administrator to assist with STEP 2A – Configuring PelcoNet Using hyperterminal. Write down the following information from your network administrator:
标签： your administrator Installation PelcoNet
上传时间： 2014-01-02
上传用户：钓鳌牧马
