A language monitor provides a full duplex communications path between the print spooler and bi-directional printers that are capable of providing software-accessible status information and adds printer control information, such as commands defined by a printer job language, to the data stream s.
标签： communications language bi-direc provides
上传时间： 2015-03-29
上传用户：comua
A software duplex UART for 8xc751 & 8cc752
上传时间： 2014-10-30
上传用户：linlin
duplex UART Routines for the 8xC751 and 8xC752 Microcontrollers
标签： Microcontrollers 8xC Routines duplex
上传时间： 2013-12-12
上传用户：yangbo69
MSP-FET430P140 Demo - USART1, SPI Full-duplex 3-Wire Master P1.x Exchange
标签： Full-duplex Exchange MSP-FET Master
上传时间： 2013-12-26
上传用户：nairui21
Implementing a Quad 1200 baud Full-duplex software UART with Salvo au1200的资料
标签： 1200 Implementing Full-duplex software
上传时间： 2014-06-20
上传用户：李彦东
Description: This program demonstrates a half-duplex 9600-baud UART using // Timer_A3 using no XTAL and an external resistor for DCO ROSC. DCO used for // TACLK UART baud generation. The program will wait in LPM4, echoing back // a received character using 8N1 protocol. On valid RX character, the // character is echoed back. // Using a 100k resistor on ROSC, with default DCO setting, set DCOCLK ~ 2MHz. // ACLK = n/a, MCLK = SMCLK ~2MHz DCOCLK
标签： using demonstrates Description half-duplex
上传时间： 2014-01-14
上传用户：cuiyashuo
本例展示了如何实现2个SPI之间的在全双工（full-duplex）模式下通信，通过NSS软件管理，实现了由主向从，接着又从向主发送数据。 在本例程中，设置SPI1和SPI2为8bit数据帧，9Mbit/s传输速率。 在第一阶段，由主SPI1把SPI1_Buffer_Tx发送到SPI2，由从SPI2把SPI2_Buffer_Tx发送到SPI1。传输完成后，通过比较判断传输是否正确。 由于NSS管脚由软件管理，因此，可以在不改变硬件配置的情况下使SPI1由主变从，而SPI2由从变主。在第二阶段，由从SPI1把SPI1_Buffer_Tx发送到SPI2，由主SPI2把SPI2_Buffer_Tx发送到SPI1。传输完成后，通过比较判断传输是否正确。 在STM3210B-LK1上，如果以上4个传输都正确，则亮起LED1（LD4），否则亮起LED2（LD3）。
标签： full-duplex SPI 全双工 模式
上传时间： 2017-01-31
上传用户：lz4v4
pic full duplex uart pic full duplex uart pic full duplex uart
上传时间： 2013-12-05
上传用户：jcljkh
Software uart using a general purpose io and an external interrupt pin of an atmel uc. half duplex operation, adjustable baud rate
标签： interrupt Software external general
上传时间： 2013-12-31
上传用户：zhangyigenius
The recent developments in full duplex (FD) commu- nication promise doubling the capacity of cellular networks using self interference cancellation (SIC) techniques. FD small cells with device-to-device (D2D) communication links could achieve the expected capacity of the future cellular networks (5G). In this work, we consider joint scheduling and dynamic power algorithm (DPA) for a single cell FD small cell network with D2D links (D2DLs). We formulate the optimal user selection and power control as a non-linear programming (NLP) optimization problem to get the optimal user scheduling and transmission power in a given TTI. Our numerical results show that using DPA gives better overall throughput performance than full power transmission algorithm (FPA). Also, simultaneous transmissions (combination of uplink (UL), downlink (DL), and D2D occur 80% of the time thereby increasing the spectral efficiency and network capacity
标签： Full-duplex Cells Small
上传时间： 2020-05-27
上传用户：shancjb
