TAD10023 demodulator From NXP.CU1216 is tuner.
标签： demodulator 10023 tuner 1216
上传时间： 2014-01-18
上传用户：13215175592
receiver matlab demodulator
标签： demodulator receiver matlab
上传时间： 2014-12-22
上传用户：zaizaibang
QAM 4 Modulator and demodulator based on ETSI TETRA Standard
标签： demodulator Modulator Standard TETRA
上传时间： 2017-07-24
上传用户：xfbs821
Designing read/write device (RWD) units for industrial RF-Identification applications is strongly facilitated by the NXP Semiconductors HITAG Reader Chip HTRC110. All needed function blocks, like the antenna driver, modulator demodulator and antenna diagnosis unit, are integrated in the HTRC110. Therefore only a minimum number of additional passive components are required for a complete RWD. This Application Note describes how to design an industrial RF-Identification system with the HTRC110. The major focus is dimensioning of the antenna, all other external components including clock and power supply, as well as the demodulation principle and its implementatio
上传时间： 2013-10-22
上传用户：zhengjian
为了在CDMA系统中更好地应用QDPSK数字调制方式，在分析四相相对移相（QDPSK)信号调制解调原理的基础上，设计了一种QDPSK调制解调电路，它包括串并转换、差分编码、四相载波产生和选相、相干解调、差分译码和并串转换电路。在MAX+PLUSⅡ软件平台上，进行了编译和波形仿真。综合后下载到复杂可编程逻辑器件EPM7128SLC84-15中，测试结果表明，调制电路能正确选相，解调电路输出数据与QDPSK调制输入数据完全一致，达到了预期的设计要求。 Abstract: In order to realize the better application of digital modulation mode QDPSK in the CDMA system， a sort of QDPSK modulation-demodulation circuit was designed based on the analysis of QDPSK signal modulation-demodulation principles. It included serial/parallel conversion circuit, differential encoding circuit, four-phase carrier wave produced and phase chosen circuit, coherent demodulation circuit, difference decoding circuit and parallel/serial conversion circuit. And it was compiled and simulated on the MAX+PLUSⅡ software platform,and downloaded into the CPLD of EPM7128SLC84-15.The test result shows that the modulation circuit can exactly choose the phase，and the output data of the demodulator circuit is the same as the input data of the QDPSK modulate. The circuit achieves the prospective requirement of the design.
上传时间： 2014-01-13
上传用户：qoovoop
为了在CDMA系统中更好地应用QDPSK数字调制方式，在分析四相相对移相（QDPSK)信号调制解调原理的基础上，设计了一种QDPSK调制解调电路，它包括串并转换、差分编码、四相载波产生和选相、相干解调、差分译码和并串转换电路。在MAX+PLUSⅡ软件平台上，进行了编译和波形仿真。综合后下载到复杂可编程逻辑器件EPM7128SLC84-15中，测试结果表明，调制电路能正确选相，解调电路输出数据与QDPSK调制输入数据完全一致，达到了预期的设计要求。 Abstract: In order to realize the better application of digital modulation mode QDPSK in the CDMA system， a sort of QDPSK modulation-demodulation circuit was designed based on the analysis of QDPSK signal modulation-demodulation principles. It included serial/parallel conversion circuit, differential encoding circuit, four-phase carrier wave produced and phase chosen circuit, coherent demodulation circuit, difference decoding circuit and parallel/serial conversion circuit. And it was compiled and simulated on the MAX+PLUSⅡ software platform,and downloaded into the CPLD of EPM7128SLC84-15.The test result shows that the modulation circuit can exactly choose the phase，and the output data of the demodulator circuit is the same as the input data of the QDPSK modulate. The circuit achieves the prospective requirement of the design.
上传时间： 2013-10-28
上传用户：jyycc
This packet is a IS-95 baseband simulation for 1 data channel of 9.6 KBps rate. The simulation is written for static channel and AWGN noise. The packet include: 1) Packet Builder (Viterbi Encoding, Interleaver, PN generation) 2) Modulator (RRC filter) 3) demodulator (Matched Filter, RAKE receiver) 4) Receiver (HD or SD) (Deinterleaver, Viterbi Decoder). You should run "Simulation.m" function that include all modules.
标签： simulation baseband channel packet
上传时间： 2014-11-09
上传用户：hwl453472107
his packet is a IS-95 baseband simulation for 1 data channel of 9.6 KBps rate. The simulation is written for static channel and AWGN noise. The packet include: 1) Packet Builder (Viterbi Encoding, Interleaver, PN generation) 2) Modulator (RRC filter) 3) demodulator (Matched Filter, RAKE receiver) 4) Receiver (HD or SD) (Deinterleaver, Viterbi Decoder). You should run "Simulation.m" function that include all modules.
标签： simulation baseband channel packet
上传时间： 2013-12-23
上传用户：zhangyigenius
This paper investigates the design of joint frequency offset and carrier phase estimation of a multi-frequency time division multiple access (MF-TDMA) demodulator that is applied to a digital video broadcasting—return channel system via satellite (DVB-RCS). The proposed joint estimation algorithm is based on the interpolation technique for two correlation values in the frequency and phase domains. This simple interpolation technique can significantly improve frequency and phase resolution capabilities of the proposed technique without increasing the number of the correlation values. In addition, the overall block diagram of a digital communications receiver for DVB-RCS is presented, which was designed using the proposed estimation algorithms. Index Terms—Carrier phase estimation, DVB-RCS, frequency offset estimation, interpolation, joint estimation, MF-TDMA.
标签： investigates estimation frequency carrier
上传时间： 2015-12-30
上传用户：ls530720646
This packet is a IS-95 baseband simulation for 1 data channel of 9.6 KBps rate. The simulation is written for static channel and AWGN noise. The packet include: 1) Packet Builder (Viterbi Encoding, Interleaver, PN generation) 2) Modulator (RRC filter) 3) demodulator (Matched Filter, RAKE receiver) 4) Receiver (HD or SD) (Deinterleaver, Viterbi Decoder).
标签： simulation baseband channel packet
上传时间： 2014-12-20
上传用户：ukuk
