为了在CDMA系统中更好地应用QDPSK数字调制方式,在分析四相相对移相(QDPSK)信号调制解调原理的基础上,设计了一种QDPSK调制解调电路,它包括串并转换、差分编码、四相载波产生和选相、相干解调、差分译码和并串转换电路。在MAX+PLUSⅡ软件平台上,进行了编译和波形仿真。综合后下载到复杂可编程逻辑器件EPM7128SLC84-15中,测试结果表明,调制电路能正确选相,解调电路输出数据与QDPSK调制输入数据完全一致,达到了预期的设计要求。 Abstract: In order to realize the better application of digital modulation mode QDPSK in the CDMA system, a sort of QDPSK modulation-demodulation circuit was designed based on the analysis of QDPSK signal modulation-demodulation principles. It included serial/parallel conversion circuit, differential encoding circuit, four-phase carrier wave produced and phase chosen circuit, coherent demodulation circuit, difference deCoding circuit and parallel/serial conversion circuit. And it was compiled and simulated on the MAX+PLUSⅡ software platform,and downloaded into the CPLD of EPM7128SLC84-15.The test result shows that the modulation circuit can exactly choose the phase,and the output data of the demodulator circuit is the same as the input data of the QDPSK modulate. The circuit achieves the prospective requirement of the design.
上传时间: 2014-01-13
上传用户:qoovoop
针对UHF读写器设计中,在符合EPC Gen2标准的情况下,对标签返回的高速数据进行正确解码以达到正确读取标签的要求,提出了一种新的在ARM平台下采用边沿捕获统计定时器数判断数据的方法,并对FM0编码进行解码。与传统的使用定时器定时采样高低电平的FM0解码方法相比,该解码方法可以减少定时器定时误差累积的影响;可以将捕获定时器数中断与数据判断解码相对分隔开,使得中断对解码影响很小,实现捕获与解码的同步。通过实验表明,这种方法提高了解码的效率,在160 Kb/s的接收速度下,读取一张标签的时间约为30次/s。 Abstract: Aiming at the requirement of receiving correctly decoded data from the tag under high-speed communication which complied with EPC Gen2 standard in the design of UHF interrogator, the article introduced a new technology for FM0 deCoding which counted the timer counter to judge data by using the edge interval of signal capture based on the ARM7 platform. Compared with the traditional FM0 deCoding method which used the timer timed to sample the high and low level, the method could reduce the accumulation of timing error and could relatively separate capture timer interrupt and the data judgment for deCoding, so that the disruption effect on the deCoding was small and realizd synchronization of capture and deCoding. Testing result shows that the method improves the efficiency of deCoding, at 160 Kb/s receiving speed, the time of the interrogator to read a tag is about 30 times/s.
上传时间: 2013-11-10
上传用户:liufei
为了在CDMA系统中更好地应用QDPSK数字调制方式,在分析四相相对移相(QDPSK)信号调制解调原理的基础上,设计了一种QDPSK调制解调电路,它包括串并转换、差分编码、四相载波产生和选相、相干解调、差分译码和并串转换电路。在MAX+PLUSⅡ软件平台上,进行了编译和波形仿真。综合后下载到复杂可编程逻辑器件EPM7128SLC84-15中,测试结果表明,调制电路能正确选相,解调电路输出数据与QDPSK调制输入数据完全一致,达到了预期的设计要求。 Abstract: In order to realize the better application of digital modulation mode QDPSK in the CDMA system, a sort of QDPSK modulation-demodulation circuit was designed based on the analysis of QDPSK signal modulation-demodulation principles. It included serial/parallel conversion circuit, differential encoding circuit, four-phase carrier wave produced and phase chosen circuit, coherent demodulation circuit, difference deCoding circuit and parallel/serial conversion circuit. And it was compiled and simulated on the MAX+PLUSⅡ software platform,and downloaded into the CPLD of EPM7128SLC84-15.The test result shows that the modulation circuit can exactly choose the phase,and the output data of the demodulator circuit is the same as the input data of the QDPSK modulate. The circuit achieves the prospective requirement of the design.
上传时间: 2013-10-28
上传用户:jyycc
One of the most important issues affecting the implementation of microcontroller software deals with the data-decision algorithm. Data-decision refers to deCoding the DIO-pin from the CC400/CC900. Two main principles exist for deCoding Manchester-coded data: Data decision based on timing the period between transitions, and data decision based on oversampling.
标签: microcontroller implementation important affecting
上传时间: 2013-12-18
上传用户:671145514
I. Introduction This code exploits a previously undisclosed vulnerability in the bit string deCoding code in the Microsoft ASN.1 library. This vulnerability is not related to the bit string vulnerability described in eEye advisory AD20040210-2. Both vulnerabilities were fixed in the MS04-007 patch. II. Screenshots $ ./kill-bill.pl . kill-bill : Microsoft ASN.1 remote exploit for CAN-2003-0818 (MS04-007) by Solar Eclipse <solareclipse@phreedom.org> Usage: kill-bill -p <port> -s <service> host Services: iis IIS HTTP server (port 80) iis-ssl IIS HTTP server with SSL (port 443) exchange Microsoft Exchange SMTP server (port 25) smb-nbt SMB over NetBIOS (port 139) smb SMB (port 445) If a service is running on its default port you don t have to specify both the service and the port. Examples: kill-bill -s iis 192.168.0.1 kill-bill -p 80 192.168.0.1 kill-bill -p 1234 -s smb 192.168.0.1
标签: I. vulnerability Introduction undisclosed
上传时间: 2015-05-15
上传用户:xhz1993
The two C source files in this archive are specific to the TRS-80 Model 4 with high-resolution graphics board. However, the code which performs Huffman enco- ding and deCoding is of general interest.
标签: high-resolution specific archive source
上传时间: 2014-11-04
上传用户:二驱蚊器
The two C source files in this archive are specific to the TRS-80 Model 4 with high-resolution graphics board. However, the code which performs Huffman enco- ding and deCoding is of general interest.
标签: high-resolution specific archive source
上传时间: 2013-12-18
上传用户:417313137
这是一篇关于turbo码的原始论文,Near optimum error correcting cod ing and deCoding turbo codes,可供学习参考之用。
上传时间: 2014-01-24
上传用户:pkkkkp
turbo code的经典论文,共享给大家 Near Shannon limit error-correcting coding and deCoding Turbo-codes
上传时间: 2015-06-20
上传用户:luke5347
The intention is to show you how to incorporate the AWGN/Rayleigh fading models in the basic deCoding program.
标签: incorporate intention the Rayleigh
上传时间: 2014-01-04
上传用户:ANRAN