虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

cost

  • 单片机控制的铅酸蓄电池充电电源

     为了有效地提升铅酸蓄电池的使用寿命,同时实现对充电过程的监控,设计出一种用单片机控制的36 V铅酸蓄电池充电电源。本电路采用反激式拓扑,连续电流工作模式,电源管理IC设计在电源的副边,由ELAN公司的EM78P258N单片机模拟,是用可编程器件模拟电源管理IC,实现智能电源低成本化的一次成功尝试,通过对单片机的软件设计实现了充电电源的状态显示、充电时间控制、报警、过温保护、过压保护、过流保护等功能。本充电器真正的实现了铅酸蓄电池的三段式充电过程,其最高输出功率可达90 W,效率约85%,成本不到20元,具有很高的市场竞争力。 Abstract:  In order to extend the life of lead-acid battery efficiently and supervise the charging process meanwhile, a 36V lead-acid battery charge powe supply controlled by microcontroller is designed. The charger is flyback switching power supply and works in CCM mode. A EM78P258N microcontroller made by ELAN microelectronics corporation is used as power management IC which is designed at the secondary circuit. The project is a successful attempt to low-cost intelligent power used microcontroller simulating power management IC. The charger also has the functions of the status reveal, charge time control, alarming, thermal protect, current limit and overvoltage protect by the software design. The circuit actually implements the three-step charge process, whose power is up to 90W and whose efficiency can get 85%. The net cost of this charger is less than 20 RMB, so that the charger is of powerful market competitiveness.    

    标签: 单片机控制 充电电源 铅酸蓄电池

    上传时间: 2013-11-16

    上传用户:cepsypeng

  • 基于单总线式无线温度采集系统设计

    为提高温度测量效率,降低系统的成本,扩展传输距离,设计出一种新型温度采集系统。单片机通过控制具有单总线方式的温度传感器DS18B20实现对温度的测量,同时单片机通过控制具有单总线方式300~450MHz频率范围内的MAX7044与MAX7033无线发射与接收芯片实现温度数据的无线传输。与传统温度采集系统相比,该系统利用单总线方式连接,采用无线传输方式实现远距离通信,易于系统的集成与扩展。实验结果表明,该系统结构简单、方便移植,能够同时实现多达上百点温度的测量与500m范围的传输。 Abstract:  To improve the temperature measurement efficiency and reduce system cost,expansion of transmission distance,a new type of temperature acquisition system is designed.Microcontroller controlled temperature sensor DS18B20which has a single-bus achieves temperature measurement,while microcontroller by controlled the MAX7044and MAX7033chip with a single-bus and having300~450MHz radiofrequency to achieve the wireless transmission of temperature data.Compared with conventional temperature acquisition system,the system uses single-bus connected,and uses wireless transmission means to achieve long-distance communications,easy-to-system integration and expansion.The experimental results show that the system is simple,convenient transplantation,and can be implemented in as many as a hundred-point temperature measure-ment and the transmission range of500meters.

    标签: 单总线 无线温度 采集 系统设计

    上传时间: 2013-10-29

    上传用户:515414293

  • 基于C8051F320的心电监护系统设计

    介绍一种基于C8051单片机的动态心电监护系统。该系统由两部分组成:以C8051F320单片机为核心的数据采集装置和以PC机为平台的分析处理系统。硬件电路功耗低,由单片机自带的USB接口将数据传送给PC机。软件平台采用LabVIEW可视化虚拟仪器系统开发平台,将传统仪器的功能模块集成到计算机中,用户可通过修改虚拟仪器的程序改变其功能。采用USB接口实时传输心电数据,并将数据采集模块设计为计算机外设,使该系统高速快捷、小巧便携。 Abstract:  In this design,a low-cost ECG electrocardiogram monitoring system is introduced,which consists of two parts:data acquisition device based on C8051F320and PC terminal as the analysis and processing system.The system is low-power consumption,the data is transmitted to the PC terminal by USB interface of the C8051F320.By using the visible virtual instrument system developing platform LabVIEW,the traditional instruments function modules are integrated into the computer,so the user can modify virtual instrument software to change its function to meet their needs.Using USB in-terface to realize real-time ECG data transmission,in addition,ECG data acquisition module is designed as the computer peripheral,which makes the syetem high-speed and portable.

    标签: C8051F320 心电监护 系统设计

    上传时间: 2013-11-13

    上传用户:zhangzhenyu

  • 基于AT89S52的机载电气盒测试仪的设计

    飞机电网故障时,机载电气盒必须在延迟时间内切断电网,保护机载设备。采用AT89S52设计的电气盒测试仪能够测试电气盒保护功能,测量延迟时间。实际应用结果表明,该测试仪具有测量准确、可靠性高、成本低等优点。 Abstract:  The helicopter-electrical-box must shut off the helicopter power,protect the equipments of the helicopter when the helicopter power is failed.The tester for the helicopter-electrical-box based on AT89S52is used for testing the protect-ing function and measuring the delay time.Application results show this tester has some advantages,such as accurate mea-surement,high dependability,economical cost etc.

    标签: 89S S52 AT 89

    上传时间: 2014-12-27

    上传用户:786334970

  • 基于ATmega16的标记机控制系统

    介绍了当前普通标记机控制系统现状及其存在缺点,给出气动标记机及相频修正PWM模式的工作原理。采用ATmega16单片机和USB转换RS232接口器件CH341T实现驱动控制系统与PC的实时通讯,标记控制系统可升级到USB接口。采用基于ATmega16的相频修正PWM替换555振荡电路产生的PWM,可直接通过软件调整PWM信号。使用达林顿三极管TIP122替代直流继电器驱动高频电磁阀,使得电磁阀驱动电路简单,成本低廉。该控制系统已成功应用于气动标记机。 Abstract:  In this paper,the actuality and demerit of the common gas marking machine control systems are described.The operation principle of the gas marking machine and the phase and frequency correct PWM of ATmega16is introduced.The real-time communication between the driving control system and PC by CH341T which its function is translated USB to RS232is realized,the control systems is updated grade to USB interface.The PWM signal can be adjustable by software for the555surge circuit was substituted by the phase and frequency.The high frequency electromagnetic value’s driving circuit by DC relay is replaced by TIP122,therefore,the circuit is become simple and the cost cheap.The control systems has been widely used in gas marking machine.

    标签: ATmega 16 标记 控制系统

    上传时间: 2013-10-18

    上传用户:1427796291

  • 基于ATmega48的3相无刷电机的控制方法

    介绍了采用ATmega48单片机实现三相无刷直流电机控制器的方法。利用Atmega48获得带死区的脉宽调制(PWM)、霍尔传感器的换相处理、正弦驱动信号的产生和电机转速的控制等功能。采用该方法的优点是所需的外围器件少,成本低。 Abstract:  The method of 3-phase brushless DC motor control based on ATmega48 is presented in this paper.The system uses ATmega48 to generate PWM signals with dead-time, hall sensors signals commutation,sine driving signal and rotational speed of motor.Using this method,the needed external devices are few, the cost is low.

    标签: ATmega 48 无刷电机 控制方法

    上传时间: 2013-12-09

    上传用户:330402686

  • 基于AVR单片机Mega16的电子时钟设计

    Mega16是一款采用先进RISC精简指令,内置A/D的8位单片机,可支持低电压联机 Flash和EEPROM 写入功能;同时还支持 Basic和C 等高级语言编程。用它设计电子时钟不仅成本低,硬件简单,而且很容易实现系统移植。介绍了如何利用AVR系列单片机Mega16及1602字符液晶来设计电子时钟的方法,同时给出了相应的电路原理及部分语言程序。 Abstract:  ?Mega16 is a high-performance, low power consumption, the use of advanced RISC concise instructions, built-in A/D 8-bit microcontrollers, the on-line support for low-voltage Flash, EEPROM write function. Except Mega16 also support the Basic, C, and other high-level language programming.The electronic clock which is deisgned by Mega16 is not only low-cost, simple hardware, but easy to achieve system migration.The design method of electrioic clock based on the AVR Mega16 and character LCD1602 is introduced in this paper,and the corresponding circuit electrionic and some language program are given.

    标签: Mega AVR 16 单片机

    上传时间: 2014-12-27

    上传用户:zl5712176

  • 基于C8051F340的数据采集器设计

    针对众多低成本数据采集需求,采用带有片上USB控制器和D/A转换器的混合信号微处理器C8051F340,设计了一款可通过USB接口和LabVIEW图形用户界面实现与PC机联机的数据采集器,同时借助系统的SD卡存储独立实现现场长时间采集数据。该数据采集器成本低,结构简单,体积小,已成功用于工业现场。 Abstract:  Aiming at the need of low cost data acquisition, a data acquisition device is designed based on C8051F340 which is a mixed-signal microcontroller and integrates USB controller and A/D controller on a chip.The data acquisition device which can combine with PC by USB interface and LabVIEW graphical user interface,can realize data acquisition. At the same time,it can be solely run a long time in virtue of SD card in field.The date aequisition device features low cost,simple structure and little sharp, and it has been used in industry field.

    标签: C8051F340 数据 集器设计

    上传时间: 2014-05-31

    上传用户:1109003457

  • 基于89C51的摄像机镜头控制电路设计

    针对视频监控中摄像机镜头光圈大小、图像聚焦、图像变焦三项参数的控制问题,介绍了一种基于89C51单片机的镜头控制电路的设计。 该电路以89C51单片机为核心,结构简单,成本低廉,控制可靠,实现了智能监控终端对摄像参数的完全控制。 Abstract:  The design of camera lens control circuit based on 89C51 is introduced. This circuit can adjust parameters of camera such as aperture, zoom and focusing. The practice of project shows that this circuit has advantages of structure simple, low cost and high reliability.

    标签: 89C51 摄像机 控制 镜头

    上传时间: 2013-10-29

    上传用户:Wwill

  • 基于ADuC841的膜片钳放大器系统设计

    为降低成本和解决现有膜片钳放大器系统中PC机的干扰问题,研究了一种基于单片机的膜片钳放大器小系统。该系统采用ADI公司生产的ADuC841作为控制核心,并且配置相应的液晶显示模块LCM3202401。模拟电路部分采用高输入阻抗的AD8627实现微电流信号的采集,并由后级电路进行信号的放大和电阻电容的补偿。它具有硬件电路简单、体积小、使用方便的特点。既可以单独作为小系统实现采集和显示,也可以通过红外方式和PC机进行通讯,在PC机上进行信号的处理。 Abstract:  In order to reduce cost and resolve the interferential problem with PC in existing patch clamp amplifiers, a small patch clamp amplifier system design based on microcontroller is studied. It adopts a new high performance microconverter ADuC841 by the ADI as the control core in the system, configuring a liquid crystal module LCM3202401. In the analog circuit, AD8627 with high input impedance is used to detect the low current,signal magnification, as well as resistance and capacitance compensation are accomplished by subsequent circuits. It has the advantage of simple hardware circuit design, small volume and convenient operation. It can either be used as an independent system to measure and show signal detected or transmit to PC by infrared ray.

    标签: ADuC 841 膜片钳 放大器

    上传时间: 2013-11-06

    上传用户:yy_cn