16 relay output channels and 16 isolated digital input channels LED indicators to show activated relays Jumper selectable Form A/Form B-type relay output channel Output status read-back Keep relay output values when hot system reset High-voltage isolation on input channels(2,500 VDC) Hi ESD protection(2,00VDC) High over-voltage protection(70VDC) Wide input range(10~50VDC) Interrupt handling capability High-density DB-62 connector Board ID
标签: channels indicators activated isolated
上传时间: 2016-02-15
上传用户:dongbaobao
touch panel enable activated for 8202r
标签: activated enable touch panel
上传时间: 2013-12-15
上传用户:1583060504
The outputs of the PCA9518 are immediately available as soon as there is a voltage present on thesupply >~1V and behave as described above. The power-on reset of the PCA9518A keeps the outputsturned off during power-up and maintains the high impedance of the outputs throughout the power-upcycle. There is an additional built-in delay after power-up that allows the analog circuits to stabilize beforethe part is activated.
标签: Replacement 9518 NXP PCA
上传时间: 2013-10-26
上传用户:13817753084
The objective is to set up SPI communication between VTI Technologies digital pressure sensor component and an MCU of an application device ATMEGA16L. In this code example: ?The MCU is configured ?SCP1000-D01 is initialized and configured ?The high resolution measurement mode is activated ?Temperature and pressure information is read always when the DRDY pin is in high state Please refer to the document "SCP1000 Product Family Specification 8260800" for further information on SCP1000 register addressing and SPI communication. This document applies to the SCP1000-D01.
标签: communication Technologies objective pressure
上传时间: 2017-06-17
上传用户:youmo81